Search results for "Comunicaciones"

Continuous Broadband MWP True-Time Delay with PbS-PMMA and -SU8 waveguides

2016

[EN] A new microwave true-time delay (TTD) photonic unit based on the dispersion of PbS colloidal quantum dots (QDs) in a Polymethyl methacrylate (PMMA) and the SU8 photoresist is presented. With this aim, the PbS-PMMA and PbS-SU8 nanocomposites are integrated on a silicon platform in the form of a planar and ridge waveguides, respectively. When PbS QDs on those structures are pumped below their band-gap, a phase shift and a temporal delay in an optically conveyed (at 1550 nm) microwave signal is performed. The results of these devices show potential benefits over current TTD technologies, since the proposed photonic waveguide structures allows real-time adjustment of the temporal delay by …

Optical properties of ZnMgO films grown by spray pyrolysis and their application to UV photodetection

2015

This work presents a comprehensive optical characterization of Zn1−xMgxO thin films grown by spray pyrolysis (SP). Absorption measurements show the high potential of this technique to tune the bandgap from 3.30 to 4.11 eV by changing the Mg acetate content in the precursor solution, leading to a change of the Mg-content ranging from 0 up to 35%, as measured by transmission electron microscopy-energy dispersive x-ray spectroscopy. The optical emission of the films obtained by cathodoluminescence and photoluminescence spectroscopy shows a blue shift of the peak position from 3.26 to 3.89 eV with increasing Mg incorporation, with a clear excitonic contribution even at high Mg contents. The lin…

Temperature Sensor Based on Colloidal Quantum Dots PMMA Nanocomposite Waveguides

2012

In this paper, integrated temperature sensors based on active nanocomposite planar waveguides are presented. The nanocomposites consist of cadmium selenide (CdSe) and cadmium telluride (CdTe) quantum dots (QDs) embedded in a polymethylmethacrylate (PMMA) matrix. When the samples are heated in a temperature range from 25$^{circ}{rm C}$ to 50 $^{circ}{rm C}$, the waveguided photoluminescence of QDs suffers from a strong intensity decrease, which is approximately quadratic dependent on temperature. Moreover, the wavelength peak of the waveguided emission spectrum of CdTe-PMMA shows a blue shift of 0.25 ${rm nm}/^{circ}{rm C}$, whereas it remains constant in the case of CdSe-PMMA. A temperature…

High frequency microwave signal generation using dual-wavelength emission of cascaded DFB fiber lasers with wavelength spacing tunability

2010

[EN] A dual wavelength fiber laser source based on two cascaded phase-shifted fiber Bragg gratings is presented The gratings are written in an erbium-doped fiber each configuring the cavity of a distributed feedback fiber laser The spacing between lasing modes is controlled dynamically by the use of piezoelectric actuators A continuous tuning range of 5-724 pm of the wavelength difference which is equivalent to a photodetected 072-92 GHz range is obtained Efficient generation from the L to the W microwave and millimeter bands has been achieved by heterodyne photodetection of the dual-wavelength optical signal (C) 2010 Elsevier BV All rights reserved

Analysis of multipactor RF breakdown in a waveguide containing a transversely magnetized ferrite

2016

In this paper, the multipactor RF breakdown in a parallel-plate waveguide partially filled with a ferrite slab magnetized normal to the metallic plates is studied. An external magnetic field is applied along the vertical direction between the plates in order to magnetize the ferrite. Numerical simulations using an in-house 3-D code are carried out to obtain the multipactor RF voltage threshold in this kind of structures. The presented results show that the multipactor RF voltage threshold at certain frequencies becomes considerably lower than for the corresponding classical metallic parallel-plate waveguide with the same vacuum gap

Acoustically driven arrayed waveguide grating.

2015

We demonstrate compact tunable phased-array wavelength-division multiplexers driven by surface acoustic waves (SAWs) in the low GHz range. The devices comprise two couplers, which respectively split and combine the optical signal, linked by an array of single-mode waveguides (WGs). Two different layouts are presented, in which multi-mode interference couplers or free propagating regions were separately employed as couplers. The multiplexers operate on five equally distributed wavelength channels, with a spectral separation of 2 nm. A standing SAW modulates the refractive index of the arrayed WGs. Each wavelength component periodically switches paths between the output channel previously asi…

MWP true time delay implemented in PbS-SU8 waveguides

2015

Es presenta un nou tipus de dispositiu de retard en temps real de microones (TTD) basat en la dispersió de punts quàntics col·loïdals PbS (QD) en el fotoresist SU8 disponible comercialment. Amb aquest propòsit, els nanocompostos PbS-SU8 s’integren en una plataforma de silici en forma de guies d’ones de cresta. Quan aquestes estructures es bomben a longituds d’ona per sota de l’interval de banda dels PbS QD, es realitza un desplaçament de fase en un senyal de microones transmès òpticament (a 1550 nm) i, per tant, es produeix un retard temporal. A més, es milloren els resultats mitjançant la implementació d’una nova guia d’ones de doble capa de cresta composta per un nanocompost PbS-SU8 i una…

Mercado mundial frente a proyecto europeo

1998

A Bayesian direction-of-arrival model for an undetermined number of sources using a two-microphone array.

2014

Sound source localization using a two-microphone array is an active area of research, with considerable potential for use with video conferencing, mobile devices, and robotics. Based on the observed time-differences of arrival between sound signals, a probability distribution of the location of the sources is considered to estimate the actual source positions. However, these algorithms assume a given number of sound sources. This paper describes an updated research account on the solution presented in Escolano et al. [J. Acoust. Am. Soc. 132(3), 1257-1260 (2012)], where nested sampling is used to explore a probability distribution of the source position using a Laplacian mixture model, whic…

Putting Oneself in the Body of Others: A Pilot Study on the Efficacy of an Embodied Virtual Reality System to Generate Self-Compassion

2019

[EN] Compassion-based interventions (CBIs) have been shown to be effective for increasing empathy and compassion, and reducing stress, anxiety, and depression. CBIs are based on constructive meditations where imagery abilities are essential. One of the major difficulties that participants report during the training is the difficulty related to imagery abilities. Virtual reality (VR) can be a useful tool to overcome this limitation because it can facilitate the construction and sustainment of mental images. The machine to be another (TMTBA) uses multi-sensory stimulation to induce a body swap illusion. This system allows participants to see themselves from a third perspective and have the il…