Search results for "Fiber"

Hamiltonian tools for the analysis of optical polarization control

2011

Import JabRef; International audience; The study of the polarization dynamics of two counterpropagating beams in optical fibers has recently been the subject of a growing renewed interest, from both the theoretical and experimental points of view. This system exhibits a phenomenon of polarization attraction, which can be used to achieve a complete polarization of an initially unpolarized signal beam, almost without any loss of energy. Along the same way, an arbitrary polarization state of the signal beam can be controlled and converted into any other desired state of polarization, by adjusting the polarization state of the counterpropagating pump beam. These properties have been demonstrate…

Condition Monitoring Technologies for Synthetic Fiber Ropes - a Review

2020

This paper presents a review of different condition monitoring technologies for fiber ropes. Specifically, it presents an overview of the articles and patents on the subject, ranging from the early 70’s up until today with the state of the art. Experimental results are also included and discussed in a conditionmonitoring context,where failuremechanisms and changes in physical parameters give improved insight into the degradation process of fiber ropes. From this review, it is found that automatic width measurement has received surprisingly little attention, and might be a future direction for the development of a continuous condition monitoring system for synthetic fiber ropes.

A Strain Sensing Structural Health Monitoring System for Delaminated Composite Structures

2012

Structural Health Monitoring (SHM) for composite materials is becoming a primary task due to their extended use in safety critical applications. Different methods, based on the use of piezoelectric transducers as well as of fiber optics, has been successfully proposed to detect and monitor damage in composite structural components with particular attention focused on delamination cracks.In the present paper a Structural Health Monitoring model, based on the use of piezoelectric sensors, already proposed by the authors for isotropic damaged components, is extended to delaminated composite structures. The dynamic behavior of the host damaged structure and the bonded piezoelectric sensors is m…

Supported liquid membrane extraction with single hollow fiber for the analysis of fluoroquinolones from environmental surface water samples

2010

Abstract In this work, the simple analytical method for the determination of four fluoroquinolone antibiotics: ciprofloxacin, enrofloxacin, norfloxacin and danofloxacin, in environmental surface water samples is described. Sample pretreatment step was performed by the application of a technique based on supported liquid membrane extraction with the configuration of single hollow fiber (HF-SLM). The HPLC system with diode array detection was used for final analysis of studied analytes. Various parameters affecting the extraction efficiency during HF-SLM enrichment, such as type of membrane diluent, pH of donor (sample) and acceptor phases, as well as an enrichment time and salt content of sa…

Modulational instability and generation of self-induced transparency solitons in resonant optical fibers

2009

International audience; We consider continuous-wave propagation through a fiber doped with two-level resonant atoms, which is described by a system of nonlinear Schrodinger-Maxwell-Bloch (NLS-MB) equations. We identify the modulational instability (MI) conditions required for the generation of ultrashort pulses, in cases of both anomalous and normal GVD (group-velocity dispersion). It is shown that the self-induced transparency (SIT) induces non-conventional MI sidebands. The main result is a prediction of the existence of both bright and dark SIT solitons in the anomalous and normal GVD regimes.

Core polarization phenomena in pion-nucleus charge-exchange reactions above the delta resonance.

1993

The fine structure of denervated and reinnervated muscle spindles: morphometric study of intrafusal muscle fibers.

1979

The fine structure of normal, denervated, and reinnervated muscle spindles in lower lumbrical muscles of rats was studied morphometrically at time intervals ranging from 3-14 months. In control spindles, the mean transverse area of mitochondria was estimated to be more than twice as large in nuclear chain than in typical nuclear bag fibers. Following denervation, there was a severe decrease of the mean number and transverse area of mitochondria, and a moderate, but statistically significant decrease of the mean transverse area of intrafusal muscle fibers (IMFs) despite an increase of the number of IMFs. At 12-14 months of reinnervation, changes of the transverse areas of IMFs were statistic…

Diagnostic immunohistochemistry in neuromuscular disorders.

2005

Most neuromuscular disorders display only non-specific myopathological features in routine histological preparations. However, a number of proteins, including sarcolemmal, sarcomeric, and nuclear proteins as well as enzymes with defects responsible for neuromuscular disorders, have been identified during the past two decades, allowing a more specific and firm diagnosis of muscle diseases. Identification of protein defects relies predominantly on immunohistochemical preparations and on Western blot analysis. While immunohistochemistry is very useful in identifying abnormal expression of primary protein abnormalities in recessive conditions, it is less helpful in detecting primary defects in …

Tooth-Implant connection: A bibliographic review

2008

The aim of this study was to carry out a bibliographic review of all available literature addressing the issue of whether or not the connection of teeth to implants by means of a prosthesis is a viable treatment alternative. Twenty articles from a variety of sources were analyzed and classified in order to draw conclusions. Articles were classified by type and an analysis was made of the different variables considered in each study, obtaining percentages of implant survival ranging from 84.4% to 100%, prosthetic complications ranging from 80% to 90%, and the incidence of dental intrusion ranging from 0 to 5.6%. Biomechanical studies: Some articles studied models in order to assess different…

Influence of prefabricated post dimensions on restored maxillary central incisors

2007

summary  The aim of this study was to test the following hypothesis: biomechanical performance (fracture strength and stress distribution) of restored teeth is less sensitive to post diameter and post length when using glass fibre posts than when using stainless steel posts. First, an experimental fracture strength test was performed on 80 extracted human maxillary central incisors. Teeth were decoronated, treated endodontically and restored (40 with glass fibre posts and 40 with stainless steel posts), and the length and diameter of the posts varied uniformly. Failure loads were recorded and results were compared using an ancova analysis. Secondly, the finite element technique was used to …