Search results for "Converter"
showing 10 items of 275 documents
Design of an efficient digital down-converter for a SDR-based DVB-S receiver
2007
This paper presents the design of an area-power efficient digital down-converter suitable for broadband communication systems. The DVB-S standard has been used as a design example. It has been shown that by selecting a bandpass sampling to generate only one spectral image, the case in which the relationship between the digital carrier frequency and the sampling frequency is 1/4, not only gives the smallest area but the lowest power consumption.
A novel method for harmonic mitigation for single-phase five-level cascaded H-Bridge inverter
2018
The efficiency of a system is a very important parameter for high power electrical drives applications. Moreover, the efficiency of power converters plays a fundamental role. Aim of this work, is to propose a novel selective harmonic mitigation method without solving non-linear equations. Through a very simple approach, the polynomial equations which drive the control angles have been detected for a single-phase five-level cascaded H-Bridge inverter. The obtained polynomial equations can be easily implemented in a digital system to real-time operation. The paper also presents the simulation analysis and experimental validation.
Nonlinear Robust Control of a Quadratic Boost Converter in a Wide Operation Range, Based on Extended Linearization Method
2022
This paper proposes a control system for a quadratic boost DC/DC converter in a wide range of operations, based on an inner loop with a sliding mode controller, for reaching a desired equilibrium state, and an outer loop with integral-type controller, for assuring robustness against load and input voltage variations and converter parameter uncertainties. The sliding mode controller is designed with the extended linearization method and assures local asymptotic stability, whereas the integral controller is designed using classical frequency methods, and assures input–output stability. It is shown that the proposed controller also deals with the sudden changes in the nominal operating conditi…
Continuous Monitoring of Parasitic Elements in Boost Converter Circuit
2021
The given paper explains the necessity of condition monitoring for DC/DC boost converter circuit. Further, an analytical model of circuit parasitic estimation is presented based on measured quantities in the circuit. The implementation of continuous estimation of circuit parasitic elements is analytically explained and verified by simulations and experimental results. Obtained results are acceptable for condition monitoring.
A Novel Symmetrical Boost Modulation Method for qZS-based CHB Inverters
2020
Quasi-Z-source cascaded H-bridge (qZS-CHB) inverters are arising as an innovation in the field of the electrical conversion for PV applications. This type of converters inherit the advantages of multilevel inverters and single-stage configuration. In this context, this paper proposes a novel symmetrical boost modulation strategy for qZS CHB multilevel inverters to increase the performance in terms of voltage stresses and power quality. The novelty lies in the adoption of a different concept to generate the shoot-through states compared to the traditional methods. Simulation analysis in a grid connected application to evaluate the benefits of this boost method is performed in the MATLAB/PLEC…
Experimental Prototyping of a Microgrid with Mechanical Point of Common Coupling
2020
The smartgrid is a key technology for the sustainable and smart utilization of the renewable energies. In this paper, a prototyping of a microgrid, assembled at the Sustainable Development and Energy Saving Laboratory (SDESLAB) of the University of Palermo, is presented and discussed. In detail, the microgrid presents only one mechanical point of common coupling (PCC) with the main grid and it is electrically separated from the main grid. In this way, the voltage variations of the main grid do not affect the microgrid electric quantities behavior. In order to validate the effectiveness of the voltage and frequency control, several experimental tests and analysis have been carried out. In de…
Adaptive tuning system and parameter estimation of a digitally controlled boost converter with STM32
2019
. This paper proposes a diagnostic system of a power electronic converter, based on a cheap STM32 Nucleo board, aiming to extract some relevant measurements which gives back important values of the converter's parameters behavior. Moreover the designed system is also exploited for implementing the converter's auto tuning in order to optimize its dynamic performance.
Selective Harmonic Elimination in a 5-Level Single Phase Converter with FPGA Based Controller
2018
Multilevel converters are becoming popular in high-power applications such as motor drives, renewable energy systems and distribution systems. Among all modulation techniques, selective harmonic elimination methods offer high quality voltage waveforms with operations at low switching frequency, hence, they are especially suitable for high-power applications. In this paper, a new analytical expression for the SHE problem formulated for a five-level converter is introduced, which is able to calculate the exact value of the switching angles. After a mathematical description of the proposed approach, this manuscript reports simulation and experimental results and analysis showing achievable res…
A Measurement System for Power Inductors in Non-Linear Operating Conditions
2021
The exploitation of power inductors in switching converters outside the linear region requires detailed information on the magnetization curve that often is not included among those usually available on their datasheets. This paper proposes an automatic system in which the inductor is characterized in real operating conditions taking into account also the core temperature. It is based on a switching converter suitably controlled by a virtual instrument. The system was tested by retrieving the inductance vs current curves of two commercial inductors for core temperatures up to 105°C, showing the different behaviors of the magnetization curves. Results are coherent with data given by manufact…
Comparative Analysis of Modified Modulation Scheme for Three-phase Voltage fed QZS Inverters
2019
Single-stage converters are one promising solution in different field of applications. In particular, quasi-Z-Source VSI topology structure playsan important role because it presents the same advantages of VSI and qZS converters. In addition, it allows increasing the inverter reliability. Moreover, modulation schemes and control strategy are still being developed. For this reason, aim of this paper is to introduce a modified modulation scheme based on the Maximum Constant Boost Control (MCBC) concept and Switching Frequency Optimal (SFO)as reference signals that represents the novelty issue of this work. The analysis has been carried out by comparing the performance of the converter in term…