Search results for "Chemical engineering"
showing 10 items of 5892 documents
Nucleation particles in diesel exhaust: composition inferred from in situ mass spectrometric analysis.
2005
Mass spectrometric measurements of size and composition of diesel exhaust particles have been performed under various conditions: chassis dynamometer tests, field measurements near a German motorway, and individual car chasing. Nucleation particles consisting of volatile sulfate and organic material could be detected both at the chassis dynamometer test facility and during individual car chasing. We found evidence that if nucleation occurs, sulfuric acid/water is the nucleating agent. Low-volatile organics species condense only on the preexisting sulfuric acid/water clusters. Nucleation was found to depend strongly on various parameters such as exhaust dilution conditions, fuel sulfur conte…
Effect of TiO2 and Al2O3 Addition on the Performance of Chitosan/Phosphotungstic Composite Membranes for Direct Methanol Fuel Cells
2023
Composite chitosan/phosphotungstic acid (CS/PTA) with the addition of TiO2 and Al2O3 particles were synthesized to be used as proton exchange membranes in direct methanol fuel cells (DMFCs). The influence of fillers was assessed through X-ray diffraction, scanning electron microscopy, thermogravimetric analysis, liquid uptake, ion exchange capacity and methanol permeability measurements. The addition of TiO2 particles into proton exchange membranes led to an increase in crystallinity and a decrease in liquid uptake and methanol permeability with respect to pristine CS/PTA membranes, whilst the effect of the introduction of Al2O3 particles on the characteristics of membranes is almost the op…
Tuning The Selectivity To Aldehyde Via Ph Regulation In The Photocatalytic Oxidation Of 4-Methoxybenzyl Alcohol And Vanillyl Alcohol By Tio2 Catalysts
2021
Abstract The influence of pH on the photocatalytic partial oxidation of 4-methoxybenzyl alcohol (MBA) and vanillyl alcohol (VA) to their corresponding aldehydes in aqueous suspension under UVA irradiation was investigated by using poorly crystalline home-prepared and crystalline commercial TiO2 (BDH, Merck and Degussa P25) photocatalysts. The results clearly show as tuning pH can strongly impart selectivity and activity to photocatalytic processes which are often quite unselective in aqueous suspensions. It was found that pH effect on reaction rate and product selectivity strongly depended on TiO2 crystallinity and substrate type. In the case of MBA oxidation, photoreactivity and selectivit…
ChemInform Abstract: Mercaptophenol-Protected Gold Colloides as Nuclei for the Crystallization of Inorganic Minerals: Templated Crystallization on Cu…
2010
An improved cathode for alkaline fuel cells
2010
Abstract The use of nickel foam as an electrode substrate in alkaline fuel cells (AFCs) has been investigated for bipolar cells incorporating an electrically conducting gas diffusion layer (GDL). Improved performance, compared to a previous design, was obtained by adding an extra active layer (AL) composed of manganese (IV) oxide (MnO2) deposited onto carbon black. This new cathode design performed significantly better (130 mA cm−2 at 0.8 V and 25 °C) than the previous design (35 mA cm−2 under the same condition), especially at higher potential. It has been shown that the GDL is a key component of the gas diffusion electrode for both performance and durability, especially with liquid electr…
Isobaric Vapor−Liquid Equilibrium in the Systems 2,3-Dimethylpentane + Methyl 1,1-Dimethylethyl Ether, + Diisopropyl Ether and + Methyl 1,1-Dimethylp…
1999
New, consistent vapor−liquid equilibrium data for the binary systems 2,3-dimethylpentane + methyl 1,1-dimethylethyl ether, + diisopropyl ether, and + methyl 1,1-dimethylpropyl ether are reported at 101.3 kPa. The measured systems deviate slightly from ideal behavior, and only the system methyl 1,1-dimethylpropyl ether + 2,3-dimethylpentane presents an azeotrope. The activity coefficients for the solutions were correlated with their compositions by the Wilson, UNIQUAC, and NRTL models. Wisniak−Tamir equations were used to correlate the boiling points of the solutions with their compositions.
Liquid gas techniques for GC trace analysis
1990
Liquid gases (LG), i.e. low boiling compounds with vapor pressures below 5 bar at room temperature, are introduced as solvents for trace analyses. A system for preparin, diluting and handling LG solutions safely and conveniently in 5 to 500 μl amounts was developed as well as a syringe for direct injection of μl-LG samples into capillary GC. Even technical grade LG are of high purity. GC/FID of LG solutions (starting at −60°C) allows the separation of volatile traces from the solvent peak: e.g., dichloromethane can be measured in the picogram range.
Lipid hydrophobicity, physical state and distribution effects on the properties of emulsion-based edible films
2000
Abstract Addition of lipids to polysaccharide-based films is necessary to improve water vapor barrier properties but it leads to a decrease of mechanical properties. Model emulsified edible films mainly composed of methylcellulose (film-forming substance) and lipid mixtures (moisture barrier) were prepared. The effect of the physicochemical characteristics of the lipid phase (hydrophobicity and physical state) and of its distribution within the methylcellulose-matrix on the mechanical and water vapor barrier film properties was investigated. The nature of the lipid phase had little influence on mechanical properties of emulsified films, but had a substantial effect on the water vapor barrie…
Lipid hydrophobicity and physical state effects on the properties of bilayer edible films
2000
Abstract Edible bilayer films based on methylcellulose, used as the film-forming substance, and lipid mixtures, as barriers against moisture transfers, were prepared. The thickness of the lipid layer had little influence on film mechanical properties, regardless of the nature and the solid content of the fat layer. Mechanical resistance was mainly attributed to the methylcellulose matrix. The water vapor transfer rate (WVTR) decreased substantially when film thickness increased up to 100 μm. Upwards, transfer seemed to be independent of thickness. The WVTR was 1.5 up to 2.5 higher for triglyceride lipid layers than alkane lipid layers. Also, WVTR increased by a factor of 25–75 when the liqu…
Catalytic cracking of alkanes on MCM-22 zeolite. Comparison with ZSM-5 and beta zeolite and its possibility as an FCC cracking additive
1995
Abstract N-heptane cracking has been carried out on MCM-22, and its kinetic and decay behaviour is compared with that of ZSM-5 and Beta zeolites. In the case of MCM-22 cracking occurs in the 10-member ring channel system, as well as in the large cavities formed by 12-member rings. Product selectivities show that MCM-22, while presenting features which indicate structural similarities with ZSM-5, it also presents characteristics corresponding to pores or cavities larger than ZSM-5. The selectivities to the individual products together with C1 + C2/iC4, C3/C4, C5/C2, iC4/total C4, and alkane/alkene ratios indicate that MCM-22 has good properties to be used as an FCC octane booster additive sp…