Search results for "Electrolysi"
showing 10 items of 110 documents
Electrochemical incineration of oxalic acid at boron doped diamond anodes: Role of operative parameters
2008
The electrochemical incineration of oxalic acid (OA) at boron doped diamond (BDD) anodes was investigated both theoretically and experimentally in order to find the influence of the operative parameters on the performances of the process. Polarization curves and chronoamperometric measurements indicate the probable occurrence of a direct electrochemical oxidation of OA at the surface of the BDD anode at low pH and of a hydroxyl radical-mediated reaction at high pH. When incineration electrolyses are performed at low pH with potentiostatic alimentation, a dramatic influence of the potential is observed. In amperostatic incineration, high CE are obtained when most part of the process was unde…
Highly selective generation of vanillin by anodic degradation of lignin: a combined approach of electrochemistry and product isolation by adsorption
2015
The oxidative degradation of lignin into a variety of valuable products has been under investigation since the first half of the last century. Especially, the chance to claim this cheap, abundant and renewable source for the production of the important aroma chemical vanillin (1) was one of the major driving forces of lignin research. So far most of the developed methods fail in technical application since no viable concept for work-up is included. This work represents a combined approach of electrochemical conversion of Kraft lignin and product recovery by adsorption on a strongly basic anion exchange resin. Electrolysis conditions are optimized regarding reaction temperatures below 100 °C…
Electrochemical reduction and carboxylation of halobenzophenones
2002
Abstract The electrochemical reduction of a series of halogenated benzophenones XC6H4COC6H4Y (1) was studied in aprotic solvents, in the absence and presence of CO2, by cyclic voltammetry (CV) and controlled-potential electrolysis. The mechanism of electroreduction in dimethylformamide (DMF) has been investigated in some detail. Most of the compounds undergo reductive carbonhalogen bond cleavage in the time window of CV. The radical anions derived from difluorobenzophenones (X=Y=4-F; X=2-F, Y=4-F) as well as from the 3-chloro derivative are quite stable with a cleavage rate constant (kc) of the order of 10−2 s−1 or less. With 4-chloro-, 2-chloro-, 4,4′-dichloro- and 2,4′-dichorobenzophen…
Experimental Test and Simulations on a Linear Generator-Based Prototype of a Wave Energy Conversion System Designed with a Reliability-Oriented Appro…
2017
In this paper, we propose a reliability-oriented design of a linear generator-based prototype of a wave energy conversion (WEC), useful for the production of hydrogen in a sheltered water area like Mediterranean Sea. The hydrogen production has been confirmed by a lot of experimental testing and simulations. The system design is aimed to enhance the robustness and reliability and is based on an analysis of the main WEC failures reported in literature. The results of this analysis led to some improvements that are applied to a WEC system prototype for hydrogen production and storage. The proposed WEC system includes the electrical linear generator, the power conversion system, and a sea-wate…
High-Performance Liquid Chromatographic Study on Oxidation Products of Lignin and Humic Substances
1991
We describe a convenient method of preparing samples and characterizing the mixture of degradation products obtained from alkaline cupric oxide oxidation of water samples containing lignin and humic substances. The method was applied to one unpolluted humic water sample and a total mill effluent of a kraft pulp mill. The fractions (Mr > 1000) obtained by ultrafi1tration were oxidized and the products (mixtures of degradation products) were analyzed by reversed-phase high-performance liquid chromatography (Spherisorb 5 ODS column). Acetonitrile-0.01 M phosphate buffer (pH 2) was used as the eluent in a gradient system and UV (set at 280 nm) as the detection system. Differences in the …
Study of the chlorfenvinphos pesticide removal under different anodic materials and different reactor configuration.
2021
The present manuscript focuses on the study of the electrochemical oxidation of the insecticide Chlorfenvinphos (CVP). The assays were carried out under galvanostatic conditions using boron-doped diamond (BDD) and low-cost tin dioxide doped with antimony (Sb-doped SnO2) as anodes. The influence of the operating variables, such as applied current density, presence or absence of a cation-exchange membrane and concentration of supporting electrolyte, was discussed. The results revealed that the higher applied current density the higher degradation and mineralization of the insecticide for both anodes. The presence of the membrane and the highest concentration of Na2SO4 studied (0.1 M) as a sup…
Electrochemical oxidation of organics in water: Role of operative parameters in the absence and in the presence of NaCl
2008
The electrochemical oxidation of organics in water was investigated theoretically and experimentally to determine the role of several operative parameters on the performances of the process in the presence and in the absence of sodium chloride. Theoretical considerations were used to design the experimental investigation and were confirmed by the results of the electrochemical oxidation of oxalic acid (OA) at boron doped diamond (BDD) or IrO(2)-Ta(2)O(5) (DSA-O(2)) anodes in a continuous batch recirculation reaction system equipped with a parallel plate undivided electrochemical cell. Polarization curves and chronoamperometric measurements indicated that, in the presence of chlorides, the a…
Electrocoagulation treatment of peat bog drainage water containing humic substances
2015
Abstract Electrocoagulation (EC) treatment of 100 mg/L synthetic wastewater (SWW) containing humic acids was optimized (achieving 90% CODMn and 80% DOC removal efficiencies), after which real peat bog drainage waters (PBDWs) from three northern Finnish peat bogs were also treated. High pollutant removal efficiencies were achieved: Ptot, TS, and color could be removed completely, while Ntot, CODMn, and DOC/TOC removal efficiencies were in the range of 33–41%, 75–90%, and 62–75%, respectively. Al and Fe performed similarly as the anode material. Large scale experiments (1 m3) using cold (T = 10–11 °C) PBDWs were also conducted successfully, with optimal treatment times of 60–120 min (applying…
Electrosynthesis of 3,3′,5,5’-tetramethyl-2,2′-biphenol in flow
2020
Abstract3,3′,5,5’-Tetramethyl-2,2′-biphenol is well known as an outstanding building block for ligands in transition-metal catalysis and is therefore of particular industrial interest. The electro-organic method is a powerful, sustainable, and efficient alternative to conventional synthetic approaches to obtain symmetric and non-symmetric biphenols. Here, we report the successive scale-up of the dehydrogenative anodic homocoupling of 2,4-dimethylphenol (4) from laboratory scale to the technically relevant scale in highly modular narrow gap flow electrolysis cells. The electrosynthesis was optimized in a manner that allows it to be easily adopted to different scales such as laboratory, semit…
Investigations on isomerization and rearrangement of polycyclic arenes under oxidative conditions – Anodic versus reagent-mediated reactions
2019
Abstract Electro-organic conversions at an active molybdenum anode enable the formation of fused arenes. High chemoselectivity was achieved under anodic conditions, and a reagent-induced selectivity was observed by comparison with results of MoCl5-mediated reactions. Polycyclic arenes like phenanthrenes, triphenylenes, chrysenes, or helicenes were selectively obtained in yields up to 87% and in some cases unusual rearrangements were crucial for the product formation.