Search results for "CIRCUIT"
showing 10 items of 936 documents
Detection and Discrimination of Inter-Turn Short Circuit and Demagnetization Faults in PMSMs Based on Structural Analysis
2021
This paper presents a fault diagnosis method based on structural analysis of permanent magnet synchronous motors (PMSMs), focusing on detecting and discriminating two of the most common faults in PMSMs, namely demagnetization and inter-turn short circuit faults. The structural analysis technique uses the dynamic mathematical model of the PMSM in matrix form to evaluate the system’s structural model. After obtaining the analytical redundancy using the over-determined part of the system, it is divided into redundant testable sub-models. Four structured residuals are designed to detect and isolate the investigated faults, which are applied to the system in different time intervals. Finally, th…
Nonlinear Analysis of Phase-locked Loop-Based Circuits
2013
Main problems of simulation and mathematical modeling of high-frequency signals for analog Costas loop and for analog phase-locked loop (PLL) are considered. Two approachers which allow to solve these problems are considered. In the first approach, nonlinear models of classical PLL and classical Costas loop are considered. In the second approach, engineering solutions for this problems are described. Nonlinear differential equations are derived for both approaches.
The effect of thickness on the composition of passive films on a Ti–50Zr at% alloy
2006
Abstract Anodic films were grown potentiodynamically in different electrolytes (pH = 1–14) on a Ti–50Zr at% cast alloy, obtained by fusion in a voltaic arc under argon atmosphere. The thickness of the films was varied by changing formation potential from the open circuit potential up to about 9 V; growth was followed by 30 min stabilization at the forming potential. Films having different thicknesses were characterized by photocurrent spectroscopy (PCS) and electrochemical impedance spectroscopy (EIS). Moreover, film composition was analyzed by X-ray photoelectron spectroscopy (XPS). Regardless of the anodizing conditions, passive films on the Ti–50Zr at% alloy consist of a single layer mix…
A laser-based system for a fast and accurate measurement of gain and linearity of photomultipliers
2018
This paper describes a method for the measurement of gain and linearity of photomultipliers (PMTs). Gain and linearity are two fundamental parameters to use properly a PMT in several physics experiments. In the developed system light is laser generated and adressed to the PMT through a set of optical fibers. The data acquisition system consists in a commercial 16 channel digitizer coupled to a custom front-end board. With the chosen digitizer the system is scalable to test up to 16 PMTs, with the aid of a light distribution system and a multi-channel version of the front-end board. Data analysis is performed by a custom acquisition software. A 1.5» Hamamatsu PMT is used to validate the syst…
Roadmap on STIRAP applications
2019
STIRAP (stimulated Raman adiabatic passage) is a powerful laser-based method, usually involving two photons, for efficient and selective transfer of populations between quantum states. A particularly interesting feature is the fact that the coupling between the initial and the final quantum states is via an intermediate state, even though the lifetime of the latter can be much shorter than the interaction time with the laser radiation. Nevertheless, spontaneous emission from the intermediate state is prevented by quantum interference. Maintaining the coherence between the initial and final state throughout the transfer process is crucial. STIRAP was initially developed with applications in …
Accelerated stabilization of coherent photon states
2018
| openaire: EC/H2020/681311/EU//QUESS Control and utilization of coherent states of microwave photons is a ubiquitous requirement for the present and near-future implementations of solid-state quantum computers. The rate at which the photon state responds to external driving is limited by the relaxation rate of the storage resonator, which poses a trade-off between fast control and long storage time. Here, we present a control scheme that is designed to drive an unknown photon state to a desired coherent state much faster than the resonator decay rate. Our method utilizes a tunable environment which acts on an ancillary qubit coupled to the resonator. By periodically resetting the qubit and…
Theory of quantum-circuit refrigeration by photon-assisted electron tunneling
2017
We focus on a recently experimentally realized scenario of normal-metal-insulator-superconductor tunnel junctions coupled to a superconducting resonator. We develop a first-principles theory to describe the effect of photon-assisted electron tunneling on the quantum state of the resonator. Our results are in very good quantitative agreement with the previous experiments on refrigeration and heating of the resonator using the photon-assisted tunneling, thus providing a stringent verification of the developed theory. Importantly, our results provide simple analytical estimates of the voltage-tunable coupling strength and temperature of the thermal reservoir formed by the photon-assisted tunne…
Quantification of spatial inhomogeneity in perovskite solar cells by hyperspectral luminescence imaging
2016
Vacuum evaporated perovskite solar cells with a power conversion efficiency of 15% have been characterized using hyperspectral luminescence imaging. Hyperspectral luminescence imaging is a novel technique that offers spectrally resolved photoluminescence and electroluminescence maps (spatial resolution is 2 micrometer) on an absolute scale. This allows, using the generalized Planck’s law, the construction of absolute maps of the depth-averaged quasi-Fermi level splitting (Δμ), which determines the maximum achievable open circuit voltage (Voc) of the solar cells. In a similar way, using the generalized reciprocity relations the charge transfer efficiency of the cells can be obtained from the…
Manufacturing and testing a thin glass mirror shell with piezoelectric active control
2015
Optics for future X-ray telescopes will be characterized by very large aperture and focal length, and will be made of lightweight materials like glass or silicon in order to keep the total mass within acceptable limits. Optical modules based on thin slumped glass foils are being developed at various institutes, aiming at improving the angular resolution to a few arcsec HEW. Thin mirrors are prone to deform, so they require a careful integration to avoid deformations and even correct forming errors. On the other hand, this offers the opportunity to actively correct the residual deformation: a viable possibility to improve the mirror figure is the application of piezoelectric actuators onto t…
MALTA: a CMOS pixel sensor with asynchronous readout for the ATLAS High-Luminosity upgrade
2018
Radiation hard silicon sensors are required for the upgrade of the ATLAS tracking detector for the High- Luminosity Large Hadron Collider (HL-LHC) at CERN. A process modification in a standard 0.18 μm CMOS imaging technology combines small, low-capacitance electrodes (∼2 fF for the sensor) with a fully depleted active sensor volume. This results in a radiation hardness promising to meet the requirements of the ATLAS ITk outer pixel layers (1.5 × 1015 neq /cm2 ), and allows to achieve a high signal-to-noise ratio and fast signal response, as required by the HL-LHC 25 ns bunch crossing structure. The radiation hardness of the charge collection to Non-Ionizing Energy Loss (NIEL) has been previ…