Search results for "FILTRATION"

Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A Review

2019

The separation of lignin from the black liquor generated during alkaline pulping is reviewed in this article with an emphasis on chemistry. Based on published accounts, the precipitation of lignin from spent pulping liquor by addition of acids can be understood based on dissociation equilibria of weak acid groups, which affects the solubility behavior of lignin-related chemical species. Solubility issues also govern lignin separation technologies based on ultrafiltration membranes; reduction in membrane permeability is often affected by conditions leading to decreased solubility of lignin decomposition products and the presence of colloidal matter. Advances in understanding of such phenomen…

The infiltration of the mafia organized crime in the football sports system

2017

The paper concerns the issue of the infiltration of the mafia organized crime in the football sports system. This is a question of topical interest and is object of particular attention of the italian legislator

Polinucleotides versus ialuronic acid in ecoguided hip infiltration: preliminary results

2011

Photografted methacrylate-based monolithic columns coated with cellulose tris(3,5-dimethylphenylcarbamate) for chiral separation in CEC

2018

A chiral capillary monolithic column for enantiomer separation in capillary electrochromatography was prepared by coating cellulose tris(3,5-dimethylphenylcarbamate) on porous glycidyl methacrylate-co-ethylene dimethacrylate monolith in capillary format grafted with chains of [2(methacryloyloxy)ethyl] trimethylammonium chloride. The surface modification of the monolith by the photografting of [2(methacryloyloxy)ethyl] trimethylammonium chloride monomer as well as the coating conditions of cellulose tris(3,5-dimethylphenylcarbamate) onto the grafted monolithic scaffold were optimized to obtain a stable and reproducible chiral stationary phase for capillary electrochromatography. The effect o…

Nanopore charge inversion and current-voltage curves in mixtures of asymmetric electrolytes

2018

[EN] We consider the screening of the negative charges (carboxylic acid groups) fixed on the surface of a conical-shaped track-etched nanopore by divalent magnesium (Mg2+) and trivalent lanthanum (La3+). The experimental current (I)-voltage (V) curves and current rectification ratios allow discussing fundamental questions about the overcompensation of spatially-fixed charges by multivalent ions over nanoscale volumes. The effects of charge inversion or reversal on nanopore transport are discussed in mixtures of asymmetric electrolytes (LaCl3 and MgCl2 with KCl). In particular, pore charge inversion is demonstrated for La3+ as well as for mixtures of this trivalent ion at low concentrations …

Removal of Fe(III) from synthetic wastewater into raw and modified clay: Experiments and models fitting

2017

Water pollution by heavy metal ions has become a serious environmental issue especially due to their toxicity and tendency to bioaccumulation. Natural smectite clay was treated using sulfuric acid ...

Barrier properties of chitosan coated polyethylene

2012

The transfer properties of chitosan coated polyethylene (PE) films were studied. The barrier properties of non coated PE were not affected by relative humidity changes. The presence of the hydrophilic chitosan layer acted as a water reservoir on the polyethylene film surface which significantly promoted its sensitivity to the water vapour. The water vapour permeability increased 1.85 times at a higher RH. Coated PE films showed more than two-order decrease in the oxygen permeability (PO2) and three-order-decrease in the carbon dioxide permeability (PCO2). When the chitosan coated PE surface was exposed to the water vapour, the PO2 and the PCO2 were significantly increased. However, the perm…

Preparation of polyelectrolyte-modified membranes for heavy metal ions removal

2017

ABSTRACTPolyethersulfone membranes were modified by polyelectrolyte (PE) multilayers, made of poly(allylamine hydrochloride) with poly(styrene sulfonate), to remove Cu2+, Zn2+ and Ni2+ heavy metal cations from aqueous solutions in a wide range of metal concentration (50–1200 ppm). After characterization of the modified membranes, the efficiency of the process was estimated for single heavy metal ions solution leading to high rejection rates (>90% for 50 ppm) and good adsorption capacities (7.0–8.5 mg cm−2) whatever the metal ion tested. The stability in time of the modified membranes was proved by repeating successive filtrations with the same membrane. The filtration process was also used …

Enantioselective transport of amino acid through supported chiral liquid membranes

1993

Abstract Two chiral alcohols, nopol and (2S)-(−)-methyl-1-butanol, immobilized in the pores of a polyethylene film were used for the anantioselective transport of amino acid hydrochloride. The degree of stereoselectivity of the permeation process varied from 0.39 to 1.52 depending on both the type of the chiral membrane phase and the properties of the amino acid. The evaluation of the membrane ability to separate stereoisomers was performed by the step-by-step analysis by considering the effect of amino acids' hydrophobicity, polarity and degree of chirality. For the purpose of this paper, the chirality measure was introduced. It was demonstrated that the enantioselectivity was affected mai…

Modelling landslides in unsaturated slopes subjected to rainfall infiltration using material point method

2016

This paper presents a dynamic fully coupled formulation for saturated and unsaturated soils that undergo large deformations based on material point method. Governing equations are applied to porous material while considering it as a continuum in which the pores of the solid skeleton are filled with water and air. The accuracy of the developed method is tested with available experimental and numerical results. The developed method has been applied to investigate the failure and post-failure behaviour of rapid landslides in unsaturated slopes subjected to rainfall infiltration using two different bedrock geometries that lie below the top soil. The models show different failure and post-failur…