Search results for "Detection limit"
showing 10 items of 810 documents
Selective determination of ammonium in water based on HPLC and chemiluminescence detection
2005
Abstract A selective and sensitive method has been developed for liquid chromatographic determination of ammonium in water samples. The analyte is derivatized with Dansyl Chloride prior to injection into HPLC. Optimal solution derivatization conditions have been established. The dansyl derivative is separated with the aid of a chromatographic column and post-column mixed with peroxyoxalate (TCPO) and H 2 O 2 in order to perform chemiluminescence detection. The detection limit achieved is 8 μg/L and linear response from 0.027 to 0.750 mg/L of ammonium was obtained. Ammonium ion was determined within 2.4 min under optimum chromatographic conditions. The method is fast, and near 10 derivatized…
Use of micellar mobile phases for the chromatographic determination of clorazepate, diazepam, and diltiazem in pharmaceuticals
2001
An ODS-2 column, a micellar mobile phase of high elution strength containing 0.1M sodium dodecyl sulfate and 3% (v/v) butanol, and ultraviolet detection at 230 nm are used for the determination of either of two benzodiazepines (clorazepate and diazepam) and a benzothiazepine (diltiazem) in pharmaceuticals. The procedure is shown to be competitive against conventional chromatography with methanol-water mobile phases, especially for diltiazem. The composition of the micellar mobile phase is selected using a predictive strategy based on an accurate retention model and assisted by computer simulation. Calibration graphs are linear at least in the 2.5 to 20 microg/mL, 4 to 20 microg/mL, and 5 to…
Evaluation of working air quality by using semipermeable membrane devices
2008
Abstract It has been evaluated the use of semipermeable membrane devices (SPMDs) as passive samplers of organophosphorus pesticides from air, in order to determine the contamination of working environments. Additionally, the use of SPMDs as portable samplers has been also considered. The analytical methodology for the determination of diazinon, chlorpyrifos-methyl, pirimiphos-methyl, chlorpyrifos and fenthion in SPMDs exposed to contaminated air was based on microwave-assisted extraction and gas chromatography with mass spectrometry determination. Limit of detection (LOD) values from 2 to 4 ng SPMD−1 and repeatability from 2 to 7% were obtained by using the aforementioned methodology. Theor…
A rapid and sensitive gas chromatography-mass spectrometry method for the quality control of perfumes: simultaneous determination of phthalates
2013
A rapid and sensitive analytical gas chromatography-mass spectrometry (GC-MS) method for perfume analysis to determine the phthalates banned by the European Union Regulation on cosmetic samples is presented. This method has been tested in commercial alcoholic perfume samples for the determination of the following seven phthalates: dibutyl phthalate, bis(2-ethylhexyl) phthalate, bis(2-methoxyethyl) phthalate, n-pentyl-isopentylphthalate, di-n-pentyl phthalate, diisopentylphthalate and benzyl butyl phthalate. Sample evaporation and redissolution in ethanol is carried out before GC-MS analysis, with no dilution of the sample. External calibration and standard addition calibration are compared …
Improved detection limit for ammonium/ammonia achieved by Berthelot's reaction by use of solid-phase extraction coupled to diffuse reflectance spectr…
2005
Abstract The proposed procedure is based on the extraction of the indothylmol blue into C 18 solid-phase extraction (SPE) membranes and direct quantification on the membrane surface by diffuse reflectance spectroscopy. The analytical performance of the proposed method has been evaluated for standard solutions of ammonium using reflectance values, R , as well as the Kubelka–Munk function, F ( R ). The results have been compared with those obtained by the conventional method, which uses UV–vis absorption spectroscopy with a sensor-based method. The described methodology provided satisfactory linearity and reproducibility within the ammonium concentration intervals 25–250 μg L −1 and 25–500 μg…
Determination of arsenic and antimony in milk by hydride generation atomic fluorescence spectrometry
2002
Abstract A highly sensitive procedure has been developed for total arsenic and antimony determination in milk samples by hydride generation atomic fluorescence spectrometry after microwave-assisted sample digestion. The discrete introduction of 2 ml of digested sample in the automated continuous flow hydride generation system allows us to reduce drastically the sample and HCl consume and to determine several elements from a same sample digestion. The method provides detection limits of 0.006 and 0.003 ng ml−1, a sensitivity of 2390 and 2840 fluorescence units per ng ml−1 for As and Sb respectively, and average relative standard deviation of 2.3% for As and 4.8% for Sb. The analysis of cow m…
On-line solvent recycling: a tool for the development of clean analytical chemistry in flow injection Fourier transform infrared spectrometry. Determ…
1998
Abstract A flow injection strategy has been developed for the direct determination of ketoprofen in pharmaceuticals by Fourier transform infrared spectrometry also incorporating a distillation unit which allows the carbon tetrachloride employed to dissolve samples and standards and used as a carrier to be recovered on-line. The system developed permits a drastic reduction of reagent consumption and easy and fast sampling and cleaning of the measurement cell. For the quantification of ketoprofen in pharmaceuticals the carbonyl bands at 1712 and 1666 cm −1 were employed and the developed method provided a 3 σ limit of detection of 0.04 mg ml −1 , a dynamic range up to 10 mg ml −1 and typical …
Chromium speciation using activated alumina microcolumns and sequential injection analysis-flame atomic absorption spectrometry
2001
Abstract A new procedure has been developed for chromium speciation in water by sequential injection analysis and flame atomic absorption spectrometry. The method involves the online retention of Cr(VI) anionic species and Cr(III) cationic species on alumina microcolumns, prepared by packing activated alumina in polytetrafluoroethylene tubes, followed by selective elution of Cr(VI) with 2 mol l −1 NH 4 OH and of Cr(III) with 0.2 mol l −1 HNO 3 . Studies were carried out on the effect of retention and elution conditions for both Cr species. The limit of detection values, established as the concentration corresponding to three times the standard deviation of blank measurements divided by the …
Determination of N-nitrosodiethanolamine in cosmetic products by reversed-phase dispersive liquid-liquid microextraction followed by liquid chromatog…
2016
A new analytical method for the determination of N-nitrosodiethanolamine (NDELA), a very harmful compound not allowed in cosmetic products, is presented. The method is based on a new approach of dispersive liquid-liquid microextraction (DLLME) useful for extraction of highly polar compounds, called reversed-phase DLLME (RP-DLLME), followed by liquid chromatography-ultraviolet/visible (LC-UV/Vis) determination. The variables involved in the RP-DLLME process were studied to provide the best enrichment factors. Under the optimized conditions, a mixture of 750µL of acetone (disperser solvent) and 125µL of water (extraction solvent) was rapidly injected into 5mL of toluene sample solution. The e…
Preconcentration and dansylation of aliphatic amines using C18 solid-phase packings
2002
Abstract Precolumn preconcentration and derivatization on solid sorbents (Bond Elut C18 solid-phase extraction cartridges) of low-molecular-mass aliphatic amines in water samples have been performed using dansyl chloride (Dns-Cl) as derivatization reagent. Conditions for analyte preconcentration and derivatization such as volume sample, reagent concentration, time, pH and temperature reaction were optimised. On the basis of these studies a rapid and sensitive method for screening of aliphatic amines in waters is presented. Up to volumes of 5 ml, samples are drawn through the sorbent, the analytes retained are dansylated at basic pH, at 100 °C for 10 min or 85 °C for 15 min. The derivatized …