Search results for "Fluids"
showing 10 items of 1936 documents
A Model to Characterize the D-T Layer of ICF Targets by Backlit Optical Shadowgraphy
2005
A numerical model is presented in order to modelize the bright ring that appears in backlit optical shadowgraphy on a transparent hollow sphere with a solid deuterium-tritium layer inside. This novel model is based on computational calculations applied to the problem of the targets used in inertial confinement fusion. The model takes into account the influences of the optical imaging system (numerical aperture, source divergence, camera resolution, etc.) and the effect of the capsule itself, diameter, thickness, and refractive index, and allows one to analyze the inner surface of a capsule in terms of thickness and roughness.
Quantitative analysis of rhenium in irradiated tungsten
2021
Abstract Pure tungsten (W), irradiated to 3.5 dpa in a target of the Swiss neutron spallation source (SINQ), was characterized using high-sensitivity HPGe gamma ray spectroscopy to identify the present radionuclides. Synchrotron X-ray absorption spectroscopy was used to quantify the amount of Re produced in the irradiated W. An atomic concentration of 0.61% Re in the irradiated W was determined from the height of the L3-edge X-ray absorption edge jump. Analysis of the local atomic structure from the extended X-ray absorption fine structure (EXAFS) spectra indicates that rhenium (Re) produced in the system is mainly coordinated by W atoms and partly coordinated by void defects. First-princip…
Collinear laser spectroscopy of stable palladium isotopes at the IGISOL facility
2020
AbstractCollinear laser spectroscopy on stable palladium isotopes was performed at the IGISOL facility in Jyväskylä in preparation for an experiment on its neutron-rich isotopes. Five transitions from different initial atomic states were tested, with the goal of finding the most spectroscopically efficient. The observed intensities afforded a comparison with atomic-level population predictions based on charge-exchange calculations. For some transitions hyperfine parameters of 105Pd were measured, which were found to be in good agreement with literature values. A King plot analysis was performed using the measured isotope shifts and known charge radii from literature to determine the atomic …
Comparison of LIBS results on ITER-relevant samples obtained by nanosecond and picosecond lasers
2019
This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the European Union's Horizon 2020 research and innovation programme under grant agreement number 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission. Work performed under EUROfusion WP PFC.
Ab initio modelling of titanium impurities in α-Fe lattice
2020
Abstract Reduced activation ferritic-martensitic (RAFM) as well as ferritic steels strengthened by yttrium oxide are considered as candidate materials for future fusion and advanced fission reactors. Addition of Ti during the manufacturing of the oxide dispersed strengthened (ODS) leads to the formation of yttrium titanium oxide particles, which size is smaller compared to yttrium oxide particles. This improves the mechanical properties and radiation resistance of the ODS steels. DFT calculations of Ti impurities have been performed to determine the factors contributing to the formation of the nanoparticles in α-Fe (bcc-Fe) based steels. The interaction energies between TiFe-OFe, TiFe-Ooct,…
Diagnostics of a charge breeder electron cyclotron resonance ion source helium plasma with the injection ofNa231+ions
2016
This work describes the utilization of an injected 23Na1+ ion beam as a diagnostics of the helium plasma of a charge breeder electron cyclotron resonance ion source. The obtained data allows estimating the upper limit for the ion-ion collision mean-free path of the incident sodium ions, the lower limit of ion-ion collision frequencies for all charge states of the sodium ions and the lower limit of the helium plasma density. The ion-ion collision frequencies of high charge state ions are shown to be at least on the order of 1–10 MHz and the plasma density is estimated to be on the order of 1011 cm−3 or higher. The experimental results are compared to simulations of the 23Na1+ capture into t…
Formation and accumulation of radiation-induced defects and radiolysis products in modified lithium orthosilicate pebbles with additions of titanium …
2016
Abstract Lithium orthosilicate (Li4SiO4) pebbles with 2.5 wt.% excess of silicon dioxide (SiO2) are the European Union's designated reference tritium breeding ceramics for the Helium Cooled Pebble Bed (HCPB) Test Blanket Module (TBM). However, the latest irradiation experiments showed that the reference Li4SiO4 pebbles may crack and form fragments under operation conditions as expected in the HCPB TBM. Therefore, it has been suggested to change the chemical composition of the reference Li4SiO4 pebbles and to add titanium dioxide (TiO2), to obtain lithium metatitanate (Li2TiO3) as a second phase. The aim of this research was to investigate the formation and accumulation of radiation-induced …
ODS ferritic steels obtained from gas atomized powders through the STARS processing route: Reactive synthesis as an alternative to mechanical alloying
2018
Authors acknowledge ALBA synchrotron (Spain) for the provision of beamtime on the beam line BL22-CLAESS (Proposal 2016081797). Transmission electron microscopy observations were accomplished at Centro Nacional de Microscopía Electrónica, CNME-UCM. This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014–2018 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission. Financial support from Basque Government through the ELKARTEK ACTIMAT 2016 project is also acknowledged.
Investigation of precipitate in an austenitic ODS steel containing a carbon-rich process control agent
2018
This work has been carried out within the framework of the German Helmholtz Association and has received funding from the topic “Materials Research for the Future Energy Supply”. The work of M. Parish and Rainer Ziegler is gratefully acknowledged. Thanks are also due to the team of the chemical laboratory at the KIT for performing the chemical analysis. The help of the beamline staff at ELETTRA (project 20140052 ) synchrotron radiation facility is acknowledged. We acknowledge support by Deutsche Forschungsgemeinschaft and Open Access Publishing Fund of Karlsruhe Institute of Technology.
Tritium retention measurements by accelerator mass spectrometry and full combustion of W-coated and uncoated CFC tiles from the JET divertor
2016
Abstract Accelerator mass spectrometry (AMS) and the full combustion method (FCM) followed by liquid scintillation counting were applied to quantitatively determine the tritium retention in the tungsten-coated carbon fibre composites (CFC), in comparison to uncoated CFC tiles from the JET divertor. The tiles were adjacent and exposed to plasma operations between 2007 and 2009. The tritium depth profiles are showing that the tritium retention on the W-coated tile was reduced by a factor of 13.5 in comparison to the uncoated tile whereas the bulk tritium concentration is approximately the same for both tiles.