Search results for "Fluoride"
showing 10 items of 314 documents
High-Resolution Spectroscopy and Analysis of the ν3 and ν4 Fundamentals of Monoisotopic 70GeF4
2001
The first high-resolution study on germanium tetrafluoride is reported. We used a monoisotopic sample of (70)GeF(4). The FTIR spectra of the two infrared active fundamentals, namely the nu(4) (bending) and nu(3) (stretching) modes, were recorded at a temperature of ca. 210 K and a resolution (1/maximum optical path difference) of 0.0031 and 0.0023 cm(-1), respectively. These spectra were analyzed using the STDS software developed in Dijon. In both cases, we obtained a fit with a root mean square better than 1x10(-3) cm(-1). Both bands show very regular structures with no detectable perturbation. Copyright 2001 Academic Press.
Degradation of fluoride-free MIL-100(Fe) and MIL-53(Fe) in water: Effect of temperature and pH
2016
Abstract The degradation in liquid water of two iron-containing MOFs MIL-100(Fe) and MIL-53(Fe) synthesized in fluoride-free conditions was studied. It was found that dispersing the MOFs in deionized water (1 mg/mL) results in the decrease of pH to 2.9 for MIL-100(Fe) and to 4.5 for MIL-53(Fe). Given this finding the stability of the MOFs in liquid water was characterized under two different sets of conditions: 1) reflux in water at 100 °C under obtained pH and 2) at ambient temperature under adjusted pH 7. After reflux of MIL-100(Fe) at 100 °C its XRD pattern remains unchanged, however a strong decrease of its BET surface area and appearance of α-Fe 2 O 3 nanoparticles point out to a parti…
Depth profiles of hardening in lithium fluoride irradiated with swift58Ni ions
2004
The changes of hardness and dislocation formation in LiF crystals irradiated with 630-MeV 58Ni ions up to a dose of 20 MGy were studied by microindentation and dislocation etching techniques. Above the threshold fluence of 2 × 1010 ions/cm2, a marked effect of hardening, which is related mainly to damage processes in the track core, has been observed. Its magnitude depends on ion fluence and energy loss. To investigate the depth distribution of hardening, indentation tests on crystal cross sections cleaved parallel to ion flux were performed. It has been found that the hardness change along the ion path correlates with the ion energy loss and reaches the highest value at the Bragg maximum. …
Corrosion protection of Nd–Fe–B type permanent magnets by zinc phosphate surface conversion coatings
2001
Abstract The use of protective zinc phosphate top coatings to protect Nd–Fe–B type permanent magnets against corrosion is discussed. The progress of the phosphatisation process has been tested by simultaneous measurement of pH near surface, corrosion potential, substrate mass loss and phosphate coating mass gain. The corrosion behaviour of the magnet in phosphate solution was analyzed by the anodic polarization technique and the general resistance of the magnet to corrosion was evaluated by the Akimov drop test. It is shown that immersion of the magnet in the acidified (pH=2) phosphating solution containing Zn(II), nitrate and fluoride ions resulted in the formation of well adhered, thin an…
Fluoride-induced precipitates on enamel surface and subsurface areas visualised by electron microscopy and confocal laser scanning microscopy
1997
The present study examined the enamel surface after in vitro topical treatments with a neutral 2% NaF solution. For minimising the risk of artefacts, samples were inspected without pre-treatment as fresh, naturally wet specimens by complementary techniques: variable pressure electron microscopy (VP-SEM) and confocal laser scanning microscopy (CLSM). VP-SEM provided information on the surface morphology, whereas CLSM allowed non-destructive visualisation of subsurface areas. Neutral NaF solutions induced globular precipitates on the enamel surfaces. If the globules formed may be described as "calcium fluoride like material", the additional information of this experiment is that, after intera…
Effect of surface impurities on downconversion luminescence of Pr3+, Yb3+ activated SrF2 nanoparticles
2020
Abstract Pr3+,Yb3+ activated SrF2 nanoparticles synthesized by low-temperature hydrothermal method were studied. The composition and size of nanoparticles were intentionally changed by controlling synthesis conditions. After structural and morphological characterization, the spectroscopic properties of the nanoparticles were analyzed in the visible and near infrared spectra ranges. The results show correlation between the gradual change of the amount of carboxylate and hydroxyl moieties on the nanoparticle surface, varied by the size nanoparticles and the quenching of the luminescence. The size-related amount of surface quenchers is strongly connected to the decrease of the downconversion e…
EPR characterization of erbium in glasses and glass ceramics
2020
Electron paramagnetic resonance (EPR) is a well-established spectroscopic technique for electronic structure characterization of rare-earth ion impurities in crystalline and amorphous hosts. EPR spectra of erbium-doped glass matrices and nanocomposites can provide information about local structure variations induced by changes in chemical composition or crystallization processes. Characterization possibilities of Er3+ ions in glasses and glass ceramics including direct EPR measurements, indirect investigations via secondary paramagnetic probes, and optically detected magnetic resonance techniques are considered in this article. ----/ / /---- This is the pre-print of the following article: A…
The rate of polymerization in two loci reaction systems: VDF-HFP precipitation copolymerization in supercritical carbon dioxide
2011
When the copolymerization of vinylidene fluoride (VDF) and hexafluoropropylene (HFP) is carried out in supercritical carbon dioxide (scCO 2) under heterogeneous conditions, the reaction occurs both in the continuous CO 2-rich phase and in the dispersed polymer-rich phase. The two phases being characterized by different values of reactant concentrations and kinetic parameters, one would expect that the reaction kinetics is affected by the polymer phase holdup in the reactor. However, the reaction rate is almost insensitive to the amount of produced polymer, at least at specific reaction conditions. This apparent contradiction is discussed and clarified in this paper by a series of comparativ…
Proton Transport in Membranes Prepared from Sulfonated Polystyrene-Poly(vinylidene fluoride) Blends
2001
The preparation of new cation-exchange membranes from polymer composites based on poly(vinylidene fluoride), sulfonated polystyrene-co-divinylbenzene, and antimonic acid is reported. The thermal properties of the composites have been characterized by differential scanning calorimetry. Values of the transport number of protons in the membranes were obtained from the observable electric potential. It is defined from the potential difference measured between the electrodes reversible to one of the constituent ions in equilibrium with the system. When compared with Nafion cation-exchange membranes, the membranes described in this work exhibit interesting proton transport properties that could m…
Assessment of the electrochemical behaviour of Nickel-Titanium-based orthodontic wires: Effect of some natural corrosion inhibitors in comparison wit…
2019
Background The aim of this study is to assess the corrosion resistance behaviour of Nickel-Titanium-based orthodontic wires (NiTi) in different concentrations of Sodium Fluoride (NaF) and the corrosion's inhibitory effect of the extracts of some medicinal plants (essential oils, hydrosols and extract). Material and methods In this study we used NiTi (3M) and CuNiTi (ORMCO, 35°C, California) orthodontic wires. The following electrolytes were prepared: Lactate Ringer solution with additions of 0.1%, 0.5% or 1% of Sodium Fluoride and the extracts of different plants: Artemisia, Syzygium aromaticum (Clove) and Celtis australis. Corrosion resistance was studied using anodic potentiodynamic polar…