Search results for "Computer network"

showing 10 items of 1634 documents

Revealing transmit diversity mechanisms and their side-effects in commercial IEEE 802.11 cards

2008

Service differentiation in WLAN has been traditionally faced at the MAC layer. However, some PHY layer parameters, such as the transmission power, the antenna, and the modulation/coding scheme, have a deep impact on network performance. Since the criterion for selecting these parameters is left to the vendor specific implementations, the performance spread of most experimental results about 802.11 WLAN could be affected by vendor proprietary schemes. The focus of this paper is an experimental analysis of the undisclosed antenna diversity mechanisms employed by some widely used cards (namely, the Atheros and Intel based cards), and a thorough understanding of the optimization goals which gui…

Engineeringbusiness.industryComputerSystemsOrganization_COMPUTER-COMMUNICATIONNETWORKSPhysical layerNetwork interfaceAntenna diversityTransmit diversityIEEE 802.11Robustness (computer science)Electronic engineeringNetwork performanceFadingbusinessComputer network2008 4th International Telecommunication Networking Workshop on QoS in Multiservice IP Networks
researchProduct

Energy Harvesting-Aware Backoff Algorithms for Distributed Device-to-Device Communication

2016

Due to limited energy capacity in mobile devices, energy harvesting is regarded as a promising technology for lifetime extension in device-to-device (D2D) communication. However, medium access control (MAC) protocols designed for D2D communication intrinsically do not consider the existence of harvested energy. In this paper we study four backoff (BO) algorithms, among which one algorithm is proposed to enhance the BO selection based on energy harvesting rate and residual energy of devices. Simulations are performed in order to assess how the proposed algorithm can extend the lifetime of a D2D communication network as well as to provide fair channel access opportunities among devices.

Engineeringbusiness.industryDevice to device05 social sciences050801 communication & media studies020206 networking & telecommunicationsAccess control02 engineering and technologyTelecommunications networkLifetime extension0508 media and communications0202 electrical engineering electronic engineering information engineeringbusinessAlgorithmMobile deviceEnergy harvestingEnergy (signal processing)Computer networkCommunication channel2016 IEEE 83rd Vehicular Technology Conference (VTC Spring)
researchProduct

Development of Diagnostic Systems for the Fault Tolerant Operation of Micro-Grids

2010

The progressive penetration level of Distributed Generation (DG) is destined to cause deep changes in the existing distribution networks no longer considered as passive terminations of the whole electrical system. A possible solution is the realization of small networks, namely the Micro-Grids, reproducing in themselves the structure of the main production and distribution of the electrical energy system. In order to gain an adequate reliability level of the micro-grids the individuation and the management of the faults with the goal of maintaining the micro-grid operation (fault tolerant operation) is quite important. In the present paper after the introduction of the aims of several diagn…

Engineeringbusiness.industryEnergy managementReliability (computer networking)Fault toleranceSettore ING-IND/32 - Convertitori Macchine E Azionamenti ElettriciFault (power engineering)AutomationReliability engineeringFault managementMicro-Grid Fault Tolerance Faults.Settore ING-IND/33 - Sistemi Elettrici Per L'EnergiaElectric power systemDistributed generationbusiness
researchProduct

Adaptative Network Topology for Data Centers

2016

Data centers have an important role in supporting cloud computing services (such as email, social networking, web search, etc.) enterprise computing needs, and infrastructure-based services. Data center networking is a research topic that aims at improving the overall performances of the data centers. It is a topic of high interest and importance for both academia and industry. Several architectures such as FatTree, FiConn, DCel, BCube, and SprintNet have been proposed. However, these topologies try to improve the scalability without any concerns about energy that data centers use and the network infrastructure cost, which are critical parameters that impact the performances of data centers…

Engineeringbusiness.industryNetwork TopologyData center networksupporting cloud computing servicesComputer securitycomputer.software_genreNetwork topologyAverage path lengthBottleneckLow latency (capital markets)ServerScalabilityData centerInstalled basebusinesscomputerComputer networkQatar Foundation Annual Research Conference Proceedings Volume 2016 Issue 1
researchProduct

Implementation of a Drosophila-inspired orientation model on the Eye-Ris platform

2010

A behavioral model, recently derived from experiments on fruit-flies, was implemented, with successful comparative experiments on orientation control in real robots. This model has been firstly implemented in a standard CNN structure, using an algorithm based on classical, space-invariant templates. Subsequently, the Eye-Ris platform was utilised for the implementation of the whole strategy, at the aim to constitute a stand alone smart sensor for orientation control in bio-inspired robotic platforms. The Eye-Ris vl.2 is a visual system, made by Anafocus, that employs a fully-parallel mixed-signal array sensor-processor chip. Some experiments are reported using a commercial roving platform, …

Engineeringbusiness.industryOrientation (computer vision)Reliability (computer networking)ChipBehavioral modelingVisualizationAttitude controlIntelligent sensorComputer architectureRobotComputer visionArtificial intelligencebusiness
researchProduct

End-to-End Quality of Service Support

2005

Engineeringbusiness.industryQuality of serviceDiffServQoSend-to-endIntServEnd-to-end principleIPIP; QoS; signalling; end-to-end; DiffServ; IntServsignallingbusinessTelecommunicationsComputer network
researchProduct

Uprating an Overhead Line. Italian TSO Applications for Integration of RES

2013

The increase of Renewable Energy Sources (RES) production units has caused significant changes in the electrical system configuration. The existing structural asset isn't adequate to dispatch these new power flows that, at same time, should be favorite by various TSOs in order to obtain incentives. The outage of primary substations on the grid and the increase of consumptions have caused growing load currents on existing overhead line. This paper, after introducing thermal resistant conductors and Dynamic Rating (DR) solutions, reports an applications used by TERNA Group S.p.A. (Italian TSO). These systems are already installed on lines and they are contributing to increase power flows than…

Engineeringbusiness.industryReliability (computer networking)Electrical engineeringGridRenewable energyPower (physics)Reliability engineeringSettore ING-IND/33 - Sistemi Elettrici Per L'EnergiaElectric power systemUprating of overhead line thermal resistant conductor Dynamic thermal rating.Smart gridAsset (economics)businessOverhead line
researchProduct

An architecture Wi-fi and GPRS for efficient management of distribution electrical networks

2008

In this paper, a telecommunication infrastructure for faults management is proposed. The complete automation of the electrical energy distribution requires the implementation of suitable data transmission systems able to easily interface with microprocessor based systems and to handle large amount of data. In particular, reliability and speed of the data transmission system are required in the fault diagnosis and post-fault management procedures, in order to guarantee high quality standards. The proposed diagnostic system indeed works by means of a set of intercommunicating MV/LV dasiaintelligent substationspsila. In this paper, after a brief description of the fault diagnostic system, an o…

Engineeringbusiness.industryReliability (computer networking)Interface (computing)media_common.quotation_subjectFault (power engineering)Automationlaw.inventionSet (abstract data type)MicroprocessorlawEmbedded systemQuality (business)General Packet Radio Servicebusinessmedia_common2008 43rd International Universities Power Engineering Conference
researchProduct

Designing an open source maintenance-free Environmental Monitoring Application for Wireless Sensor Networks

2015

We discuss the analysis and design of an Environmental Monitoring Application.The application is reliable and maintenance-free, runs in multihop wireless network.We analyze the different alternatives and tradeoffs, using open source software.The application is validated in long-term outdoor deployments with good results.Related work does not analyze the software design with open source. We discuss the entire process for the analysis and design of an Environmental Monitoring Application for Wireless Sensor Networks, using existing open source components to create the application. We provide a thorough study of the different alternatives, from the selection of the embedded operating system to…

Engineeringbusiness.industryReliability (computer networking)Real-time computingNetwork topologyPortingEmbedded operating systemHardware and ArchitectureEnvironmental monitoringWirelessSoftware designbusinessWireless sensor networkSoftwareInformation SystemsJournal of Systems and Software
researchProduct

A suitable control technique for fault-tolerant converters in Distributed Generation

2011

The penetration of Distributed Generation (DG) in power systems is deeply changing the existing distribution networks which is becoming a very sophisticated and complex systems incorporating both active (generators) and passive systems (distribution systems, converters and loads). The necessary simplification can be obtained dealing with small networks, namely Micro-Grids, reproducing, in a smaller scale, the structure and the problems of large networks including production, transmission and distribution of the electrical energy. In order to achieve an adequate level of reliability, fault-tolerant operations of micro-grids become very important. This result can be achieved only using power …

Engineeringbusiness.industryReliability (computer networking)Topology (electrical circuits)Control engineeringFault toleranceSettore ING-IND/32 - Convertitori Macchine E Azionamenti ElettriciConvertersPower (physics)Capacitors Circuit faults Fault tolerance Fault tolerant systems Leg Mathematical model TopologyElectric power systemTransmission (telecommunications)fault-tolerant convertersDistributed generationElectronic engineeringPWM modulationbusinessfault-tolerant converters; PWM modulation
researchProduct