Search results for "COMPOSITE"
showing 10 items of 4584 documents
Bioresorbable β-TCP-FeAg nanocomposites for load bearing bone implants: High pressure processing, properties and cell compatibility.
2017
In this paper, the processing and properties of iron-toughened bioresorbable β-tricalcium phosphate (β-TCP) nanocomposites are reported. β-TCP is chemically similar to bone mineral and thus a good candidate material for bioresorbable bone healing devices; however intrinsic brittleness and low bending strength make it unsuitable for use in load-bearing sites. Near fully dense β-TCP-matrix nanocomposites containing 30vol% Fe, with and without addition of silver, were produced employing high energy attrition milling of powders followed by high pressure consolidation/cold sintering at 2.5GPa. In order to increase pure iron's corrosion rate, 10 to 30vol% silver were added to the metal phase. The…
Induction of carbonic anhydrase in SaOS-2 cells, exposed to bicarbonate and consequences for calcium phosphate crystal formation.
2013
Ca-phosphate/hydroxyapatite crystals constitute the mineralic matrix of vertebrate bones, while Ca-carbonate dominates the inorganic matrix of otoliths. In addition, Ca-carbonate has been identified in lower percentage in apatite crystals. By using the human osteogenic SaOS-2 cells it could be shown that after exposure of the cells to Ca-bicarbonate in vitro, at concentrations between 1 and 10 mm, a significant increase of Ca-deposit formation results. The crystallite nodules formed on the surfaces of SaOS-2 cells become denser and larger in the presence of bicarbonate if simultaneously added together with the mineralization activation cocktail (β-glycerophosphate/ascorbic acid/dexamethason…
Changes in surface stress at the liquid/solid interface measured with a microcantilever
2000
Abstract The bending of microfabricated silicon nitride cantilevers was used to determine surface stress changes at solid–liquid interfaces. The radius of curvature of the bent cantilever is directly proportional to changes in the differential surface stress between its opposite sides. To demonstrate the possibilities and limitations of the technique, cantilevers coated on both sides with gold and densely packed monolayers of different thiols were put in a constant flow of aqueous electrolyte solution and the deflection was measured using a optical lever technique. Changes in the surface stress for the different thiol monolayers due to specific proton adsorption are presented. Possible appl…
Measurement of Mechanical Properties of Cantilever Shaped Materials
2008
Microcantilevers were first introduced as imaging probes in Atomic Force Microscopy (AFM) due to their extremely high sensitivity in measuring surface forces. The versatility of these probes, however, allows the sensing and measurement of a host of mechanical properties of various materials. Sensor parameters such as resonance frequency, quality factor, amplitude of vibration and bending due to a differential stress can all be simultaneously determined for a cantilever. When measuring the mechanical properties of materials, identifying and discerning the most influential parameters responsible for the observed changes in the cantilever response are important. We will, therefore, discuss the…
Dynamic thermal expansivity near the glass transition
2000
Dielectric techniques were used to investigate the thermal expansivity of polystyrene films. Capacitive scanning dilatometry (CSD) employs temperature ramping in order to monitor the non-linear structural relaxation in the glass transformation range and to quantify liquid fragility. In the linear response regime, the complex thermal expansivity is obtained as a function of the temperature cycling frequency and is observed to reflect the structural relaxation.
Effect of low amount of nanosilica on dielectric properties of polypropylene
2010
This paper presents the results of the dielectric properties measurements conducted on Silica-Polypropylene (PP) nanocomposites. According to prior investigations by the authors silica nanoparticles have improved the performance of the dielectric material considering capacitor applications. Especially breakdown strengths with ac and dc voltages and resistance against surface degradation have increased. The relative permittivity and dielectric losses have also been comparable to reference PP. In this paper the results of the dielectric measurements conducted on composites with 1-2 wt-% silica are compared with reference PP. Silica dispersion in PP was confirmed with transmission electron mic…
Correlating surface forces with surface reactivity of gypsum crystals by atomic force microscopy. Comparison with rheological properties of plaster
2001
Abstract Atomic Force Microscopy (AFM) was used to image the surface reactivity as well as to characterize quantitatively the surface forces between two gypsum (CaSO 4 , 2H 2 O) crystals. Measurements on different crystal faces, which vary in morphology, structure, hydrophilicity, surface charge, were performed in both air and ionic solutions. In ionic solutions, varying the experimental parameters, the ionic nature and the concentration as well as the duration of the contact leads to the conclusion that the adhesion occurs whatever the orientation of faces. Nevertheless, the magnitude of the adhesion of a physical nature (Van der Waals and ionic correlation) depends on the surface charge d…
Manganese carbonyl terpyridyl complexes: their synthesis, characterization and potential application as CO-release molecules
2014
MnI carbonyl terpyridyl complexes have been synthesized and characterized. The tricarbonyl derivative exhibits interesting behaviors for controlled CO-release by both thermal and photosynthetic pathways.