Search results for "CERAMICS"
showing 10 items of 1599 documents
Effect of sisal and hydrothermal ageing on the dielectric behaviour of polylactide/sisal biocomposites
2017
[EN] The dielectric properties of virgin polylactide (PLA) and its reinforced composites with different weight amounts of sisal fibres were assessed at broad temperature (from - 130 degrees C to 130 degrees C) and frequency ranges (from 10(-2)-10(7) Hz), before and after being subjected to accelerated hydrothermal ageing. The synergetic effects of both the loading of sisal and hydrothermal ageing were analysed by means of dielectric relaxation spectra. The relaxation time functions were evaluated by the Havriliak-Negami model, substracting the ohmic contribution of conductivity. The intramolecular and intermolecular relaxations were respectively analysed by means of Arrhenius and Vogel-Fulc…
Energetics of conformational conversion between 1,1,2-trichloroethane polymorphs
2008
Pressure-induced transformations between gauche-, gauche+ and transoid conformations have been evidenced by X-ray single-crystal diffraction for 1,1,2-trichloroethane, and the energies of intermolecular interactions, conformational conversion, and the latent heat have been determined.
In situ high-pressure synchrotron X-ray diffraction study of the structural stability in NdVO4 and LaVO4
2014
Abstract Room-temperature angle-dispersive X-ray diffraction measurements on zircon-type NdVO 4 and monazite-type LaVO 4 were performed in a diamond-anvil cell up to 12 GPa. In NdVO 4 , we found evidence for a non-reversible pressure-induced structural phase transition from zircon to a monazite-type structure at 6.5 GPa. Monazite-type LaVO 4 also exhibits a phase transition but at 8.6 GPa. In this case the transition is reversible and isomorphic. In both compounds the pressure induced transitions involve a large volume collapse. Finally, the equations of state and axial compressibilities for the low-pressure phases are also determined.
High-pressure powder x-ray diffraction study of EuVO4
2015
The high-pressure structural behavior of europium orthovanadate has been studied using in-situ, synchrotron based, high-pressure x-ray powder diffraction technique. Angle-dispersive x-ray diffraction measurements were carried out at room temperature up to 34.7 GPa using a diamond-anvil cell, extending the pressure range reported in previous experiments. We confirmed the occurrence of zircon-scheelite phase transition at 6.8 GPa and the coexistence of low- and high-pressure phases up to 10.1 GPa. In addition, clear evidence of a scheelite-fregusonite transition is found at 23.4 GPa. The fergusonite structure remains stable up to 34.7 GPa, the highest pressure reached in the present measureme…
In situ and time resolved study of the - transition in nanometric particles
2007
In situ and real-time study of the {gamma} to {alpha}-Fe{sub 2}O{sub 3} transition is carried out on the H10 beamline at LURE (France). {gamma}-Fe{sub 2}O{sub 3} particles are synthesized by soft chemistry. These particles have an average diameter evaluated by X-ray diffraction of 9{+-}1nm and a specific surface area of 116m{sup 2}g{sup -1}. The size of produced {alpha}-Fe{sub 2}O{sub 3} particles is determined by in situ and time resolved X-ray diffraction measurements at different temperatures. An amazing evolution of size with time is revealed: an abrupt doubling of the {alpha}-Fe{sub 2}O{sub 3} particle size is observed whatever the heating temperature. Some assumptions are given in ord…
Thermal evolution and structural study of 2:1 mullite from monophasic gels
2006
Abstract Single phase mullite gels with composition 2Al 2 O 3 ·SiO 2 (2:1) were prepared by the slow hydrolysis method using aluminium nitrate nonahydrate and tetraethylorthosilicate as reagents. The evolution to mullite from gels was studied by infrared (IR) spectroscopy and X-ray diffraction (XRD). Gels thermally treated under fast schedules showed mullite formation below 900 °C. Compositional and microstructural changes in 2:1 mullites through the range of temperature from 900 to 1600 °C were determined by the measurement of lattice parameters and field emission scanning electron microscopy. The alumina-rich mullites formed at low temperatures become almost the nominal 2:1 at 1600 °C. Th…
X-ray diffraction microstructure analysis of mullite, quartz and corundum in porcelain insulators
2005
Abstract The X-ray diffraction microstructure analysis has been performed on commercial samples of the silica and alumina porcelain insulators obtained at 1300 °C, with the same time of firing. The study was carried out on mullite, corundum and quartz by applying several integral breadth methods (i.e. the Williamson–Hall analysis, the Langford method and the Halder–Wagner approximation) and the Fourier analysis (Warren–Averbach method). The apparent crystallite sizes determined for the mullite are direction-dependent (anisotropic) and within each group of samples, on average, the greatest values are obtained along the direction [0 0 1]. With regard to the microstructure of the corundum and …
Which tool to distinguish transient alumina from alpha alumina in thermally grown alumina scales?
2005
International audience; Alumina scales constitute excellent protective barriers when they form on alumina-forming steels. If they keep tightly adherent to the underlying substrate, they isolate it from the surrounding aggressive atmosphere at high temperature. The protectiveness of the alumina scale is highly dependant upon its growth mechanism. The nucleation and transformation of transient alumina (mainly g-Al2O3 and y-Al2O3) is known to play an important role on alumina scale formation. It is therefore fundamental to characterise these transient alumina especially during the early stages of the oxidation process. The morphology of the transient alumina was observed by scanning electron m…
Time-resolved XRD experiments for a fine description of mechanisms induced during reactive sintering
2005
The control of Mechanically Activated Field Activated Pressure Assisted Synthesis hereafter called the MAFAPAS process is the main objective to be achieved for producing nanostructure materials with a controlled consolidation level. Consequently, it was essential to develop characterization tools "in situ" such as the Time Resolved X-ray Diffraction (TRXRD), with an X-ray synchrotron beam (H10, LURE Orsay) coupled to an infrared thermography to study simultaneously structural transformations and thermal evolutions. From the 2003 experiments, we took the opportunity to modify the sample-holder in order to reproduce the better synthesis conditions of the MAFAPAS process, but without the conso…
Short and long range order of Half-Heusler phases in (Ti,Zr,Hf)CoSb thermoelectric compounds
2016
Abstract The structural properties of (Ti,Zr,Hf)CoSb thermoelectric Half-Heusler compounds were investigated by synchrotron radiation based techniques. The short-range order, in particular the environment of the Co atoms, was studied by extended X-Ray absorption fine structure spectroscopy and the long range order by powder X-Ray diffraction. Structural models were obtained for the single phase materials TiCoSb0.85Sn0.15, ZrCoSb0.85Sn0.15, and HfCoSb0.85Sn0.15. These models were transferred for the phase-separated material Ti0.5Hf0.5CoSb0.85Sn0.15. As a result, proving that each Half-Heusler phase was well ordered, apart from the intermixing of Ti and Hf on its designated crystallographic l…