Search results for "Combustion"

Modelling of Mercury Emissions from Large Solid Fuel Combustion and Biomonitoring in CZ-PL Border Region

2016

Abstract Tightening of norms for air protection leads to a development of new and significantly more effective techniques for removing particulate matter, SOx and NOx from flue gas which originates from large solid fuel combustion. Recently, it has been found that combinations of these environmental technologies can also lead to the reduction of mercury emissions from coal power plants. Now the greatest attention is paid especially to the coal power plant in Opatovice nad Labem, close to Hradec Kralove. Its system for flue gas dedusting was replaced by a modern type of cloth fabric filter with the highest particle separation efficiency which belongs to the category of BAT. Using this techno…

Tetra- and pentachlorodibenzothiophenes are formed in waste combustion

1991

Abstract Two different waste combustion samples have been analyzed for tetra- and pentachlorodibenzothiophenes. HRGC/HRMS with a resolution of 20 000 was used for identification. By resolution of 10 000 chlorinated dibenzo-p-dioxins and some unknown compounds gave GC/SIM peaks at the exact masses of the chlorinated dibenzothiophenes. These peaks were no more present by resolution 20 000. Several tetra- and pentachlorodibenzothiophenes were found in both samples. In the other one of the samples the concentrations were seemingly high although exact quantitative determination could not be done.

Chlorinated dioxins and dibenzothiophenes in fly ash samples from combustion of peat, wood chips, refuse derived fuels and liquid packaging boards

1995

Abstract Peat, wood chips, refuse derived fuel and liquid packaging board in different combinations were burned at a temperature of at least 850 °C. Fly ash samples from these combustions were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzothiophenes (PCDBTs) by high resolution GC/MS. The concentrations of tri- and tetrachlorodibenzothiophenes and tri-, tetra- and pentachlorodioxins were highest when mixtures of wood chips and refuse derived fuel (RDF) were burned. The fly ash from the combustion of pure peat pellets did not contain any polychlorinated dibenzothiophenes. When wood chips and RDF were burned the concentrations of chlorinated compounds in fly…

Mineral Deposit Formation in Gas Engines During Combustion of Biogas from Landfills and Municipal WWTP

2020

Abstract The biogas produced in municipal wastewater-treatment plants (WWTP) should be cleaned before it can be used as a fuel in internal combustion engines. Efficient running of such engines is possible only subject to using high quality biogas and lubricating oil. Otherwise, biogas impurities in course of complex chemical reactions may form deposits on various engine parts as well as seriously contaminate the lubricating oil. In this paper, mineral deposits containing high concentration of bismuth, silicon, sulphur, calcium and zinc are studied. Silicon deposits demonstrating strong friction properties are formed during combustion of volatile silica compounds. As these deposits build up,…

PCDDs, PCDFs, PCDTs, PCBs and some other organochlorine compounds in pine needles exposed to pulp and paper mill emissions and effects of waste combu…

1997

Concentrations of semivolatile chlorinated organic compounds α-HCH, lindane, HCB, DDT, DDE, DDD, chlordanes and PCBs, and low-volatility compounds PCDDs, PCDFs and PCDTs in pine needles in a recipient area of the emissions from a pulp and paper mill where also waste combustion was done were measured. Mostly, the concentrations were found to be near the background levels. Elevated concentrations of HCB, some PCB congeners and some HxCDF isomers in samples from two sampling points were observed. Some other possible point sources of these compounds are situated in the vicinity of the pulp and paper mill.. Also the community of Pietarsaari is one possible source of the slightly elevated concent…

Influence of mw pretreatment on main gasification/combustion characteristics of different types of biomass

2020

Combustion synthesis of MoSi2 and MoSi2–Mo5Si3 composites: Multilayer modeling and control of the microstructure

2010

International audience; In this work, we present a multilayer modeling for the formation of molybdenum silicides in the exothermic reaction between Mo and Si under the influence of a temperature pulse. The heating rate can either be a well-controlled ramp or be generated spontaneously by the propagation of a combustion synthesis front. The model addresses the specific situation above the melting point of silicon and describes the solid–liquid reaction taking place in a single representative particle of molybdenum surrounded by the melt of silicon. We obtain a set of kinetic equations for the propagation of the interfaces between the different layers (Mo/Mo5Si3 and Mo5Si3/MoSi2) in the solid…

Development and validation of a 5 stroke engine for range extenders application

2014

International audience; A 5-stroke turbo-charged port-injection spark-ignition engine has been developed in the present study for use as a range extender or series-hybrid main power source. The development and the design of the engine are based on 0D/1D model and experimental results have been compared with the engine model. The 5-stroke engine is a three-cylinder in which two cylinders perform a four-stroke cycle and alternatively a second expansion of the burnt gases is performed in the third cylinder. The boost pressure delivered by the turbocharger is controlled by a particular innovative system called “smart wastegate”, different from a conventional wastegate, consisting in a variable …

Electric Field Effect on the Thermal Decomposition and Co-combustion of Straw with Solid Fuel Pellets

2019

The aim of this study was to provide more effective use of straw for energy production by co-firing wheat straw pellets with solid fuels (wood, peat pellets) under additional electric control of the combustion characteristics at thermo-chemical conversion of fuel mixtures. Effects of the DC electric field on the main combustion characteristics were studied experimentally using a fixed-bed experimental setup with a heat output up to 4 kW. An axisymmetric electric field was applied to the flame base between the positively charged electrode and the grounded wall of the combustion chamber. The experimental study includes local measurements of the composition of the gasification gas, flame tempe…

CFD modelling of flue gas particulates in a biomass fired stove with electrostatic precipitation

2013

Abstract The biomass fired stoves have been used in medium and large scales applications from several years and are utilizing electrostatic precipitator technology. Biomass based technologies are considered as renewable energy source and less harmful to the environment. The combustion of biomass generates a high concentration of flue gas particulates. The most of the flue gas particulates in the exhaust gas can be filtered through an electrostatic precipitator. In this work, a computational fluid dynamic (CFD) model has been developed for analysing the trajectory of particulates in a small scale domestic stove using biomass material. It is considered that electrostatic precipitator is based…