Search results for "FLUID"

A new strategy to maximize organic matter valorization in municipalities: combination of urban wastewater with kitchen food waste and its treatment w…

2017

[EN] The aim of this study was to evaluate the feasibility of treating the kitchen food waste (FW) jointly with urban wastewater (WW) in a wastewater treatment plant (WWTP) by anaerobic membrane technology (AnMBR). The experience was carried out in six different periods in an AnMBR pilot-plant for a total of 536 days, varying the SRT, HRT and the food waste penetration factor (PF) of food waste disposers. The results showed increased methane production of up to 190% at 70 days SRT, 24 hours HRT and 80% PF, compared with WW treatment only. FW COD and biodegradability were higher than in WW, so that the incorporation of FW into the treatment increases the organic load and the methane producti…

Closure to “Extraction of the Flow Rate Equation under Free and Submerged Flow Conditions in Pivot Weirs with Different Side Contractions” by N. Shei…

2018

Partial Stabilization of Input-Output Contact Systems on a Legendre Submanifold

2017

This technical note addresses the structure preserving stabilization by output feedback of conservative input-output contact systems, a class of input-output Hamiltonian systems defined on contact manifolds. In the first instance, achievable contact forms in closed-loop and the associated Legendre submanifolds are analysed. In the second instance the stability properties of a hyperbolic equilibrium point of a strict contact vector field are analysed and it is shown that the stable and unstable manifolds are Legendre submanifolds. In the third instance the consequences for the design of stable structure preserving output feedback are derived: in closed-loop one may achieve stability only rel…

Aircraft wing rock oscillations suppression by simple adaptive control

2020

Abstract Roll angular motion of the modern aircraft operating in non-linear flight modes with a high angle of attack often demonstrates the limit cycle oscillations, which is commonly known as the wing rock phenomenon. Wing rock dynamics are represented by a substantially non-linear model, with parameters varying over a wide range, depending on the flight conditions (altitude, Mach number, payload mass, etc.) and angle of attack. A perspective approach of the wing rock suppression lies in the adaptation methods. In the present paper an application of the simple adaptive control approach with the Implicit Reference Model (IRM) is proposed and numerically studied. The IRM adaptive controller …

Adaptive Feedforward Control of a Pressure Compensated Differential Cylinder

2020

This paper presents the design, simulation and experimental verification of adaptive feedforward motion control for a hydraulic differential cylinder. The proposed solution is implemented on a hydraulic loader crane. Based on common adaptation methods, a typical electro-hydraulic motion control system has been extended with a novel adaptive feedforward controller that has two separate feedforward states, i.e, one for each direction of motion. Simulations show convergence of the feedforward states, as well as 23% reduction in root mean square (RMS) cylinder position error compared to a fixed gain feedforward controller. The experiments show an even more pronounced advantage of the proposed c…

Underwater Wireless Communications for Cooperative Robotics with UWSim-NET

2019

The increasing number of autonomous underwater vehicles (AUVs) cooperating in underwater operations has motivated the use of wireless communications. Their modeling can minimize the impact of their limited performance in real-time robotic interventions. However, robotic frameworks hardly ever consider the communications, and network simulators are not suitable for HIL experiments. In this work, the UWSim-NET is presented, an open source tool to simulate the impact of communications in underwater robotics. It gathers the benefits of NS3 in modeling communication networks with those of the underwater robot simulator (UWSim) and the robot operating system (ROS) in modeling robotic systems. Thi…

A Comparison Study of a Novel Self-Contained Electro-Hydraulic Cylinder versus a Conventional Valve-Controlled Actuator—Part 2: Energy Efficiency

2019

This research paper presents the second part of a comparative analysis of a novel self-contained electro-hydraulic cylinder with passive load-holding capability against a state of the art, valve-controlled hydraulic system that is typically used in load-carrying applications. After addressing the control design and motion performance in the first part of the study, the comparison is now focused on the systems&rsquo

Energy-based fluid–structure model of the vocal folds

2020

AbstractLumped elements models of vocal folds are relevant research tools that can enhance the understanding of the pathophysiology of many voice disorders. In this paper, we use the port-Hamiltonian framework to obtain an energy-based model for the fluid–structure interactions between the vocal folds and the airflow in the glottis. The vocal fold behavior is represented by a three-mass model and the airflow is described as a fluid with irrotational flow. The proposed approach allows to go beyond the usual quasi-steady one-dimensional flow assumption in lumped mass models. The simulation results show that the proposed energy-based model successfully reproduces the oscillations of the vocal …

Sliding solutions of second-order differential equations with discontinuous right-hand side

2017

We consider second-order ordinary differential equations with discontinuous right-hand side. We analyze the concept of solution of this kind of equations and determine analytical conditions that are satisfied by typical solutions. Moreover, the existence and uniqueness of solutions and sliding solutions are studied. Copyright © 2017 John Wiley & Sons, Ltd.

An adaptive multi-rate system for visual tracking in augmented reality applications

2016

The visual tracking of an object is a well-known problem, and it involves many fields of applications. Often a single sensor, the camera, could not provide enough information in order to track the whole object trajectory due to a low updating rate; therefore a multi-sensor system, based also on inertial measurements, could be necessary to improve the tracking accuracy. This leads to the fundamental question: how can information from different sensors be combined when they work at different rates? In this paper an approach based on recursive parameter estimation focusing on multi-rate situations is suggested. The problem is here formulated as the state-of-the-art problem of the visual tracki…