Search results for "Composites"
showing 10 items of 1905 documents
Glass fibre strength distribution determined by common experimental methods
2002
The tensile strength of brittle fibres is routinely described by the Weibull distribution. The parameters of the distribution can be obtained from tests on single fibres and fibre bundles or from model composite tests. However, there is growing evidence that the distribution parameters obtained by different experimental techniques differ systematically. In order to investigate the possible causes of such discrepancies, single-fibre tension, fibre bundle, and single-fibre fragmentation tests are employed in this study to obtain strength distribution of commercial E-glass fibres. The results reveal parameter dependence on the approach used to extract the distribution parameters from experimen…
Effectiveness of stirrups and steel fibres as shear reinforcement
2004
This paper presents the results of experimental tests carried out on rectangular simply supported beams made of hooked steel fibre reinforced concrete with and without stirrups, subjected to two-point symmetrically placed vertical loads. The tests, carried out with controlled displacements, allow one to record complete load-deflection curves by means of which it is possible to deduce information on dissipative capacity and ductile behaviour up to failure. Depending on the amount of transverse reinforcement, volume fraction of fibres added in the mix and shear span, the collapse mechanism is due to predominant shear or flexure, thus showing the influence of the aforementioned structural para…
Toward high performance renewable agave reinforced biocomposites: Optimization of fiber performance and fiber-matrix adhesion analysis
2017
Abstract The increasing sensitivity toward the environmental pollution and the recent laws on the environmental protection, have led to an increasing attention to the so called biocomposites, i.e. to ecofriendly or renewable composite materials, obtained from biopolymers reinforced by natural fibers. Although the contribution of various works reported in literature, focused on biocomposites reinforced by agave fibers, such materials are still exclusively used in the automotive industry for non-structural applications, and the implementation of high performance biocomposites for semi-structural and structural applications, is an expected, but not yet reached objective. Therefore, the present…
Salt-fog spray aging of jute-basalt reinforced hybrid structures. Flexural and low velocity impact response
2017
Abstract In this work, a study on the aging resistance of jute and jute-basalt interply hybrid laminates exposed to salt-fog is presented with the aim to investigate the possibility to enhance the durability of natural fiber reinforced composites for marine application by a ply-substitution approach. In particular, jute and basalt/jute reinforced composite plates were manufactured by vacuum assisted resin infusion in two different staking sequences (i.e., intercalated and sandwich-like basalt-jute) and aged under salt fog conditions. The effects of the accelerated aging at increasing times on the mechanical response of laminates were assessed in both quasi static (three point bending) and d…
Mechanical properties of pultruded glass fiber-reinforced plastic after moistening
2012
Abstract The kinetics of moisture sorption under immersion in water at room and elevated temperatures and flexural characteristics of dry (conditionally initial) and wet (moistened up to saturation level) composite material were investigated on flat specimens of polyester based glass fiber-reinforced plastic, cut from I-beam pultruded profile. It was found that the coefficients of diffusion and swelling are different in three principal axis of the composite. The former have the largest value in fiber axis direction, but the latter – in transverse to fiber axis direction out of plane of the layers. The observed difference in kinetics of mass gain and change of volume strain for the specimens…
Estimation of the tensile strength of an oriented flax fiber-reinforced polymer composite
2011
Unidirectional orientation of natural fibers in a polymer composite ensures the highest efficiency of reinforcement. Flax fiber reinforcement is discontinuous due to limited fiber length and heterogeneous due to the presence of elementary fibers and their bundles. In order to assess the upper limit of tensile strength of such slightly misoriented, nominally UD natural fiber composite, a statistical strength model of continuous UD fiber reinforced composites is applied. It is found that the experimental strength of UD flax composites, produced from rovings or manually aligned fibers, approaches the theoretical limit only at relatively low fiber volume fraction ca. 0.2, being markedly below i…
Solution processable phosphorescent dendrimers based on cyclic phosphazenes for use in organic light emitting diodes (OLEDs)
2008
A novel solution processable phosphorescent dendrimer based on cyclic phosphazene (CP) cores has been prepared and used as emissive layers in simple OLED architectures, providing efficiencies of 24.0 cd A^-1 and 16.7 lm W^-1. Bolink, Henk, Henk.Bolink@uv.es ; Garcia Santamaria, Sonsoles Amor, Sonsoles.Garcia@uv.es
Very high titanium content mesoporous silicas
2001
Titanium content in mesoporous titanosilicate catalysts has been modulated up to a minimum Si/Ti value of 1.9 by using complexing agents able to coordinate both Si and Ti atoms and harmonize the reactivity of the resulting precursors avoiding subsequent phase segregation and leading to chemically very homogeneous materials. El Haskouri, Jamal, Jamal.Haskouri@uv.es ; Beltran Porter, Aurelio, Aurelio.Beltran@uv.es ; Beltran Porter, Daniel, Daniel.Beltran@uv.es ; Amoros del Toro, Pedro Jose, Pedro.Amoros@uv.es
Intercalation of decamethylferrocenium cations in bimetallic oxalate-bridged two-dimensional magnets
1997
The structure and magnetic properties of novel hybrid molecule-based magnets formed by combination of two magnetically active sublattices, the bimetallic oxalatobridged honeycomb net [MnIIMIII(ox)3] (MII = Mn, Fe, Co, Cr, Ni, Cu; MIII = Cr, Fe) and the organometallic cation decamethylferrocenium, are reported. Clemente Leon, Miguel, Miguel.Clemente@uv.es ; Coronado Miralles, Eugenio, Eugenio.Coronado@uv.es ; Galan Mascaros, Jose Ramon, Jose.R.Galan@uv.es ; Gomez Garcia, Carlos Jose, Carlos.Gomez@uv.es
Supramolecular self-assembling in mesostructured materials through charge tuning in the inorganic phase
1998
Supramolecular self-assembling of organic CTA+ micelles and inorganic [VO(H2O)PO4]n^q-2 2D-anions for the isolation of hexagonal mesostructured materials can be reached by charge tuning in the inorganic phase through the adjustment of the vanadium mean oxidation state. El Haskouri, Jamal, Jamal.Haskouri@uv.es ; Cabrera Medina, Saul, Saul.Cabrera@uv.es ; Beltran Porter, Aurelio, Aurelio.Beltran@uv.es ; Alamo Serrano, Jaime, Jaime.Alamo@uv.es ; Beltran Porter, Daniel, Daniel.Beltran@uv.es ; Amoros del Toro, Pedro Jose, Pedro.Amoros@uv.es