Search results for "Flocculation"
showing 10 items of 21 documents
Comparative study of laboratory-scale thermophilic and mesophilic activated sludge processes.
2005
Laboratory-scale mesophilic (20-35 degrees C) and thermophilic (55 degrees C) activated sludge processes (ASPs) treating diluted molasses wastewater were compared in effluent quality, removal of different COD fractions, sludge yield, floc size, and sludge settleability. The effect of polyaluminium chloride (PAC) with high cationic charge on sludge settleability and effluent quality was also studied. In the ASPs, the hydraulic retention time was 12h in both processes, corresponding to a volumetric loading rate of 3.2+/-1.0 kg COD(filt) m(-3)d(-1). The mesophilic ASP gave 79+/-18% and 90+/-2% and the thermophilic ASP gave 50+/-6% and 67+/-11% total COD (COD(tot)) and GF/A-filtered COD (COD(fi…
Bioflocculation of Euglena gracilis via direct application of fungal filaments: a rapid harvesting method
2021
Funding Information: Special thanks to the US Agricultural Research Service for the provision of fungal strains. Thanks also to Dr Marilyn Wiebe (Technical Research Centre of Finland) for her expert advice on fungi and Johanna Oja for her technical help. This research was enabled by funding from The Land and Water Technology Foundation, The Finnish Cultural Foundation, and The Finnish Foundation for Technology Promotion. Publisher Copyright: © 2021, The Author(s). The high cost and environmental impact of traditional microalgal harvesting methods limit commercialization of microalgal biomass. Fungal bioflocculation of microalgae is a promising low-cost, eco-friendly method but the range of …
Effect of high methoxyl pectin on pea protein in aqueous solution and at oil/water interface
2010
International audience; The effect of the addition of high methoxyl pectin on the stability of pea protein isolate emulsions was investigated. Except for low pectin concentrations at acidic pHs where bridging flocculation occurred the addition of pectin improved emulsion stability to pH changes and depletion flocculation induced by maltodextrin addition. The mechanism of pectin induced stability was probed by measuring protein-pectin complex formation in solution, zeta potential of the emulsions droplets and the change in surface viscoelasticity on pectin addition. The phase diagrams of pectin-pea protein isolate in solution and pectin-pea protein-stabilized emulsions were established based…
Heavy metals in coastal water systems. A case study from the northwestern Gulf of Thailand.
2005
A geochemical survey of the northwestern part of the Thailand Gulf (Inner Gulf) was carried out in order to define concentrations and distribution patterns of selected heavy metals (V, Cr, Co, Ni, Cu, Zn, and U) in the coastal system and estuarine area of the Mae Klong river. The results indicate the presence of two different sources of heavy metals in the studied environment and allowed us to identify a lithogenic component that significantly influences the composition of coastal waters and suspended particulate matter (SPM). Comparison of the normalized heavy metals concentrations both in the studied samples and in those reported for the Sn–W ores present in the surrounding areas suggests…
Online measurement of floc size, viscosity, and consistency of cellulose microfibril suspensions with optical coherence tomography
2021
AbstractIn this study, cellulose microfibril (CMF) suspensions were imaged during pipe flow at consistencies of 0.4%, 1.0%, and 1.6% with optical coherence tomography (OCT) to obtain images of the structure and the local velocity of the suspension. The viscosities obtained by combining pressure loss measurement with the OCT velocity data showed typical shear thinning behavior and were in excellent agreement with viscosities obtained with ultrasound velocity profiling. The structural OCT images were used to calculate the radial and the axial floc sizes of the suspension. A fit of power law to the geometrical floc size–shear stress data gave the same power law index for all consistencies, sug…
Rheological and Flocculation Analysis of Microfibrillated Cellulose Suspension Using Optical Coherence Tomography
2018
A sub-micron resolution optical coherence tomography device was used together with a pipe rheometer to analyze the rheology and flocculation dynamics of a 0.5% microfibrillated cellulose (MFC) suspension. The bulk behavior of the MFC suspension showed typical shear thinning (power-law) behavior. This was reflected in a monotonously decreasing floc size when the shear stress exceeded the yield stress of the suspension. The quantitative viscous behavior of the MFC suspension changed abruptly at the wall shear stress of 10 Pa, which was reflected in a simultaneous abrupt drop of the floc size. The flocs were strongly elongated with low shear stresses. With the highest shear stresses, the flocs…
AcetyltransferaseSAS2and sirtuinSIR2,respectively, control flocculation and biofilm formation in wine yeast
2014
Cell-to-cell and cell-to-environment interactions of microorganisms are of substantial relevance for their biotechnological use. In the yeast Saccharomyces cerevisiae, flocculation can be an advantage to clarify final liquid products after fermentation, and biofilm formation may be relevant for the encapsulation of strains of interest. The adhesion properties of wine yeast strains can be modified by the genetic manipulation of transcriptional regulatory proteins, such as histone deacetylases, and acetylases. Sirtuin SIR2 is essential for the formation of mat structures, a kind of biofilm that requires the expression of cell-wall protein FLO11 as its deletion reduces FLO11 expression, and ad…
Surface properties of Saccharomyces cerevisiae lees during sparkling wine ageing and their effect on flocculation
2009
Cell surface properties were determined for the first time for lees of Saccharomyces cerevisiae, and they proved to be significantly dependent on the time of sparkling wine ageing on lees. Cell surface hydrophobicity decreased from approximately 44% to 11% of affinity to hexadecane. Electron acceptor capacity (calculated as % affinity to ethyl acetate-% affinity to decane) increased from approximately -27% to 10 % and zeta potential from approximately -4 to 6mV. Mannoproteins are released from the external cell wall layer during the autolytic process, as confirmed by TOF-SIMS analysis of the cell wall chemical composition. This could explain the modifications of lees cell surface properties…
Polymer-induced phase separation in Escherichia coli suspensions
2010
We studied aggregation and phase separation in suspensions of de-flagellated Escherichia coli (AB1157) in phosphate buffer induced by the anionic polyelectrolyte sodium polystyrene sulfonate. We also performed Monte Carlo simulations of this system based on the Asakura–Oosawa model of colloid–polymer mixtures. The results of these simulations, as well as comparison with previous work on synthetic colloid–polymer mixtures, demonstrate that the role of the polymer is to cause a depletion attraction between the E. coli cells. The implication of these results for understanding the role of (predominantly anionic) extracellular polymeric substances (EPS) secreted by bacteria in various natural ph…
Some aspects related to stability, critical concentrations and kinetics of flocculation of the calcium phytate colloid
1986
Abstract As 99mTcCa phytate is an important radiopharmaceutical and its colloidal nature presents problems, we investigated some of them. This work describes the study of the colloidal behaviour of the calcium phytate colloid in terms of its formation, stability and kinetics of flocculation. The study of spontaneous, and centrifugation-induced flocculation allows the determination of two critical concentrations of sol flocculation. The titrations of calcium phytate colloid at different concentrations provide information on the colloidal formation conditions. Moreover, a study on flocculation kinetics was made by turbidity measurements.