Search results for "Comet"

Ionic polymers based on dextran: hydrodynamic properties in aqueous solution and solvent mixtures.

2009

Hydrodynamic properties of a series of ionic polysaccharides with different charge density but the same molecular weight have been evaluated in salt-free aqueous solution and aqueous/organic solvent mixtures by means of capillary viscometry. The polyelectrolytes investigated contain quaternary ammonium salt groups, N-ethyl-N,N-dimethyl-2-hydroxypropylammonium chloride, attached to a dextran backbone. The experimental viscometric data have been plotted in terms of the Wolf method. The results show that the experimental data fit well with this model and allow the calculation of intrinsic viscosities and other hydrodynamic parameters, which provide new information about the dependence of the p…

Shear influences on the solubility of LDPE in ethene

1998

Abstract The influence of shear on the demixing pressures of the binary system ethene/polyethene was determined viscometrically in the temperature range 147–195°C up to pressures of 1400 bar at polymer concentrations of 18.4, 22.5 and 27.4 wt%, respectively. Autoclaves were used to prepare the solutions and to measure cloud points for the stagnant system. A high-pressure viscometer was used to perform experiments at shear rates γ up to 1500 s −1 . Under all conditions investigated here the two-phase area grows as γ becomes larger and the demixing pressures increase up to 23 bar. This observation is in contrast to theoretical expectation according to which it should be the one-phase region w…

Solution Properties of Polysarcosine: From Absolute and Relative Molar Mass Determinations to Complement Activation

2018

Polysarcosine (pSar) was one of the first polymers synthesized in a controlled living manner, but it was only recently when it was reconsidered as a promising alternative for poly(ethylene glycol) (PEG) in biomedical applications. Despite receiving more and more attention, very little is known about the solution properties of pSar, such as coil dimensions and thermodynamic interactions. In this article, we report on these properties of pSar with degrees of polymerization 50 < X-n < 400 that were prepared by controlled living ring-opening polymerization. The polymers are characterized by gel permeation chromatography (GPC), MALDI-TOF mass spectrometry, dynamic and static light scattering (SL…

Prediction of the flow curves of thermoplastic polymer/clay systems from torque data

2014

Abstract The aim of this work was to determine some relevant rheological parameters of polymer/clay systems using mixing torque and mixing speed data obtained during processing in an internal mixer. The method used was originally proposed by Marquez et al. for monophase polymers, and is here applied to polymer/clay systems for the first time. Several clay-containing composites based on different polymer matrices (i.e., LDPE, HDPE, PA6, EVA) were used to verify the effectiveness of the method for measuring the flow curves of these polymer/clay systems. The results indicated that, for all the systems at low clay level, the rheological curves calculated with the Marquez method fit quite well t…

Polyelectrolytes in dilute solution: viscometric access to coil dimensions and salt effects

2015

Copolymers of acrylamide (AM) and diallyldimethylammonium chloride (DADMAC), differing in molar masses M (52.3 to 227 kDa) and degrees of charging y (0.2 to 0.6), were studied with respect to their viscometric behavior in dilute aqueous solutions containing variable amounts of NaCl. Complementary measurements were performed on a Brookhaven 90 plus particle size analyzer. M dominates the intrinsic viscosities [η]. For the viscometric interaction parameters B this is only true for large concentrations of extra salt. [η] and B as a function of solvent salinity follow Boltzmann laws. Coil dimensions, determined either via dynamic light scattering or viscometry, agree well. For low salt contents…

1996

An iterative, approximative procedure is presented, to calibrate the determination of molar masses of polymers with gel-permeation chromatography, additionally using viscometry, and transformations, according to Benoit's concept of universal calibration, even if only polymers with broad molar mass distribution are available. The calculated (intermediate) values of the average molar masses from each step of iteration converge to final values. With at least two fractions of the polymers to be analyzed, and with measured intrinsic viscosities of the fractions, a calibration curve of gel-permeation chromatography and Mark-Houwink's constants can be determined. Assumptions for the use of the cal…

Molecular characterization of α , β -poly(asparthylhydrazide) a new synthetic polymer for biomedical applications

1999

Abstract α , β -Poly(asparthylhydrazide) (PAHy) is a new synthetic polymer that exhibits interesting properties and is a candidate for biomedical applications. In this article the characterization of PAHy polymer by multi-angle laser light scattering (MALS) and single-capillary viscometer (SCV) detectors on-line to a size exclusion chromatography (SEC) system is reported. The SEC–MALS–SCV system furnishes exhaustive and consistent characterization of the PAHy polymer. Further, it is possible to characterize the PAHy polymer through conventional SEC and universal calibration. The universal calibration method gives intrinsic viscosity and dispersity very close to those measured by the absolut…

Viscometry of polyelectrolyte solutions: Star-like versus linear poly[[2-(methacryloyloxy)ethyl] trimethylammonium iodide] and specific salt effects

2017

Abstract The intrinsic viscosities, [η], of the 3-arm star polyelectrolyte in pure water are for a given molar mass considerably lower than for the linear product because of the higher monomer concentration and charge density in isolated coils. These effects are much more pronounced than in the case of uncharged macromolecules. Extra salt (NaCl, NaI, CaCl2) reduces the solution viscosities of the 3-arm star polymer less than of the linear product. The transition of [η] from the value in pure water to the minimum saturation value at high salt concentrations follows a Boltzmann sigmoid. In saline solvents the changes of the viscosities with rising polymer concentration depend strongly on the …

Polymer-polymer interaction, in the presence of a solvent as measured by viscometry

2001

Dilute solution viscometry experiments have been carried out in five ternary polymer systems solvent(1)/polymer(2)/polymer(3). Values of the specific viscosity of polymer (3) in a ‘binary solvent’ formed by polymer(2) + solvent(1) have been used to determine the compatibility of the polymer blends. Krigbaum and Wall formalism has been used to predict compatibility which relies on an interaction parameter that depends on the concentration, weight fraction and molar mass of each polymer. To reduce the dependences and to clarify the criterion of compatibility, a parameter independent of polymer (3) composition and molar mass has been deduced. This parameter shows the same behaviour with polyme…

Intrinsic viscosities of polyelectrolytes in the absence and in the presence of extra salt: Consequences of the stepwise conversion of dextran into a…

2011

Abstract Viscosities of dilute polymer solutions were measured in capillary viscometers for samples varying in their fraction f of charged units from 0.00 to 0.90. The dependence of the logarithm of the relative viscosity on polymer concentration c is in all cases reproduced quantitatively by three characteristic parameters: [ η ], the intrinsic viscosity; B , a viscometric interaction parameter (related to the Huggins constant); [ η ] , a parameter required only for polyelectrolytes at low concentrations of extra salt. In pure water [ η ] increases more than 80 times as the fraction f rises from zero to 0.90 and [ η ] starts from zero and goes up to ≈71 mL/g. Upon the addition of NaCl [ η …