Search results for "Concentration effect"
showing 10 items of 80 documents
Modeling of Amino Acid Electrodiffusion through Fixed Charge Membranes
2001
Abstract We study theoretically the electrodiffusion of amino acids through fixed charge membranes, calculating the ionic fractions of the amino acid in the membrane as well as its total flux as a function of the relevant experimental parameters (amino acid concentration, salt concentration, and pH of the external solution; membrane fixed charge concentration; and amino acid membrane/solution partition coefficients) under different experimental conditions (symport vs antiport transport, uphill transport, etc.). The theoretical approach employed is based on the Nernst–Planck flux equations in the (Goldman) constant electric field assumption and considers all the species present in the system…
Solvent quality as reflected in concentration- and temperature-dependent Flory-Huggins interaction parameters
2001
Flory-Huggins interaction parameters (χ) between poly(dimethylsiloxane) (weight-average molecular weight = 152 kg/mol) and various solvents (methyl ethyl ketone, toluene and n-octane) were determined as a function of composition and temperature with vapor-pressure measurements. These data, complemented by independent information for dilute and very concentrated solutions, serve as the basis for a discussion of solvent quality via different theoretical relations. Regardless of polymer concentration, the χ values fall from methyl ethyl ketone via toluene to n-octane, the ketone being the worst solvent and the hydrocarbon being the best solvent. The variation of χ with composition and temperat…
Behaviour of modified and unmodified polybutadienes in the semidilute regime
1997
Abstract The association behaviour of polybutadiene modified with 4-phenyl-l,2,4-triazoline-3,5-dione was studied in semidilute solution through static (SLS) and dynamic light scattering (DLS). The results were compared with the unmodified polybutadiene, whose behavior in semidilute solution was also studied as function of the molecular weight. At higher concentrations a small-angle excess scattering in SLS and a slow mode motion in DLS were observed both for modified and unmodified polybutadienes suggesting the presence of large clusters. Increasing the polymer concentration, the mass fraction of the slow motion increases up to values near 1, indicating a proximity to the gel point. For po…
Dependence of Coefficient of volumetric thermal expansion (CVTE) of glass fiber reinforced (GFR) polymers on the glass fiber content
2007
In a Glass Fiber Reinforced (GFR) polymer, the coefficient of volumetric thermal expansion CVTE (determined as a sum of the coefficients of linear thermal expansion CLTE’s for the three principal directions) is sometimes much smaller than the value predictable on the basis of well acquainted models, such as Chow model, taking into account fibers anisotropy and aspect ratio.
Effect of random copolymer additives on the interfacial tension between incompatible polymers
1998
Interfacial tensions γ were measured for mixtures of poly(methylphenylsiloxane) (4 kg/mol) and poly(dimethylsiloxane) (24 kg/mol) in the absence and in the presence of small amounts of the random copolymer poly(dimethylsiloxane-ran-methylphenylsiloxane) (89 mol-% of dimethylsiloxane units, 28 kg/mol) from 25 to 110°C. Approximately 1 wt.-% of the copolymer additive suffices to reduce γ from ca. 2.2 to 1.6 mN/m. The time dependence of the apparent γ value in the course of the attainment of equilibria also indicates surface acivity. The hypothesis is formulated that the efficiency of the random copolymer for a reduction of γ is bound to the condition that it is only sparingly soluble in both …
Excess viscosity and glass transition
2001
Abstract Literature data on the viscosity of solutions of poly(butyl methacrylate) (PBMA) and poly(methyl methacrylate) (PMMA) in diethyl phthalate (DEP) for different temperatures, including the range around and below T g , the glass transition temperatures of the pure polymers, were evaluated by means of an approach that uses surface fractions as composition variables. The discussion of these results together with information on solutions of the isomeric polymers, poly(vinyl acetate) (PVAc) and poly(methyl acrylate) (PM(A)), in the same solvent testifies that the previously published relations remain valid for T T g . They enable the determination of viscosities of the pure polymers below…
Stabilisation of LDPE cross-linked in the presence of peroxides III. Mass spectrometric study of chemical changes taking place in the n-octadecane–di…
2000
Abstract An attempt was made to identify the products of the reaction between dicumyl peroxide and Irganox 1081, carried out in n -octadecane (saturated hydrocarbon), in conditions of fast decomposition of the peroxide (180°C, 5 min). Mass spectrometry (MS) was employed to find m/z values of molecular and fragment ions in analyses of the components ( n -octadecane, dicumyl peroxide, Irganox 1081) and of the following systems: n -octadecane–dicumyl peroxide, n -octadecane–Irganox 1081 and n -octadecane–dicumyl peroxide–Irganox 1081, after holding them at a temperature of 180°C for 5 min. The tendency of sulphur in Irganox 1081 to oxidise, specifically in the presence of dicumyl peroxide, was…
Branched Versus Linear Polyisoprene: Flory-Huggins Interaction Parameters for their Solutions in Cyclohexane
2009
Flory-Huggins interaction parameters were determined as a function of composition for solutions of linear and of branched polyisoprene in cyclohexane (CH) at 25, 45, and 65 °C by means of vapor pressure measurements (moderate to concentrated solutions) and by vapor pressure osmometry (dilute solutions). The results demonstrate that CH is a considerably worse solvent for branched polyisoprene than for the linear analog at all temperatures and at all compositions. This observation corroborates the expectation based on a recent phenomenological approach, which accounts explicitly for the incapability of the segments of an individual polymer molecule to spread out over the entire volume of the …
PEO/CHCl3. Crystallinity of the Polymer and Vapor Pressure of the Solvent. Equilibrium and Nonequilibrium Phenomena
2003
Vapor pressures were measured for the system CHCl3/PEO 1000 (PEO stands for poly(ethylene oxide) and 1000 for Mw in kg/mol) at 25 °C as a function of the weight fraction w of the polymer by means of a combination of headspace sampling and gas chromatography. The establishment of thermodynamic equilibria was assisted by employing thin polymer films. The degrees of crystallinity α of the pure PEO and of the solid polymer contained in the mixtures were determined via DSC. An analogous degree of polymer insolubility β was calculated from the vapor pressures measured in this composition range. The experiments demonstrate that both quantities and their concentration dependence are markedly affect…
Composition-dependent Flory-Huggins parameters: molecular weight influences at high concentrations
1995
Flory-Huggins interaction parameters X were determined by means of equilibrium vapor pressures (measured via a combination of a head-space sampler with a gas chromatograph) and light scattering as a function of composition and temperature for the systems cyclohexanone/polystyrene [CHO/PS] and cyclohexanone/poly(butyl methacrylate) [CHO/PBMA]. The investigation of molecular weight influences on X with the system CHO/PBMA demonstrates that they persist almost up to the pure polymer. In order to rationalize this result, it is postulated (in accord with experimental findings and theoretical predictions) that the dimensions of polymer chains may vary upon the addition of solvent even in highly c…