Search results for "Computer network"
showing 10 items of 1634 documents
Analysis of duplexing modes in the IEEE 802.16 wireless system
2010
The IEEE 802.16 standard defines two main duplexing modes: Time Division Duplexing (TDD) and Frequency Division Duplexing (FDD). The FDD can be divided further into Full-FDD (F-FDD) and Half-FDD (H-FDD). F-FDD requires full duplexing support from subscriber stations and works with two frequency bands. TDD operates a single frequency band, but it does not need full-duplexing support. H-FDD is a combination of these: it works with two frequency bands and does not require full-duplexing support. The cost of this is a more complicated scheduling and added overhead. Still, H-FDD might be the only possible duplexing mode in some occasions. In this paper, these duplexing modes are compared and the…
A performance analysis of block ACK scheme for IEEE 802.11e networks
2010
The demand for the IEEE 802.11 wireless local-area networks (WLANs) has been drastically increasing along with many emerging applications and services over WLAN. However, the IEEE 802.11 medium access control (MAC) is known to be limited in terms of its throughput performance due to the high MAC overhead, such as interframe spaces (IFS) or per-frame based acknowledgement (ACK) frame transmissions. The IEEE 802.11e MAC introduces the block ACK scheme for improving the system efficiency of the WLAN. Using the block ACK scheme can reduce the ACK transmission overhead by integrating multiple ACKs for a number of data frames into a bitmap that is contained in a block ACK frame, thus increasing t…
Increasing the VoIP Capacity through MAP Overhead Reduction in the IEEE 802.16 OFDMa Systems
2010
One of the main issues with supporting VoIP service over 802.16 networks is the signalling overhead caused by the downlink MAP messages due to frequent transmissions and small packets. To decrease the MAP overhead, the 802.16 standard proposes some mechanisms, such as the compressed MAP and sub-MAPs. In this paper, we show by means of extensive dynamic simulations that sub-MAPs can reduce dramatically the signalling overhead associated with VoIP traffic and significantly improve overall VoIP capacity. At the same time, since sub-MAPs are more sensitive to packet drops, they tend to increase the number of HARQ retransmissions in downlink and transmission delays in the uplink direction.
Adaptive Contention Resolution for VoIP Services in the IEEE 802.16 Networks
2007
In the IEEE 802.16 networks, a subscriber station can use the contention slots to send bandwidth requests to the base station. The contention resolution mechanism is controlled by the backoff start/end values and a number of the request transmission opportunities. These parameters are set by the base station and are announced to subscriber stations in the management messages. In the case of the VoIP services, it is critical that the contention resolution occurs within the specified time interval to meet the VoIP QoS requirements. Thus, it is the responsibility of the base station to set correct contention resolution parameters to ensure the QoS requirements. This paper presents analytical c…
Analysis of the Non-Transparent In-Band Relays in the IEEE 802.16 Multi-Hop System
2010
This paper presents extensive dynamic simulations of the non-transparent in-band relays working in the distributed scheduling mode. The simulation results show that in-band relays can improve noticeably the spectral efficiency without acquiring an additional radio spectrum. Also, packet transmission delays become smaller. An important outcome of the dynamic simulations is that it is very crucial to choose a correct relay zone size where the base station and relay nodes exchange data. Otherwise, throughput fairness of the whole system declines. It indicates an importance of the relay zone size adjustment algorithm that the base station must run.
ARQ parameters for VoIP in IEEE 802.16 networks
2009
IEEE 802.16 standard defines two data retransmission mechanisms. HARQ provides fast retransmissions in cost of slightly increased overhead. On the contrary, ARQ has less overhead in cost of bit longer delays. It is therefore often used with BE connections. In addition to delay tolerant applications, BE can also be used for real-time services. Therefore, in this paper we analyze the ARQ mechanism and provide guidelines on how to set the ARQ parameters to achieve a good balance between the VoIP delay and packet loss.
Adaptive contention resolution parameters for the IEEE 802.16 networks
2007
In the IEEE 802.16 networks, the base station allocates resources to subscriber stations based on their QoS requirements and bandwidth request sizes. A subscriber station can send a bandwidth request when it has an uplink grant allocated by the base station or by taking part in the contention resolution mechanism. This paper presents analytical calculations for parameters that control the contention resolution process in the IEEE 802.16 networks. In particular, the backoff start/end values and the number of request transmission opportunities are considered. The simulation results confirm the correctness of theoretical calculations. They also reveal that the adaptive parameter tuning results…
Impact of portable device restrictions on IEEE 802.16 performance
2008
IEEE 802.16 is a good alternative for fast wireless connection in the next generation portable information devices (PID). However it was not originally designed for portable devices, but mobility was added later to the specification. This means that the lack of resources on portable devices might have a significant impact on which IEEE 802.16 features should be chosen and how they should be used. Proper usage of ARQ can increase the IEEE 802.16 performance but it can also require much resources from PIDs. In this paper we focus on how ARQ features are affected by limited resources on PID and how much the limitations affect on the performance.
Rethinking the IEEE 802.11e EDCA Performance Modeling Methodology
2010
Analytical modeling of the 802.11e enhanced distributed channel access (EDCA) mechanism is today a fairly mature research area, considering the very large number of papers that have appeared in the literature. However, most work in this area models the EDCA operation through per-slot statistics, namely probability of transmission and collisions referred to "slots." In so doing, they still share a methodology originally proposed for the 802.11 Distributed Coordination Function (DCF), although they do extend it by considering differentiated transmission/ collision probabilities over different slots.We aim to show that it is possible to devise 802.11e models that do not rely on per-slot statis…
Analysis of the limitations of WiFi communications managed by the IEEE 802.11 protocol in data transmission in automated power distribution systems
2010
This paper presents a study on the performances of the IEEE 802.11 protocol used in a Medium Voltage networks management system, carried out using a model for the simulation of WiFi chains architectures. The results of the simulations give some practical indications for the use of the IEEE 802.11 protocol also in presence of transmissions characterized by rigid time intervals, for which this protocol is usually not suitable. Finally the whole communications system is presented.