Search results for "EPO"

A bizarre foreign body in the appendix: A case report.

2013

Foreign bodies are rare causes of appendicitis and, in most cases, ingested foreign bodies pass through the alimentary tract asymptomatically. However, ingested foreign bodies may sometimes remain silent within the appendix for many years without an inflammatory response. Despite the fact that cases of foreign-body-induced appendicitis have been documented, sharp and pointed objects are more likely to cause perforations and abscesses, and present more rapidly after ingestion. Various materials, such as needles and drill bits, as well as organic matter, such as seeds, have been implicated as causes of acute appendicitis. Clinical presentation can vary from hours to years. Blunt foreign bodie…

Pressure dependence of the optical properties of wurtzite and rock-salt Zn1–xCoxO thin films

2007

In this paper we investigate the electronic structure of Zn 1-x Co x O by means of optical absorption measurements under pressure. Thin films of Zn 1-x Co x O with different Co content (from 1 to 30%) were prepared by pulsed laser deposition on mica substrates. Absorption spectra exhibit three main features that are clearly correlated to the Co content in the films: (i) absorption peaks in the infrared associated to crystal-field-split internal transitions in the Co 3d shell, with very small pressure coefficients due to their atomic character; (ii) a broad absorption band below the fundamental edge associated to charge transfer transitions, that exhibit relatively large pressure coefficient…

Absorption kinetics and swelling stresses in hydrothermally aged epoxies investigated by photoelastic image analysis

2015

Abstract The present work proposes an experimental optical methodology able to measure the transient swelling stresses induced by the water uptake ageing of polymers. In particular, the work describes the implementation of a Photoelastic technique to quantify internal stresses arising during the hydrothermal ageing of cast epoxy samples. The material investigated is a model DGEBA/DDS epoxy system. Curing and post-curing cycles have been optimised in order to obtain a fully cured, high T g , and completely stress free initial condition. Rectangular beam samples were then left in a hydrothermal bath at 90 °C, and regularly monitored by gravimetric and photoelastic analyses. The quantitative e…

Basalt Fibre Composite with Carbon Nanomodified Epoxy Matrix under Hydrothermal Ageing

2021

This work aimed to investigate the effect of hybrid carbon nanofillers (e.g., carbon nanotubes/carbon nanofibers in the ratio 1:1 by mass) over the electrical and flexural properties for an epoxy matrix and corresponding basalt fibre reinforcing composite (BFRC) subjected to full-year seasonal water absorption. Hydrothermal ageing was performed by full immersion of the tested materials into distilled water according to the following model conditions (seasons). The mechanical properties were measured in three-point bending mode before environmental ageing and after each season. Upon environmental ageing, the relative change of flexural strength and elastic modulus of the epoxy and NC was wit…

Water absorption and hydrothermal ageing of epoxy adhesives reinforced with amino-functionalized graphene oxide nanoparticles

2021

Abstract The study is focused on quantitative characterization of water absorption and hydrothermal ageing effects in a room-temperature amine cured epoxy adhesive widely used in automotive, aerospace, construction, and marine industries. Amino-functionalized graphene oxide (mGO) nanoparticles were incorporated into the epoxy (up to 1.72 wt.%) enabled cross-linking reactions and providing high interfacial adhesion, superior reinforcement efficiency and enhanced resistance to hydrothermal ageing of nanocomposites. Anomalous water absorption accompanied by progressive weight loss of samples (down to 7%) is fitted by two-stage models considering additive and coupled contribution from water dif…

Hydrothermal Aging of an Epoxy Resin Filled with Carbon Nanofillers

2020

The effects of temperature and moisture on flexural and thermomechanical properties of neat and filled epoxy with both multiwall carbon nanotubes (CNT), carbon nanofibers (CNF), and their hybrid components were investigated. Two regimes of environmental aging were applied: Water absorption at 70 &deg

Vibrational analysis of Ni(II)- and Cu(II)-octamethylchlorin by polarized resonance Raman and Fourier transform infrared spectroscopy

2001

We measured the polarized resonance Raman spectra of Cu(II)-2,2,7,8,12,13,17,18-octamethylchlorin in CS2 at various excitation wavenumbers in a spectral region covering the Qy, Qx and Bx optical absorption bands. Additionally, we measured the FTIR-Raman spectrum of the highly overcrowded spectral region between 1300 and 1450 cm−1. The spectral decomposition was carried out by a self-consistent global fit to all spectra obtained. The thus identified Raman and IR lines were assigned by comparison with the resonance Raman spectra of Cu(II)-octaethylporphyrin, by utilizing their depolarization ratio dispersions and by a normal mode analysis. The latter was based on a modified transferable molec…

Ag11(SG)7 : A New Cluster Identified by Mass Spectrometry and Optical Spectroscopy

2014

We report a one-step and high yield synthesis of a red-luminescent silver cluster with the molecular formula, Ag11(SG)7 (SG: glutathionate) via reduction of silver ions by sodium borohydride in the presence of the tripeptide, glutathione (GSH). The as-prepared cluster shows prominent absorption features at 485 and 625 nm in its UV-vis absorption spectrum. Aging of the as-prepared cluster solution led to the disappearance of the 625 nm peak, followed by broadening of the 485 nm peak to give three maxima at ?487, 437, and 393 nm in its absorption spectrum. These peaks remain unchanged even after polyacrylamide gel electrophoresis (PAGE), where a single band was observed confirming high purity…

Fabrication and characterization of vacuum deposited fluorescein thin films

2011

Simple vacuum evaporation technique for deposition of dyes on various solid surfaces has been developed. The method is compatible with conventional solvent-free nanofabrication processing enabling fabrication of nanoscale optoelectronic devices. Thin films of fluorescein were deposited on glass, fluorine-tin-oxide (FTO) coated glass with and without atomically layer deposited (ALD) nanocrystalline 20 nm thick anatase TiO2 coating. Surface topology, absorption and emission spectra of the films depends on their thickness and the material of supporting substrate. On a smooth glass surface the dye initially formes islands before merging into a uniform layer after 5 to 10 monolayers. On FTO cove…

Puput, Abubilla (VER0000186)

Eurasian Hoopoe (Anglès), Huppe fasciée (Francès), Wiedehopf (Alemany) Gabinet de Vertebrats (Departament de Zoologia), Facultat de Ciències Biològiques (Campus de Burjassot), C/ Doctor Moliner, s/n, Bloque B. 5é plant, Burjassot (Valencia). Armari: 31-3 Cartagena Adulto