Search results for "Forensic engineering"

Temporary Employment in the Nordic Countries: A `Trap' or a `Bridge'?

1993

More about the developing of invisible lipstick-contaminated lipmarks on human skin: The usefulness of fluorescent dyes

2006

At the present time fingerprints are one of the simplest, and most reliable means of identification. Increasingly, crime scene investigators look for palm, foot, ear or lip prints. With regard to lip prints, the use, very common today, of protective or permanent lipsticks allow the production an invisible lipmark (or invisible lipstick-contaminated lipmark) which is possible to develop. Some results have already been published about developers useful for different kinds of surfaces (both porous and non-porous) as well as those which are more efficient in case of old or recent prints. The latest studies are about the developing on human skin, and they prove the usefulness of lysochromes (spe…

Temperature Coefficients of Compensated Silicon Solar Cells – Influence of Ingot Position and Blend-in-ratio

2015

Published version of an article in the journal: Energy Procedia. Also available on Science Direct: http://dx.doi.org/10.1016/j.egypro.2015.07.004 Solar-grade silicon made from a metallurgical route presents boron and phosphorus compensation. Earlier work has shown that cells made from such material produce more energy than reference polysilicon modules when the temperature and irradiance is high. In the present study, solar cells from two different ingots with different blend-in-ratios were made from wafers at varying ingot heights in order to investigate how the temperature coefficients vary with compensation level and ingot height. The results suggest that solar modules made with solar ce…

1990

This lecture summarizes some recent results and ideas about interrelations between degradation and mechanical behaviour of polyolefins. Aspects of the heterogeneous nature of oxidative degradation in the solid state, the feedback mechanism in degradation, effects of morphology, particularly orientation, on the degradation process, and the influence of degradation on plasticity and on the ultimate mechanical behaviour are discussed.

Master curves of viscoelastic behavior in the plastic region of a solid polymer

1977

Stress relaxation and creep tests following strain ramps were made on Mylar, both above and below the yield stress. The ramp velocity was varied over a 40-fold range. All data exhibit nonlinear viscoelastic behavior. However, those obtained above the yield point, i.e., in the plastic region, could be reduced to single master curves for both the creep and the relaxation tests by means of a simple time shift factor. This factor is inversely proportional to the strain rate existing just prior to the test.

No-Flow Temperature in Injection Molding Simulation

2010

Most injection molding simulation packages use the no-flow temperature (NFT) as a means of determining whether the polymer flows or is solid. The NFT is not well defined, and a standard method for measuring it does not exist. A sensitivity analysis of the filling stage has been carried out with two different packages [VISI Flow (Vero Software Limited, Gloucestershire, UK) and Moldflow (Autodesk, Inc., San Rafael, CA)] to estimate the influence of the NFT on the main processing parameters. The NFT has a large influence on the thickness of the frozen layer, but it does not appreciably affect the filling pressure. Because the NFT affects the frozen layer, an effect on the estimation of shrinka…

Effectiveness of Preservative Treatments on Coloured Ruditic Building Stones

2009

:  The dark grey Breccia di Billiemi and the Ammonitico Rosso of Piana degli Albanesi, two coloured stones widely used in monuments both outdoor and indoor in Sicily, undergo significant decay as effect of weathering: colour change and development of surface microcracks which affect not only the chromatic aspect but also the state of aggregation. In a previous study (Fracture and Failure of Natural Building Stones, 2006, Springer, Dordrecht, The Netherlands: 329), such effects were successfully reproduced on laboratory samples by means of artificial accelerated weathering and the different response of veins and grains to the ageing agents was related to the microstructure of stones. In this…

Linear ViscoElastic (LVE) Behaviour of Pure Bitumen via Fractional Model

2012

AbstractBy fitting experimental data from static creep/recovery carried out on pure bitumen, it is shown that the fractional model proposed enables the description of both creep and recovery behaviour with fewer parameters than those needed by other models in the literature. In particular, the model is fitted to experimental data of complex modulus |G*| and phase angle δ° obtained from Dynamic Mechanical Analysis. Lastly, it is demonstrated that when the fractional model is used, complex modulus isotherms for a range of frequencies can be created simply starting from isochronals at f = 1Hz.

The Effect of Damage Functions on Urban Flood Damage Appraisal

2014

Flooding damage appraisal can been obtained by interpolating real damage data caused by historical flooding events or accounting the effects of a flood in terms of the depreciation of assets. Most often, the expected damage is evaluated by means of damage functions describing the relationship occurring between the damage and hydraulic characteristics of flood. The present paper aims to evaluate the uncertainty linked to the choice of the depth-damage function adopted in the flood damage analysis. Several possible depth-damage function formulations were selected in literature and applied to historical flooding events monitored in the "Centro Storico" catchment in Palermo (Italy). (C) 2013 Th…

Accelerated Light-Induced Defect Transformation Study of Elkem Solar Grade Silicon

2012

AbstractSolar cells made of silicon feedstock from a metallurgical route must qualify not only the initial efficiency, but must also be comparable to the solar cells made from reference polysilicon on the spectral response after light induced degradation. A detailed comparative study of light induced defects and its impact on cell performance is necessary for both materials. We have studied accelerated light induced degradation (ALID) defect transformation for Elkem Solar Silicon and polysilicon solar cells by selecting wafers from different positions from respective silicon bricks. Active boron-oxygen complexes and iron ions in multicrystalline silicon solar cells have been analyzed, and t…