Search results for "Fission"

Decay properties of neutron-deficient isotopes 256, 257Db, 255Rf, 252, 253Lr

2001

Isotopes of dubnium (element 105) with mass numbers A = 256, 257, and 258 were produced by the reaction 209Bi(50Ti,xn) 259-xDb (x = 1, 2, 3) at projectile energies of (4.59-5.08) AMeV. Excitation functions were measured for the 1n, 2n and 3n evaporation channels. The same position of the excitation function was observed for the 1n channel as for the previously measured 1n channel of the reaction 208Pb(50Ti,1n)257Rf. The measured α-decay data of 257Db and its daughter products resulted in the identification of α-decaying isomeric states in 257Db and 253Lr. Two new isotopes, 256Db and 252Lr, were produced at the highest bombarding energies of 4.97 AMeV and 5.08 AMeV. They were identified by d…

Gas phase synthesis of 4d transition metal carbonyl complexes with thermalized fission fragments in single-atom reactions

2021

Abstract The formation of carbonyl complexes using atom-at-a-time quantities of short-lived transition metals from fusion and fission reactions was reported in 2012. Numerous studies focussing on this chemical system, which is also applicable for the superheavy elements followed. We report on a novel two-chamber approach for the synthesis of such complexes that allows spatial decoupling of thermalization and gas-phase carbonyl complex synthesis. Neutron induced fission on 235U and spontaneous fission of 248Cm were employed for the production of the fission products. These were stopped inside a gas volume behind the target and flushed with an inert-gas flow into a second chamber. This was fl…

Über die schnelle Trennung des Rutheniums von den Spaltprodukten des Urans

1971

Measurements of isomeric yield ratios of fission products from proton-induced fission on natU and 232Th via direct ion counting

2017

Independent isomeric yield ratios (IYR) of 81Ge, 96Y, 97Y, 97Nb, 128Sn and 130Sn have been determined in the 25 MeV proton-induced fission of natU and 232Th. The measurements were performed at the Ion Guide Isotope Separator On-Line (IGISOL) facility at the University of Jyväskylä. A direct ion counting measurement of the isomeric fission yield ratios was accomplished for the first time, registering the fission products in less than a second after their production. In addition, the IYRs of natU were measured by means of γ-spectroscopy in order to verify the consistency of the recently upgraded experimental setup. From the obtained results, indications of a dependence of the production rate …

Trennung von spaltprodukten durch Extraktionschromatographie

1970

The separation of fission products which form anionic species in mineral acids and of uranium and neptunium from samples of neutron-irradiated uranium is described. The method used is extraction chromatography with tri-n-butylphosphate (TBP) and di-(2-ethylhexyl)-orthophosphoric acid (HDEHP) as extractants and polytrifluoromonochloroethylene powder as the solid support. In the first column Zr, U and Np are extracted with TBP from 8N HNO3/NaClO3. In the second column, HDEHP is applied as extractant and 9N HCl/NaClO3 as the mobile phase for the isolation of Nb, Sb, and I, and in the third column (HDEHP), the rare earths and Mo are extracted from 0.1N HCl. Finally with the fourth column (TBP),…

Studies of short-lived fission products by means of the multistage solvent extraction system SISAK

1990

The multistage solvent extraction system SISAK is described. The system is used for online studies of nuclides with half-lives down to ∼1 s. Some of the chemical separation procedures are presented, and a survey is given on the results obtained so far. The possiblity to gain access to nuclides with even shorter half-lives is also discussed.

Isomeric Yield Ratios of 134I and 136I and Independent Fractional Yields of some Halogen Isotopes in the Fission of 232Th with Reactor Neutrons

1990

Performance of the on-line isotope separation facility HELIOS at the Mainz reactor

1981

Abstract The helium-jet on-line isotope eparation facility HELIOS is in operation at the Mainz reactor for spectroscopic studies on mass separated neutron-rich nuclides far from the line of beta-stability. The basic features and achievements of the facility are reported. A total of 45 isotopes of the elements Rb, Sr, Y, Sn, Sb, Te, Cs, Ba, La, Ce, Pr and Nd have been separated and identified so far. Overall efficiencies up to 2% have been obtained using the integrated skimmer ion source arrangement either in a hollow cathode or in a high temperature surface ionization mode. The delay time for the HELIOS system was determined to be about 1 s.

A ROOT-based analysis tool for measurements of neutron-induced fission products at the IGISOL facility

2012

For the sustainable development of nuclear energy, the handling of used nuclear fuel is a key issue. Innovative fuel cycles are being developed for the transmutation of minor actinides and long-lived fission products. In view of these developments, accurate knowledge of the fuel inventory is necessary. The IGISOL facility with JYFLTRAP, at the accelerator laboratory of the University of Jyvaskyla, will be used to measure independent fission yield distributions from neutron-induced fission on different actinides. In this paper, an analysis tool is developed, using the CERN-based ROOT Data Analysis Framework, with the objective of performing full data analysis within the same code. The analys…

Fission studies at IGISOL/JYFLTRAP: Simulations of the ion guide for neutron-induced fission and comparison with experimental data

2020

For the production of exotic nuclei at the IGISOL facility, an ion guide for neutron-induced fission has been developed and tested in experiments. Fission fragments are produced inside the ion guide and collected using a helium buffer gas. Meanwhile, a GEANT4 model has been developed to simulate the transportation and stopping of the charged fission products. In a recent measurement of neutron-induced fission yields, implantation foils were located at different positions in the ion guide. The gamma spectra from these foils and the fission targets are compared to the results from the GEANT4 simulation. In order to allow fission yield measurements in the low yield regions, towards the tails a…