Search results for "Conversion"

Excited-state absorption in erbium-doped silica fiber with simultaneous excitation at 977 and 1531 nm

2009

We report a study of the excited-state absorption (ESA) in erbium-doped silica fiber (EDF) pumped at 977 nm, when the fiber is simultaneously excited by signal radiation at 1531 nm. We show, both experimentally and theoretically, that ESA efficiency at 977 nm gets strongly enhanced only in the presence of signal power. Experimentally, this conclusion is supported through the detection of upconversion emission, a “fingerprint” of the ESA process, and through the measurements of the EDF nonlinear transmission coefficient for the pump wavelength, which is sensitive to the ESA value. It is shown that the experimental data are precisely modeled with an advanced five-level Er3+ model developed fo…

University of Palermo: Exploiting the Optical Quadratic Nonlinearity of Zinc-Blende Semiconductors for Guided-Wave Terahertz Generation: A Material C…

2012

Content synopsis of the following paper: Matteo Cherchi, Alberto Taormina, Alessandro C. Busacca, Roberto L. Oliveri, Saverio Bivona, Alfonso C. Cino, Salvatore Stivala, Stefano Riva Sanseverino, and Claudio Leone, "Exploiting the Optical Quadratic Nonlinearity of Zinc-Blende Semiconductors for Guided-Wave Terahertz Generation: A Material Comparison", IEEE Journal of Quantum Electronics, Vol. 46, N. 3, March 2010

Electrical and photovoltaic properties of indium‐tin‐oxide/p‐InSe/Au solar cells

1987

Conditions for efficiency improvement and optimization in indium‐tin‐oxide/p‐indium‐selenide solar cells are discussed in this paper. This aim is achieved by using low‐resistivity p‐indium‐selenide and by incorporating a back‐surface‐field contact. This contact is insured by a p‐indium selenide/gold barrier whose rectifying behavior is explained through the complex impurity structure of p‐indium‐selenide. Electrical and photovoltaic properties of the cells are also reported. The efficiency parameters under AM1 simulated conditions have been improved up to 32 mA/cm2 for the short‐circuit current density, 0.58 V for the open‐circuit voltage, and 0.63 for the filling factor. As a result, solar…

Generation of white LED light by frequency downconversion using a perylene-based dye

2012

A high efficiency white light emitting diode (LED) was fabricated by generation of frequency down-conversion from a GaN/InGaN blue LED. In place of conventional inorganic phosphors, a perylene-based dye was used for colour conversion. The resulting hybrid structure is analysed by focusing on the visual performance of the realised LEDs employing the most relevant photometric parameters of a light source. Preparation of the organic polymer is described as well. The thermal stability of the dye was investigated and a simple structure which avoids colour degradation is proposed.

A coupled lossy local-mode theory description of a plasmonic tip

2012

International audience; We investigate power propagation in a metal-coated tapered optical fiber. We analyze in detail the conversion from the fiber core guided mode to a surface plasmon polariton (SPP) confined at the tip apex. To this aim, we adapt coupled local-mode theory to include lossy modes. Two distinct regimes are identified. In the case of thin metal coating, a strong coupling regime occurs between a core guided mode and a SPP with good conversion efficiency. In the case of thick metal coating, a very weak coupling occurs. Finally, energy confinement and the role of Joule losses are discussed in the near-infrared and visible ranges. Moreover, the coupled equations derived for loc…

The use of two-diode substitute model in predicting the efficiency of PV conversion in low solar conditions

2017

The article presents theoretical foundations of a two-diode equivalent model of a photovoltaic cell/module (PV), together with calculation procedures. A physical interpretation of individual components of an equivalent model was presented. Its practical application in predicting efficiency of operation of various PV cells and modules in low insulation conditions was demonstrated. The obtained predictions were verified with the actual results of their operation in open space (outdoor). The practical suitability of the “model” in early detection of ageing phenomena, such as, for example, absorber degradation taking place in PV modules, was demonstrated. The article was prepared on the basis o…

Application of the reduced I-V Blaesser’s characteristics in predicting PV modules and cells conversion efficiency in medium and high insolation cond…

2017

The article presents theoretical foundations of application of the reduced I-V Blaesser’s characteristics in predicting a photovoltaic cell/module (PV) efficiency, together with calculation procedures. A detailed analysis of the error of this transformation method of characteristics was carried out. Its practical application in predicting efficiency of operation of various PV cells and modules in medium and high insulation conditions was demonstrated. The practical suitability of the presented method in early detection of ageing phenomena, such as, for example, absorber degradation taking place in PV modules, was demonstrated. The article was prepared on the basis of the results of testing …

The payment of the poll-tax and the lowering of the Christian presence in palestinian countryside

2013

GRAd-COV2, a gorilla adenovirus based candidate vaccine against COVID-19, is safe and immunogenic in young and older adults

2021

AbstractSafe and effective vaccines against coronavirus disease 2019 (COVID-19) are urgently needed to control the ongoing pandemic. Although impressive progress has been made with several COVID-19 vaccines already approved, it is clear that those developed so far cannot meet the global vaccine demand. We have developed a COVID-19 vaccine based on a replication-defective gorilla adenovirus expressing the stabilized pre-fusion SARS-CoV-2 Spike protein, named GRAd-COV2. We aimed to assess the safety and immunogenicity of a single-dose regimen of this vaccine in healthy younger and older adults to select the appropriate dose for each age group. To this purpose, a phase 1, dose-escalation, open…

A combination vaccine against measles, mumps, rubella and varicella.

2008

A new combination vaccine against measles, mumps, rubella and varicella (MMRV) from GlaxoSmithKline Biologicals has recently been approved in Europe. It combines the components from two well-established, live, attenuated vaccines against measles, mumps and rubella. This review presents a summary of the development of this MMRV vaccine from published clinical studies. Seroconversion rates and antibody titers after the first and second dose are similar to those observed after concomitant administration of the MMR and varicella vaccines. Furthermore, the clinical profile of this combination vaccine, in terms of injection- site and general tolerability, is similar to that of the component vacci…