Search results for "Energy recovery"

Efficiency advantages of the separated electric compound propulsion system for CNG hybrid vehicles

2021

As is widely known, internal combustion engines are not able to complete the expansion process of the gas inside the cylinder, causing theoretical energy losses in the order of 20%. Several systems and methods have been proposed and implemented to recover the unexpanded gas energy, such as turbocharging, which partially exploits this energy to compress the fresh intake charge, or turbo-mechanical and turbo-electrical compounding, where the amount of unexpanded gas energy not used by the compressor is dedicated to propulsion or is transformed into electric energy. In all of these cases, however, maximum efficiency improvements between 4% and 9% have been achieved. In this work, the authors d…

Energy, water and environmental balance of a complex water supply system

2015

The present paper describes the analysis of water and energy balance in a complex urban water supply system. The analysis was carried out employing Life Cycle Analysis (LCA) methodologies. The LCA approach was integrated with the analysis of the system energy and water balance. For a real size water supply system, based on the results of the individual LCAs, the current baseline was constructed highlighting the water, energy and environmental (in terms of CO2eq emissions in the atmosphere) costs of supplied water. Then, three different mitigation measures have been evaluated: the first is based on energy production by installation of photovoltaic systems; the second is based on energy recov…

A regenerative braking system for internal combustion engine vehicles using supercapacitors as energy storage elements - Part 2: Simulation results

2020

Abstract In this two-part work, an electric kinetic energy recovery system (e-KERS) for internal combustion engine vehicle (ICEV) is presented and its performance evaluated through numerical simulations. The KERS proposed is based on the use of a supercapacitor as energy storage, interfaced to a brushless machine through a properly designed power converter. In Part 1, the system is described and analysed, and the mathematical model used for the simulations is presented. For each component of the KERS, the real efficiency and the power or energy limitations are adequately considered. In Part 2, the energetic and economic advantages attainable by the proposed KERS are evaluated using MATLAB S…

A regenerative braking system for internal combustion engine vehicles using supercapacitors as energy storage elements - Part 1: System analysis and …

2020

Abstract In this two-part work, an electric kinetic energy recovery system (e-KERS) for internal combustion engine vehicle (ICEV) is presented, and its performance evaluated through numerical simulations. The KERS proposed is based on the use of a supercapacitor as energy storage, interfaced to a brushless machine through a properly designed power converter. In part 1, the system is described and analysed, and the mathematical model used for the simulations is presented. For each component of the KERS, the real efficiency, and the power or energy limitations are adequately considered. In part 2, the energetic and economic advantages attainable by the proposed KERS are evaluated using MATLAB…

Searching for a robust strategy for minimizing alkali chlorides in fluidized bed boilers during burning of high SRF-energy-share fuel

2015

Abstract To meet the increasing volume of waste to be treated via energy recovery, high SRF-energy-share fuel is being fired in conventional waste-to-energy facilities. In this work, corrosion related risk during firing of 70 e-% share (target fuel) is studied and compared against the base case fuel containing 50 e-% share. Cl and S concentration is highest in the target fuel as a direct result of increasing the proportion of SRF in the fuel mixture. Br, Zn and Pb showed the same trend. Meanwhile, the concentration of Na, K, Al and Si are highly dependent on the type of the SRF fired. The corrosion risk of the base and target fuels are analyzed using the composition of the fine aerosol frac…

Hydrothermal liquefaction of waste biomass in stirred reactors: One step forward to the integral valorization of municipal sludge

2020

Abstract Hydrothermal liquefaction (HTL) of municipal sludge (MS) was performed at 350 °C for 30 min (subcritical water) and at 400 °C for 0 min (supercritical water) at fixed kinetic severity (LogR0 = 8.9) in static and stirred batch reactors to study the effect of the flow regime on the energy recovery (ER) of the process and on the quality of the products. With adopted experimental procedures it was possible to reduce to less than 10% the yield of lost organic compounds, termed volatiles (VT), and to collect and quantify a liquid hydrocarbon fraction (HC) separated from the biocrude (BC). The highest value of the HC yield, 25% w/w, was obtained in supercritical conditions. The C content …

Managing Municipal Solid Waste: Energetic and Environmetal Comparison among different options

2001

Goal. This research aims to assess the environmental effects of integrated strategies in a municipal waste management system. In particular, analysis is focused on a waste stream in Palermo, where landfill involves the prompt disposal of the most waste after collection. The current local management system is compared with two integrated waste management alternatives. Both the options comply with Italian regulations, but each one predicts adopting the available technologies in different ways. Methods and objectives. Energetic and environmental balances are carried out in each management system referring to local waste composition in order to quantify energy consumption, the recovery of mater…

RECUPERO ENERGETICO ALL’INTERNO DELLE RETI ACQUEDOTTISTICHE MEDIANTE MICROTURBINE IDRAULICHE

2022

Low-Head Hydropower for Energy Recovery in Wastewater Systems

2022

Hydraulic turbines for energy recovery in wastewater treatment plants, with relatively large discharges values and small head jumps, are usually screw Archimedes or Kaplan types. In the specific case of a small head jump (about 3 m) underlying a rectangular weir in the major Palermo (Italy) water treatment plant, a traditional Kaplan solution is compared with two other new proposals: a Hydrostatic Pressure Machine (HPM) located at the upstream channel and a cross-flow turbine (CFT) located in a specific underground room downstream of the same channel. The fluid mechanical formulations of the flow through these turbines are analyzed and the characteristic parameters are stated. Numerical ana…

Coupled Electric and Hydraulic Control of a PRS Turbine in a Real Transport Water Network

2019

Although many devices have recently been proposed for pressure regulation and energy harvesting in water distribution and transport networks, very few applications are still documented in the scientific literature. A new in-line Banki turbine with positive outflow pressure and a mobile regulating flap, named Power Recovery System (PRS), was installed and tested in a real water transport network for the regulation of pressure and flow rate. The PRS turbine was directly connected to a 55 kW asynchronous generator with variable rotational velocity, and coupled to an inverter. The start-up tests showed how automatic adjustment of the flap position and the runner velocity variation are able to c…