Search results for "Deflection"

Output-feedback-based H∞ control for vehicle suspension systems with control delay

2014

This paper deals with the problem of output-feedback H∞ control for a class of active quarter-car suspension systems with control delay. The dynamic system of the suspension systems is first formed in terms of the control objectives, i.e., ride comfort, road holding, suspension deflection, and maximum actuator control force. Then, the objective is to the design of the dynamic output-feedback H∞ controller in order to ensure asymptotic stability of the closed-loop system with H∞ disturbance attenuation level and the output constraints. Furthermore, using Lyapunov theory and linear matrix inequality (LMI) approach, the existence of admissible controllers is formulated in terms of LMIs. With t…

Stress transfer and failure mechanisms in steel-concrete trussed beams: Experimental investigation on slab-thick and full-thick beams

2018

Abstract This study presents the results of an experimental investigation on semi-precast Hybrid Steel Trussed-Concrete Beams (HSTCBs) for analyzing the failure modes and the stress transfer mechanism between concrete and embedded steel elements (plate and truss). The available literature presents previous studies carried out by the authors mainly focused on the understanding of the local transfer mechanism by means of push-out tests. Conversely, in this paper original the results of laboratory tests conducted on six specimens of full-size HSTCBs subjected to four-point bending, with variation in the shear span, are reported on. From these results, the authors are able to assess the failure…

Risk of failure in existing RC balcony and strength verification under degradation phenomena

2020

Abstract In the present paper, the safety conditions of reinforced concrete (RC) balconies subject to degradation phenomena caused by carbonation, presence of chlorides or water infiltration were examined. After a brief review of the typical damages of balconies occurring with detachments of plaster and bricks expulsion, some cases of collapses of balconies recently occurred were presented. Therefore, a calculation model was proposed for a hand verification of the flexural and shear strength of existing corroded T beams cast in place of lightened RC orthotropic slabs forming the balcony and for the calculus of deflection including slippage of steel bars. Diffused and pitting corrosion on st…

Resolving Point Defects in the Hydration Structure of Calcite (10.4) with Three-Dimensional Atomic Force Microscopy

2018

It seems natural to assume that defects at mineral surfaces critically influence interfacial processes such as the dissolution and growth of minerals in water. The experimental verification of this claim, however, is challenging and requires real-space methods with utmost spatial resolution, such as atomic force microscopy (AFM). While defects at mineral-water interfaces have been resolved in 2D AFM images before, the perturbation of the surrounding hydration structure has not yet been analyzed experimentally. In this Letter, we demonstrate that point defects on the most stable and naturally abundant calcite (10.4) surface can be resolved using high-resolution 3D AFM-even within the fifth h…

Formulation and validation of a reduced order model of 2D materials exhibiting a two-phase microstructure as applied to graphene oxide

2018

Abstract Novel 2D materials, e.g., graphene oxide (GO), are attractive building blocks in the design of advanced materials due to their reactive chemistry, which can enhance interfacial interactions while providing good in-plane mechanical properties. Recent studies have hypothesized that the randomly distributed two-phase microstructure of GO, which arises due to its oxidized chemistry, leads to differences in nano- vs meso‑scale mechanical responses. However, this effect has not been carefully studied using molecular dynamics due to computational limitations. Herein, a continuum mechanics model, formulated based on density functional based tight binding (DFTB) constitutive results for GO …

Extra tension at electrode-nanowire adhesive contacts in nano-electromechanical devices

2017

Abstract We report a strong tangential component of the reaction force at electrode to nanowire adhesive contact which was previously established using electrostatic attraction. The reaction force tangential component absolute value was found to be comparable to or even bigger than the corresponding normal component. This effect is important for understanding of the mechanics of nano-electromechanical devices. Both the experiment and the corresponding theory are presented. Fitting of the obtained analytical solutions to experimental data was used to measure the reaction force acting at the contact for several nanowire-electrode configurations.

Large deflection of magneto-electro-elastic laminated plates

2014

Abstract A model for the large deflection analysis of magneto-electro-elastic laminated plates is derived. The first order shear deformation theory and the von Karman stress function approach are employed. A set of resolving partial differential equations involving kinematical variables and the stress function is obtained as a consequence of the preliminary condensation of the electro-magnetic state to the plate kinematics. A closed form solution for simply-supported plates is presented. Numerical results are carried out for plates consisting of piezoelectric BaTiO 3 and piezomagnetic CoFe 2 O 4 layers. These results show the influence of large deflections on the plate response and could be…

Semiflexible Polymers in the Bulk and Confined by Planar Walls

2016

Semiflexible polymers in solution under good solvent conditions can undergo an isotropic-nematic transition. This transition is reminiscent of the well-known entropically-driven transition of hard rods described by Onsager’s theory, but the flexibility of the macromolecules causes specific differences in behavior, such as anomalous long wavelength fluctuations in the ordered phase, which can be understood by the concept of the deflection length. A brief review of the recent progress in the understanding of these problems is given, summarizing results obtained by large-scale molecular dynamics simulations and density functional theory. These results include also the interaction of semiflexib…

2019

In this study, the structural behavior of small-scale wood beams externally strengthened with various fiber strengthened polymer (FRP) composites (i.e., flax FRP (FFRP), basalt FRP (BFRP), E-glass FRP (“E” stands for electrical resistance, GFRP) and their hybrid FRP composites (HFRP) with different fiber configurations) were investigated. FRP strengthened wood specimens were tested under bending and the effects of different fiber materials, thicknesses and the layer arrangements of the FRP on the flexural behavior of strengthened wood beams were discussed. The beams strengthened with flax FRP showed a higher flexural loading capacity in comparison to the beams with basalt FRP. Flax FRP prov…

Flexural vibrations of discontinuous layered elastically bonded beams

2018

Abstract This paper addresses the dynamic flexural behavior of layered elastically bonded beams carrying an arbitrary number of elastic translational supports and rotational joints. The beams are referred to as discontinuous for the discontinuities of response variables at the application points of supports/joints. The Euler-Bernoulli hypothesis is assumed to hold for each layer separately, and a linear constitutive relation between the horizontal interlayer slip and the interlaminar shear force is considered. Based on the theory of generalized functions to handle the discontinuities of response variables due to supports/joints, exact beam modes are obtained from a characteristic equation b…