Search results for "Electric power system"
showing 10 items of 169 documents
Comparison of Nonactive Powers for the Detection of Dominant Harmonic Sources in Power Systems
2008
This paper deals with an innovative technique for the detection of disturbing loads in distorted power systems. The technique is a single-point strategy based on a comparison among different ldquononactiverdquo power quantities already proposed in the literature, which are measured at the same metering section. In this paper, the effectiveness of the strategy is discussed, which also considered the errors of the measurement transducers; the analysis is supported by simulation tests, which were carried out on both a simple single-phase system and an IEEE standard three-phase test power system. The latter was used by other authors as a benchmark system for the analysis of multipoint measureme…
An enhanced approach based on IEEE 1459 for the detection of disturbing loads in distorted and unbalanced three-phase power systems
2009
This paper presents an enhanced approach for the detection of disturbing loads in distorted and/or unbalanced three-phase power systems in both cases of three and four-wires. It is based on the IEEE Std. 1459-2000 effective apparent power resolution and it requires only the separation of the fundamental components of voltage and current from the remaining harmonic content. In the paper, the formulation of the novel approach is given and some simulation results are presented.
Disturbing loads identification in power systems: a single-point time-domain method based on IEEE 1459-2000
2009
This paper presents a single-point method for the identification of prevailing disturbing loads in power systems for both single-phase and three-phase applications downstream or upstream from the metering section. It is based on the simultaneous measurement of three nonactive power quantities, which are based on the IEEE Std. 1459-2000 approach. The proposed method is only based on the separation of the fundamental components from the harmonic content of voltage and current; thus, it does not require any spectral analysis of the voltages and current. In this paper, the formulation of the proposed method and its time-domain implementation are described; moreover, some simulation results are …
Wireless Power Transfer System Design for E-bikes Application
2019
The present work presents an analysis of Inductive Coupled Power Transfer (ICPT) Systems behaviour applied to electrical bikes. In particular, the study has focused on the design of the coupled coils of this system. In the first part of the work, the theoretical aspects of the wireless power system are handled. In the second part of the work, the inductive features of the coupled windings are analyzed. In order to perform this process, the Ansys Maxwell software has been used, performing 3D simulations. To conclude, the results of the simulations are compared.
Wireless power transfer system stability analysis for E-bikes application
2019
The present work reports the stability analysis of an Inductive Coupled Power Transfer (ICPT) System coupled to an electrical bike. The study has focused on two coupled coils with circular geometry and vertical disposition. In the first part of the work, the theoretical aspects related to the stability of wireless power systems are handled. In the second part, performing several simulations, varying the features of the considered configuration, the stability is looked for. In order to perform this process, the Ansys Maxwell software has been used, performing 3D simulations.
On the Impact of Heat Pumps Electric Load on the Power Consumption of Lampedusa
2020
The present paper reports the results of a simulation study regarding the impact of the adoption of heat pumps for domestic hot water production in the island of Lampedusa (Italy). In the study, it has been assumed to replace electric storage water heaters with heat pumps at every dwelling of the about four thousand domestic end-users of the island and, in addition, to control the heat pump operation in order to enhance some parameters that characterize the quality of the generation and distribution system of the island (power peak, energy losses and voltage drop). According to the results of the simulations, while the replacement of electric storage water heaters with heat pumps is able to…
A Power Sector in Transition Understanding Transition Towards a Cleaner Grid and how Distributed Energy Resources Affect the Design and Operation of …
2018
Important changes in the supply and the demand side of electricity apparatus are now underway, triggered by a combination of drivers dramatically affecting the transmission sector of power systems: greenhouse gas emissions, distributed generation, energy efficiency and the full integration of the European energy market. A variety of accelerating factors - including active consumer, aggregators, energy storage, e-vehicles, etc..- are creating a new era for the many stakeholders, incl. system operators, regional entities, industry and consumer organizations, producers or their trade bodies, Regulators, public decision makers and the society at large. Entraining this background, ENTSO-E and th…
EU transition in power sector
2019
Abstract In the past, much of Europe’s electricity grid network has been designed in consideration of the locations of conventional generation plants. However, a large share of today's renewables production – notably variable wind and solar – does not correspond to this grid architecture. Interconnectors, in addition to internal infrastructure, are key to creating new electricity corridors to connect areas of surplus to areas of scarcity. In this context, in 2014 the European Council, in recognizing that a fundamental role of transmission infrastructure is to enable the integration of areas of high renewable energy potential with main consumption areas, endorsed the proposal by the European…
Maximizing energy transfer and RES integration using dynamic thermal rating
2019
Abstract The production of electricity from wind and other renewable sources is rapidly increasing all over the world, causing significant changes in the management of electrical systems. The current structural asset is not adequate to manage this growing generation of energy. The hypothesis of construction of new power lines would mean taking into consideration economic, political and social problems. The following paper reports the experience gained by the Italian TSO, Terna S.p.A, on the use of the DTR (Dynamic Thermal Rating), which is able to dynamically calculate the real transport capacity of an overhead power line. The results obtained are encouraging as they show how it is possible…
Impact of non-programmable renewable sources in Day-Ahead Market in Sicily. Reasons to make more flexible and smarter the national transmission grid.
2014
This article describes technical and market aspects that characterize the Sicilian electrical system, the non-programmable renewable sources impacts on the energy markets (Day-Ahead Market and ancillary services market) and on Sicilian system operation, to evaluate the grid integration of renewable energy sources in a future Sicilian smart grid.