Search results for "Environment"

MonteCarlo Methods

2016

Calibration of an airborne HO<sub><i>x</i></sub> instrument using the All Pressure Altitude-b…

2020

Abstract. Laser-induced fluorescence (LIF) is a widely used technique for both laboratory-based and ambient atmospheric chemistry measurements. However, LIF instruments require calibrations in order to translate instrument response into concentrations of chemical species. Calibration of LIF instruments measuring OH and HO2 ( HOx ) typically involves the photolysis of water vapor by 184.9 nm light, thereby producing quantitative amounts of OH and HO2 . For ground-based HOx instruments, this method of calibration is done at one pressure (typically ambient pressure) at the instrument inlet. However, airborne HOx instruments can experience varying cell pressures, internal residence times, tempe…

Structural characterization and electrochemical hydrogen storage properties of Ti2LxZrxNi (x [ 0, 0.1, 0.2) alloys prepared by mechanical alloying

2013

International audience; Nominal Ti2Ni was synthesized under argon atmosphere at room temperature using a planetary high-energy ball mill. The effect of milling time and Zr substitution for Ti on the microstructure was characterized by XRD, SEM and TEM, and the discharge capacities of Ti2xZrxNi (x 1/4 0, 0.1, 0.2) were examined by electrochemical measurements at galvanostatic conditions. XRD analysis shows that amorphous phase of Ti2Ni can be elaborated by 60 h of milling, whereas Zr substitution hinders amorphization process of the system. The products of ball milling nominal Ti2xZrxNi (x 1/4 0.1, 0.2) were austenitic (Ti, Zr)Ni and partly TiO, despite the fact that the operation was carrie…

Experimental investigation on different rainfall energy harvesting structures

2018

In this paper proposes an experimental comparison between different rainfall harvesting devices and the study of the corresponding electrical rectifying circuit. More in detail, three harvesting structures are considered: the cantilever, the bridge and the floating circle. For each of the proposed structure, different waveforms have been acquired and discussed. The processed data have been compared in order to suggest the best choice for the rectifying circuit, from the simplest one to the most endorsed in the technical literature.

Maximum Torque Per Ampere control algorithm for low saliency ratio interior permanent magnet synchronous motors

2017

This paper presents an investigation on the comparison between the Maximum Torque Per Ampere (MTPA) and the Field Orientation Control (FOC) algorithms for interior permanent magnet synchronous machines (IPMSMs). In particular, this study was carried out on a small-power IPMSM with low salience ratio. Both control algorithms have been implemented in the Matlab/Simulink environment, obtaining promising results.

The Use of Two-Diode Substitute Model in Predicting the Efficiency of PV Conversion in Low Solar Conditions

2017

Abstract The article presents theoretical foundations of a two-diode equivalent model of a photovoltaic cell/module (PV), together with calculation procedures. A physical interpretation of individual components of an equivalent model was presented. Its practical application in predicting efficiency of operation of various PV cells and modules in low insulation conditions was demonstrated. The obtained predictions were verified with the actual results of their operation in open space (outdoor). The practical suitability of the “model” in early detection of ageing phenomena, such as, for example, absorber degradation taking place in PV modules, was demonstrated. The article was prepared on th…

Photovoltaics: solar energy resources and the possibility of their use

2016

Abstract In this paper possibilities and limits of use of solar energy (like the best efficiencies of PV cells, world records and ‘notable exceptions’) were shown. Also some new ideas and concepts in photovoltaics (like new photovoltaic power plants or energy storage) were presented. Additionally authors try to predict development of solar power industry.

The role of structural disorder on luminescence of Eu-doped Na0.5Bi0.5TiO3

2020

A detailed analysis of photoluminescence of Eu-doped Na0.5Bi0.5TiO3 (NBT) is performed using it as a tool for describing the local structure of NBT. The obtained results reveal the low symmetry of the Eu3+ local environment in NBT, as indicated by the observed maximal number of sublevels of the 5D0→7F1 and the 5D0→7F2 luminescence transitions, clearly observed at low temperatures. Approximation of the luminescence spectra by Gaussian peaks provides valuable information about the shift of the involved levels upon change of the excitation wavelength. Variation in the strength of the crystal field in Eu-doped NBT is evaluated. Temperature dependence of the luminescence above room temperature i…

Towards the Improvement of Citizen Communication Through Computational Intelligence

2016

When dealing with problems that arise from collective sharing of resources in metropolitan areas (i.e., energy, pollution, traffic, health) most of the interaction between citizens and local governance is usually carried out through the use of natural languages. Digital technologies allows smart cities residents to communicate with a broad range of experts (e.g. bureaucrats, legislators, urbanists, etc.) that routinely use technical terminology seldom accessible to the layperson, or linguistic styles that are not immediately understandable. Although information technology should encourage citizen participation in governance at many levels, the different levels of knowledge possessed by the …

Application of the reduced I-V Blaesser’s characteristics in predicting PV modules and cells conversion efficiency in medium and high insolation cond…

2017

Abstract The article presents theoretical foundations of application of the reduced I-V Blaesser’s characteristics in predicting a photovoltaic cell/module (PV) efficiency, together with calculation procedures. A detailed analysis of the error of this transformation method of characteristics was carried out. Its practical application in predicting efficiency of operation of various PV cells and modules in medium and high insulation conditions was demonstrated. The practical suitability of the presented method in early detection of ageing phenomena, such as, for example, absorber degradation taking place in PV modules, was demonstrated. The article was prepared on the basis of the results of…