Search results for "COMPRESSION"
showing 10 items of 774 documents
INDAGINE SPERIMENTALE SU ELEMENTI IN VETRO STRUTTURALE COMPRESSI
2011
Several experimental investigations in the past few years have highlighted the fact that the compressive strength of glass was significantly higher than its tensile strength, allowing new applications of glass in compression members. However, due to the high slenderness of structural glass elements made of thin glass panels, they tend to fail in a brittle manner. A substantial amount of fundamental research has been carried out in the past few years to investigate the stability behaviour of structural glass elements. However, although buckling of glass panels has been quite well studied, a very poor amount of research has been addressed to glass columns, which by contrast represent the most…
Effects of different lower-limb sensory stimulation strategies on postural regulation-a Systematic review and metaanalysis
2017
Systematic reviews of balance control have tended to only focus on the effects of single lower-limb stimulation strategies, and a current limitation is the lack of comparison between different relevant stimulation strategies. The aim of this systematic review and meta-analysis was to examine evidence of effects of different lower-limb sensory stimulation strategies on postural regulation and stability. Moderate- to high-pooled effect sizes (Unbiased (Hedges' g) standardized mean differences (SMD) = 0.31-0.66) were observed with the addition of noise in a Stochastic Resonance Stimulation Strategy (SRSS), in three populations (i.e., healthy young adults, older adults, and individuals with low…
Shear Strength of a Compacted Scaly Clay from Suction-Controlled Triaxial Tests
2012
The paper presents the results of an experimental research aimed at investigating the shear strength characteristics of an unsaturated compacted scaly clay. Shear strength was investigated by suction-controlled triaxial compression tests on dynamically compacted samples. Collected results point out that suction effects on stiffness and shear strength can be very different for suction values applied lower or greater than air entry value (AEV), corresponding to the material void ratio.
Generation of CO2-rich melts during basalt magma ascent and degassing
2013
International audience; To test mechanisms of basaltic ma gma degassing, continuous decompressions of volatile-bearing (2.7-3.8 wt% H2O, 600-1300 ppm CO2) Stromboli melts were performed from 250-200 to 50-25 MPa at 1180-1140°C. Ascent rates were varied from 0.25 to ~ 1.5 m/s. Glasses after decompression show a wide range of textures, from totally bubble-free to bubble-rich, the latter with bubble number densities from 104 to 106/cm3, similar to Stromboli pumices. Vesicularities range from 0 to ~ 20 vol%. Final melt H2O concentrations are homogeneous and always close to solubilities. In contrast, the rate of vesiculation controls the final melt CO2 concentration. High vesicularity charges ha…
Calibration of a knock prediction model for the combustion of a gasoline-natural gas mixture
2009
Gaseous fuels, such as Liquefied Petroleum Gas (LPG) and Natural Gas (NG), thank to their good mixing capabilities, allow complete and cleaner combustion than normal gasoline, resulting in lower pollutant emissions and particulate matter. Moreover natural gas, which is mainly constituted by methane, whose molecule has the highest hydrogen/carbon ratio, leads also to lower ozone depleting emissions. The authors in a previous work (1) experienced the simultaneous combustion of gasoline and natural gas in a bi-fuel S.I. engine, exploiting so the high knock resistance of methane to run the engine with an ‘overall stoichiometric’ mixture (thus lowering fuel consumption and emissions) and better …
Integrated plasmonic waveguides: A mode solver based on density of states formulation
2009
International audience; We express the density of states (DOS) near guided resonances of plasmonic waveguides by using multiple-scattering theory. In direct analogy with the case of localized electronic defect states in condensed matter, we demonstrate that optical DOS variations follow a lorentzian profile near guided modes resonances. The lorentzian shape gives quantitative information on the guided modes (effective index, propagation length, and polarization state). We numerically investigate both leaky and bound (lossy) modes supported by dielectric-loaded surface-plasmon-polariton waveguides.
Understanding the Impact of Trampling on Rodent Bones
2022
Experiments based on the premise of uniformitarism are an effective tool to establish patterns of taphonomic processes acting either before, or after, burial. One process that has been extensively investigated experimentally is the impact of trampling to large mammal bones. Since trampling marks caused by sedimentary friction strongly mimic cut marks made by humans using stone tools during butchery, distinguishing the origin of such modifications is especially relevant to the study of human evolution. In contrast, damage resulting from trampling on small mammal fossil bones has received less attention, despite the fact that it may solve interesting problems relating to site formation proces…
PrVO$_4$ under High Pressure: Effects on Structural, Optical and Electrical Properties
2020
In pursue of a systematic characterization of rare-earth vanadates under compression, in this work we present a multifaceted study of the phase behavior of zircon-type orthovanadate PrVO$_4$ under high pressure conditions, up until 24 GPa. We have found that PrVO$_4$ undergoes a zircon to monazite transition at around 6 GPa, confirming previous results found by Raman experiments. A second transition takes place above 14 GPa, to a BaWO$_4$-I--type structure. The zircon to monazite structural sequence is an irreversible first-order transition, accompanied by a volume collapse of about 9.6%. Monazite phase is thus a metastable polymorph of PrVO$_4$. The monazite-BaWO$_4$-II transition is found…
Peak dispersion in gradient elution: An insight based on the plate model.
2020
Gradient elution in liquid chromatography reduces the analysis time, improves the efficiency and increases the peak capacity. The study of this chromatographic mode has been based mainly on kinetic dispersion models. The plate model has been applied to a lesser extent, despite being the basis for the concepts of plate height and chromatographic efficiency. In this work, a general equation describing peak dispersion in HPLC gradient elution is derived from the plate model. This equation is studied and validated for three types of gradients: (i) a reference gradient without ramp in which the retention factor varies with time identically throughout the column, (ii) a gradient of stationary pha…
Effect of plastic deformation on photoluminescence of ZnTe bulk monocrystals
1999
Abstract In this work ZnTe bulk single crystals have been deformed by axial compression with the aim of analyzing the luminescence properties related to intrinsic structural defects like dislocations. Plastic deformation greatly decreases the overall PL response, near-band-edge luminescence as well as deep level-related emissions. Results indicate a close relationship between the so-called Y1 and Y2 bands and the density of generated dislocations. Plastic deformation also produces an emission band at 603 nm whose intensity is proportional to the amount of introduced deformation.