Search results for "Copper oxide"
showing 10 items of 15 documents
Sintering of copper nanopowders under hydrogen: an in situ X-ray diffraction analysis.
2003
Abstract The reduction by hydrogen gas of the cuprite layer on copper nanocrystals and the subsequent sintering of the nano-particles were studied using in-situ X-ray diffraction and dilatometry. Spherical nanocrystals produced by evaporation and condensation have an average size of 35 nm, exhibiting a large surface curvature. Each nanoparticle is coated with a 3.5 nm layer of Cu 2 O, which is rough and disordered, as revealed by high-resolution electron microscopy. Reduction by hydrogen of this curved cuprite layer occurs at 363 K, which is ≈65 K lower than is observed on a layer supported by micrometer-sized or bulk copper with a flat surface. The reduction process and its effect on the s…
Effect of current on the sintering of pre-oxidized copper powders by SPS
2017
Abstract As mentioned in the literature, SPS (Spark Plasma Sintering) technology combines uniaxial charge and pulsed currents to achieve the rapid sintering of powders. Although the utilization of current is often reported, an understanding of its role in the sintering mechanisms is still a subject of controversy. In fact, the oxide layer around metal particles is sometimes considered to be a dielectric gap in which discharges may occur: these discharges can clean the surface of particles and enhance densification. In this paper, an oxide layer was grown on the particle surface of a copper powder, and the growth enabled the study of the role of current on such dielectric layers. The powders…
Phase and structural transformations in annealed copper coatings in relation to oxide whisker growth
2015
Abstract We describe structural and phase transformation in copper coatings made of microparticles during heating and annealing in air in the temperature range up to 400 °C. Such thermal treatment is accompanied by intensive CuO nanowhisker growth on the coating surface and the formation of the layered oxide phases (Cu 2 O and CuO) in the coating interior. X-ray diffraction and focused ion beam (FIB) are employed to characterize the multilayer structure of annealed copper coatings. Formation of volumetric defects such as voids and cracks in the coating is demonstrated.
Segregation of copper oxide on calcium copper titanate surface induced by Graphene Oxide for Water splitting applications
2020
Abstract Photoelectrochemical cells (PEC) are promising devices for hydrogen production via sunlight energy. One of the important challenges in this area is to design photoactive electrodes able to absorb visible light. A good photoelectrochemical behavior depends on the presence of surface active sites to photogenerate current at the lower possible potential for water splitting. Recent investigations in this field are focusing on perovskite materials such as CaCu3Ti4O12 (CCTO) as visible light active electrode due its outstanding structure in which CCTO encloses in its structure a visible light absorbance component (CuO). The presence CuO on the material surface is mainly responsible for t…
Template electrosynthesis of aligned Cu2O nanowires
2008
Abstract Large arrays of aligned copper oxide nanowires were produced by electrodeposition, using anodic alumina membranes as template. We have studied the effect of two fundamental parameters involved in fabrication process: potential perturbation and bath composition. Performing electrodeposition from a copper acetate/sodium acetate bath (pH 6.5), we found that chemical composition of nanowires varied in dependence on the shape of the applied potential perturbation: pure copper oxide nanowires were produced by pulsed potential, whilst continuous electrodeposition resulted in a co-deposition of Cu and Cu 2 O. In a copper lactate bath, buffered at pH 10, the shape of perturbation did not in…
Grafting and characterization of dodecylphosphonic acid on copper: Macro-tribological behavior and surface properties
2013
International audience; Thin film of n-dodecylphosphonic acid (DDPA) was prepared on a copper oxide substrate via a molecular self-assembly process. The composition, structure, organization, surface energy, morphology, and electrochemical behavior of the DDPA filmwere characterized bymeans of X-ray photoelectron spectroscopic analysis (XPS), polarization modulation infrared reflection absorption spectroscopy (PM-IRRAS), contact angle measurement v(CAM), microscopic observations, and electrochemistry. The friction behavior of the DDPA film adsorbed on copper oxide substrate sliding against a Si3N4 ball was examined on a linear reciprocating tribological tester. Worn surfaces of the DDPA film…
Influence of Pressure and Temperature on X-Ray Induced Photoreduction of Nanocrystalline CuO
2018
The authors are grateful to Prof. Alain Polian for providing NDAC cell. Parts of the present research have been carried out at the ODE beamline at SOLEIL.
Synchrotron Radiation-Based Micro-XANES and Micro-XRF Study of Unsuccessfully Produced Egyptian Blue from the Late Hellenistic Production Site of Kos…
2021
International audience; This paper examines the production technology of Egyptian blue, an ancient artificial pigment, through the investigation of an unsuccessfully produced pellet derived from the Hellenistic production site of Kos (Dodecanese, Greece). This heterogeneous material was investigated by a combination of laboratory and synchrotron radiation-based (SR) techniques: scanning electron microscopy coupled with energy-dispersive Xray spectrometry, micro-Raman spectroscopy, high-resolution SR micro-X-ray fluorescence spectroscopy, and SR micro-X-ray absorption near-edge structure spectroscopy (XANES), at the ID21 beamline of the European Synchrotron Radiation Facility. Principal comp…
A field induced ferromagnetic-like transition below 2.8 K in Li2CuO2: An experimental and theoretical study
1998
The low temperature magnetic properties of the Li2CuO2 compound have been investigated by means of superconducting quantum interference device magnetometry. We find in addition to an antiferromagnetic phase below 9.5 K a ferromagnetic-like steep rise of the magnetization around 2.8 K. The observed low temperature behavior is discussed by considering second and fourth order magnetocrystalline effective anisotropy coefficients, in addition to the exchange couplings reported in the literature. Work at the Institut de Ciencia dels Materials was supported by the Spanish Comisión Interministerial de Ciencia y Technología Grant No. CICYT MAT 96-1037.
Gas-phase hydrogenation of propionitrile on copper-lanthanide oxides
2009
Abstract The hydrogenation of propionitrile on copper-lanthanide oxide catalysts (2Cu·CeO 2 and 4Cu·Ln 2 O 3 (Ln = La, Pr, Nd)) was studied in the gas phase. The activity of the catalysts varies with the lanthanide in the order 2Cu·CeO 2 > 4Cu·Pr 2 O 3 > 4Cu·La 2 O 3 ≥ 4Cu·Nd 2 O 3 , while the activation energies varies in the opposite order, except for 2Cu·CeO 2 . The main product was the primary amine, n -propylamine. The formation of the unstable imine CH 3 CH 2 N CHCH 3 as a major product over 2Cu·CeO 2 seems to be consistent with the acidity of the catalyst. The catalysts were more selective than conventional copper impregnation catalysts, Cu (10 wt.%) on SiO 2 , La 2 O 3 or CeO 2 ,…