Search results for "Control theory"
showing 10 items of 1333 documents
On the optimal design of multi-stage cascaded transistor amplifiers with noise, gain and mismatch constraints
2007
The problem of evaluating the optimal performances of cascaded, unbalanced, multi-stage transistor amplifiers is addressed. In particular, a theoretically rigorous approach is proposed for the determination of a family of Optimal Design Curves (ODC's) which express the best noise-gain tradeoff that can be achieved - at each frequency and device operating condition - when a simultaneous constraint on amplifier input VSWR is accounted for. Such curves can be used as a more meaningful starting point in practical amplifier design in place of the approximate calculations so far employed for target performance or optimization goals determination.
On the Theoretical Limits of Noise-Gain-Mismatch Tradeoff in the Design of Multi-Stage Cascaded Transistor Amplifiers
2007
The problem of evaluating the limit performances of cascaded single-ended multi-stage transistor amplifiers is addressed. In particular, a theoretically rigorous approach is proposed for the determination of a family of optimal design curves (ODC's) which express the best (maximum optimal) noise-gain tradeoff that can be achieved - at each operating frequency - when a simultaneous constraint on amplifier input VSWR is accounted for.
Multiobjective design of distributed reactive power production in a deregulated electric market
2005
Abstract Reactive flows compensation optimal design for losses reduction in MV automated distribution systems is a problem deeply studied in literature. In this paper, the design problem is formulated considering the new deregulated energy market. These new operational conditions allow the MV grid operator to consider the generation of reactive energy also as a service that can be sold to the transmission system above. In this case, the transmission system would be helped in all the working conditions in which a strong modulation of the reactive flow through the HV/MV node is required. Then, for the MV grid operator, the compensation system optimal design problem is therefore that of the se…
Crowded comparison operators for constraints handling in NSGA-II for optimal design of the compensation system in electrical distribution networks
2006
This paper proposes an improvement of an efficient multiobjective optimization algorithm, Non-dominated Sorting Genetic Algorithm II, NSGA-II, that has been here applied to solve the problem of optimal capacitors placement in distribution systems. The studied improvement involves the Crowded Comparison Operator and modifies it in order to handle several constraints. The problem of optimal location and sizing of capacitor banks for losses reduction and voltage profile flattening in medium voltage (MV) automated distribution systems is a difficult combinatorial constrained optimization problem which is deeply studied in literature. In this paper, the efficiency of the proposed Crowded Compari…
Simplified analytical solution for the optimal design of Tuned Mass Damper Inerter for base isolated structures
2019
Abstract In this paper the use of the Tuned Mass Damper Inerter (TMDI) to control the response of base isolated structures under stochastic horizontal base acceleration is examined. Notably, the TMDI, recently introduced as a generalization of the classical Tuned Mass Damper, allows to achieve enhanced performance compared to the other passive vibration control devices. Thus, it represents an ideal alternative for reducing displacements of base isolated structures. To this aim, firstly a straightforward numerical approach is developed for the optimal design of this device considering a white noise base excitation. Further, a simplified analytical solution for the optimal design of TMDI para…
Optimal design of tuned liquid column damper inerter for vibration control
2022
Abstract In this paper, the use of a novel passive control device defined as Tuned Liquid Column Damper Inerter (TLCDI) is studied to control the seismic response of structural systems. The TLCDI, recently introduced as an enhanced version of the conventional Tuned Liquid Column Damper, may achieve improved seismic performances by exploiting the mass amplification effect of the so-called inerter device. For this purpose, an optimization procedure for the design of the TLCDI based on a statistical linearization technique and the minimization of the structural displacement variance is proposed. Notably, by assuming a white noise base excitation and considering some additional approximations, …
Optimal design of complex passive-damping systems for vibration control of large structures: An energy-to-peak approach
2014
Published version of an article in the journal: Abstract and Applied Analysis. Also available from the publisher at: http://dx.doi.org/10.1155/2014/510236 Open Access We present a new design strategy that makes it possible to synthesize decentralized output-feedback controllers by solving two successive optimization problems with linear matrix inequality (LMI) constraints. In the initial LMI optimization problem, two auxiliary elements are computed: a standard state-feedback controller, which can be taken as a reference in the performance assessment, and a matrix that facilitates a proper definition of the main LMI optimization problem. Next, by solving the second optimization problem, the …
Application of circuit theory for extraction of water from oil
2011
This paper discusses optimization of the performance of a pulsed dc electrostatic coalescer, a device that is used in the oil industry to increase the speed of separation of water from a water-in-oil emulsion. A previously found criterion for optimum performance, the charge hypothesis, is reviewed. Analysis by circuit theory shows that the performance may be improved through selecting an optimum switching frequency and duty ratio, improving the design of the pulse train generator, and making physical modifications to the coalescer apparatus. The addition of an external charging circuit is beneficial. Experiments on the modified system could contribute to a better understanding of the physic…
Multicopter UAV design optimization
2014
Designing and selecting hardware for a multirotor can be challenging in order to get the best flight performance out of the system. In addition to selecting the hardware, the number of actuators can also be altered. For a 4 actuator (quadrotor) setup, one set of hardware can give the optimal design, while for a 6 actuator setup (hexarotor) the same hardware may not necessarily give the same response. In this paper we present a design optimization process of a multirotor, where the hardware is selected from a set of low-cost off-the-shelf standard RC hobby parts. Constraining the problem to a given hardware ensures existence of the selected hardware, and the design can be implemented. Also t…
Optimal design of tuned liquid column dampers for seismic response control of base-isolated structures
2017
In this paper, the use of a tuned liquid column damper (TLCD) as a cost-effective means to control the seismic response of a base-isolated structure is studied. A straightforward direct approach for the optimal design of such a device is proposed, considering a white noise model of the base excitation. On this base, a direct optimization procedure of the TLCD design parameters is performed and optimal design charts are presented as a ready-to-use practical design tool. Comparison with the optimal parameters obtained considering a classical iterative statistical linearization technique proves the reliability of the proposed approach. The performance of the base-isolated TLCD-controlled struc…