Search results for "Data acquisition"
showing 10 items of 237 documents
Impact of physicians’ participation in non-interventional post-marketing studies on their prescription habits: A retrospective 2-armed cohort study i…
2020
Background Non-interventional post-marketing studies (NIPMSs) sponsored by pharmaceutical companies are controversial because, while they are theoretically useful instruments for pharmacovigilance, some authors have hypothesized that they are merely marketing instruments used to influence physicians’ prescription behavior. So far, it has not been shown, to our knowledge, whether NIPMSs actually do have an influence on prescription behavior. The objective of this study was therefore to investigate whether physicians’ participation in NIPMSs initiated by pharmaceutical companies has an impact on their prescription behavior. In addition, we wanted to analyze whether specific characteristics of…
A Patient Registry to Improve Patient Safety: Recording General Neurosurgery Complications
2016
Background To improve the transparency of the local health care system, treatment cost was recently referenced to disease related groups. Treatment quality must be legally documented in a patient registry, in particular for the highly specialized treatments provided by neurosurgery departments. Methods In 2013 we have installed a patient registry focused on cranial neurosurgery. Surgeries are characterized by indication, treatment, location and other specific neurosurgical parameters. Preoperative state and postoperative outcome are recorded prospectively using neurological and sociological scales. Complications are graded by their severity in a therapy-oriented complication score system (C…
Real-time acquisition of wideband signals data using non-uniform sampling
2009
Wideband signal acquisition often faces a problem of bulk data recording. It is a critical factor in real-time systems. The paper discusses an approach that deals with this problem incorporating Digital Alias-free Signal Processing and Virtual Instrumentation technologies. Such combination is advantageous for real-time applications and useful in the development of measurement and software defined radio systems. Non-uniform sampling technique allows considerably decrease the data of wideband signals so, that they can be transferred in real-time to a typical PC through high-speed PCI Express communication interface. The experimental prototype system has been developed and obtained results are…
Cycle-triggered averaging of respiration-related neuronal activity
1985
Abstract A computer system is presented which provides off-line computation of cycle-triggered histograms (CTH) of respiration-related neuronal activity. Binwidths of the histograms are freely selectable by software from 10 ms to 100 ms. For special evaluation purposes. CTHs can be standardized in different ways concerning cycle duration as well as amplitude. Time incidence of maximum frequency, center of gravity and expiration-to-inspiration phase transition within the respiratory cycle are computed. The system employs special hardware interfaces to an 8-bit microcomputer which are briefly described. Data acquisition, data manipulation and output handling of the results are performed by ch…
Affine compensation of illumination in hyperspectral remote sensing images
2009
A problem when working with optical satellite or airborne images is the need to compensate for changes in the illumination conditions at the time of acquisition. This is particularly critical when working with time series of data. Atmospheric correction strategies based on radiative transfer codes may provide a rigorous solution but it may not be the best solution for situations where a huge amount of hyperspectral images may need to be processed and computational time is a critical factor. The GMES (”Global Monitoring for Environment and Security”) initiative has promoted the creation of a new generation of satellites (the SENTINEL series) with ”ultra-high resolution” and ”superspectral im…
Management and Control of the Read Out Processors (tpps) of the Aleph Time Projection Chamber
1989
The readout of the Aleph time projection chamber (TPC) relies on a set of 72 time projection processors (TPPs), which are based on a Motorola 68020 microprocessor running a real-time operating system. The advanced processing capabilities of the TPPs allow them to perform in parallel a number of tasks, both during and outside of data acquisition, which are outlined. The management and control of such a large number of intelligent devices is presented. The discussion covers the hardware configuration of the TPPs; the software running the TPPs; their management, status, and control; exception handling and message logging; and the TPP monitoring tasks. >
The NA48 event-building PC farm
2003
The NA48 experiment at the CERN SPS aims to measure the parameter $\Re(\epsilon'/ \epsilon)$ of direct CP violation in the neutral kaon system with an accuracy of $2 \times 10^{-4}$. Based on the requirements of: \\\\ * high event rates (up to 10 kHz) with negligible dead time;\\ * support for a variety of detectors with very wide variation in the number of readout channels;\\ * data rates of up to 150 MByte/s sustained over the beam burst;\\ * level-3 filtering and remote data logging in the CERN computer center; \\\\ the collaboration has designed and built a modular pipelined data flow system with 40 MHz sampling rate. The architecture combines custom-designed components with commerciall…
Development of the Optical Multiplexer Board Prototype for Data Acquisition in the TileCal System
2006
This paper describes the development of the optical multiplexer board (OMB), also known as PreROD board, for the TileCal readout system in the ATLAS experiment. The aim of this board is to overcome the problems that may arise in the integrity of data due to radiation effects. The solution adopted has been to add redundancy to data transmission and so two optical fibers with the same data come out from the detector front end boards. The OMB has to decide in real time which fiber, eventually, carries data with no errors switching it to the output link connected to the read out driver (ROD) motherboard where data processing takes place. Besides, the board may be also used as a data injector fo…
Auto-Adaptive Trigger and Pulse Extraction for Digital Processing in Nuclear Instrumentation
2015
International audience; This paper presents a novel auto-adaptive method for pulse triggering and extraction. Pulse triggering uses a threshold that must be placed as close as possible to the noise level. We do this by means of an adaptive threshold level based on real-time noise level estimation. A dynamic estimation of the pulse length is also used for pulse selection. The proposed approach is largely insensitive to noise and enables autonomous extraction of pulses regardless of their shape, height or length. The proposed approach can be used with numerous types of detectors from an analog-to-digital converter, and can be used in conjunction with various pulse processing techniques such a…
A Portable Readout System for Microstrip Silicon Sensors (ALIBAVA)
2009
A readout system for microstrip silicon sensors has been developed. This system is able to measure the collected charge in one or two microstrip silicon sensors by reading out all the channels of the sensor(s), up to 256. The system can operate either with non-irradiated and irradiated sensors as well as with n-type and p-type microstrip silicon sensors. Heavily irradiated sensors will be used at the Super Large Hadron Collider, so this system can be used to research the performance of microstrip silicon sensors in conditions as similar as possible to the Super Large Hadron Collider operating conditions. The system has two main parts: a hardware part and a software part. The hardware part a…