Search results for "Chemical engineering"
showing 10 items of 5892 documents
Highly Reduced Saturation Magnetization in Epitaxially Grown Ferrimagnetic Heusler Thin Films
2019
The key of spintronic devices using the spin-transfer torque phenomenon is the effective reduction of switching current density by lowering the damping constant and the saturation magnetization while retaining strong perpendicular magnetic anisotropy. To reduce the saturation magnetization, particular conditions such as specific substitutions or buffer layers are required. Herein, we demonstrate highly reduced saturation magnetization in tetragonal D022 Mn3–xGa thin films prepared by rf magnetron sputtering, where the epitaxial growth is examined on various substrates without any buffer layer. As the lattice mismatch between the sample and the substrate decreases from LaAlO3 and (LaAlO3)0.3…
Calculations on solvents and co-solvents of single-wall carbon nanotubes:cyclopyranoses
2005
The (10, 10) single-wall carbon nanotube (SWNT) presents consistency between relatively small solubility, and large partition coefficients and kinetic stability. The solubility of SWNTs is investigated in a variety of solvents, finding a class of non-hydrogen-bonding Lewis bases that provides good solubility. The organic solvent–water partition and hydrophobic moment of lysozyme show that the main contribution to the water-accessible surface area of helices is the hydrophobic term, while the hydrophilic part dominates in the sheet, which is related to the 1-octanol–, cyclohexane– and chloroform–water partition coefficients Po−ch−cf of helices, which are greater than those of the sheet. The …
Kinetics of nitrogen removal in a MBR nutrient removal activated sludge system
2006
The application of membrane bioreactor (MBR) technology to biological nutrient removal (BNR) activated sludge (AS) systems is limited and uncertainty exists as to the impact of the conditions induced by the membranes on the biologically mediated processes of nutrient removal. Two main conditions associated with MBRs are (1) high total suspended solids (TSS) concentrations (8–20 g/L) and (2) different selection pressures due to biomass retention not being based on settleability, compared with conventional systems with secondary settling tanks (SSTs). Recently, Ramphao et al. [1] concluded that incorporating membranes in BNR AS makes a profound difference to the design of the system. Previous…
The expanding role of LC-MS in analyzing metabolites and degradation products of food contaminants
2008
Abstract Liquid chromatography-mass spectrometry (LC-MS) has contributed significantly in advancing research in the analysis of metabolites and degradation products of food contaminants. Of particular interest is the comprehensive application of LC-MS to discovery of degradation products and metabolites. This review, covering research published between 2003 and 2008, describes how LC-MS has been used in this field, with the majority of work dealing with target-metabolite analysis and only a small fraction using LC-MS comprehensively. In considering the significance of this topic and the potential interest in it, we briefly describe state-of-the art mass analyzers applied for it (QtrAP, QqTO…
Selective CO2 adsorption by a triazacyclononane-bridged microporous metal-organic framework.
2011
Metal-organic frameworks constructed by self-assembly of metal ions and organic linkers have recently been of great interest in the preparation of porous hybrid materials with a wide variety of functions. Despite much research in this area and the large choice of building blocks used to fine-tune pore size and structure, it remains a challenge to synthesise frameworks composed of polyamines to tailor the porosity and adsorption properties for CO(2). Herein, we describe a rigid and microporous three-dimensional metal-organic framework with the formula [Zn(2)(L)(H(2)O)]Cl (L=1,4,7-tris(4-carboxybenzyl)-1,4,7-triazacyclononane) synthesised in a one-pot solvothermal reaction between zinc ions a…
Thermal analyses of commercial magnesium stearate pseudopolymorphs
2005
Abstract Two commercial magnesium stearate powders in two well-characterised structural states are investigated using DSC and coupled TGA–DTA under dry nitrogen flow. They consist of either a mixture of crystalline hydrates or a poorly crystallised so-called anhydrate. Following the degassing of unbound water, 1 or 3 weight-loss peaks are observed below about 100 °C, each associated with one heat loss peak at the same temperature. The present results and a review of graphical data from literature show that the so-called anhydrate always contains a significant amount of water. At the beginning of the dehydration process, the heat loss is the same as the standard heat of vaporisation of water…
Snapshots of calcium carbonate formation – a step by step analysis
2017
Abstract Recent advances in our understanding of CaCO3 nucleation from solution have provoked new and challenging questions. We have studied CaCO3 formation using precipitation by carbonate ester hydrolysis which ensures precipitation from a strictly homogeneous solution state and allows “titrating” carbonate to a solution with a given Ca2+ concentration on a timescale suited for kinetic studies. Nucleation and crystallization were traced by combining dynamic light scattering (DLS) and transmission electron microscopy (TEM). DLS served as in situ technique to identify the nucleation time, to monitor particle size evolution, to discriminate different precipitation mechanisms and to validate …
Alternating current electrogravimetry of copper electrodissolution in a sulfuric acid solution
2017
Abstract Copper electrodissolution processes have been studied by means of electrochemical impedance spectroscopy and ac-electrogravimetry (mass impedance). During ac-electrogravimetry acquisition, mass decreases or increases due to the electrodissolution or the electrodeposition of copper, respectively. As a result, this continuous mass drift makes impossible obtaining a true ac-electrogravimetry response unless a numerical correction was applied. It has been compared the electrochemical behavior of copper layers previously treated and other freshly deposited on the gold electrode of the quartz crystal microbalance. The simultaneous analysis of both impedance functions has allowed separati…
Using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry for the characterization of functionalized carbon nanotubes
2013
RATIONALE Functionalization of carbon nanotubes (CNTs) generates complex systems that require the development of suitable characterization protocols. New techniques have been explored, and existing analytical and spectroscopic methods to characterize functionalized CNTs have been adapted. Presently, chemical characterization of functionalized CNTs (f-CNTs) remains a difficult task. METHODS Matrix-assisted laser desorption/ionization (MALDI) analysis is performed on f-MWCNT samples prepared via grafting or absorption of anti-oxidant (AO) molecules on both MWCNT-COOH and MWCNT-OH. Covalently functionalized MWCNTs were subjected to thermal degradation and/or hydrolysis reaction before analysis…