Search results for "Forming"
showing 10 items of 1719 documents
Robust Transmit Beamforming for Underlay D2D Communications on Multiple Channels
2020
Underlay device-to-device (D2D) communications lead to improvement in spectral efficiency by simultaneously allowing direct communication between the users and the existing cellular transmission. However, most works in resource allocation for D2D communication have considered single antenna transmission and with a focus on perfect channel state information (CSI). This work formulates a robust transmit beamforming design problem for maximizing the aggregate rate of all D2D pairs and cellular users (CUs). Assuming complex Gaussian distributed CSI error, our formulation guarantees probabilistically a signal to interference plus noise ratio (SINR) above a specified threshold. In addition, we al…
Reliable Underlay D2D Communications over Multiple Transmit Antenna Framework
2020
Robust beamforming is an efficient technique to guarantee the desired receiver performance in the presence of erroneous channel state information (CSI). However, the application of robust beamforming in underlay device-to-device (D2D) communication still requires further investigation. In this paper, we investigate resource allocation problem for underlay D2D communications by considering multiple antennas at the base station (BS) and at the transmitters of D2D pairs. The proposed design problem aims at maximizing the aggregate rate of all D2D pairs and cellular users (CUs) in downlink spectrum. In addition, our objective is augmented to achieve a fair allocation of resources across the D2D…
Relay selection in FDD amplify-and-forward cooperative networks
2017
In this paper, the problems of relay selection and distributed beamforming are investigated for bi-directional dual-hop amplify-and-forward frequency-division duplex cooperative wireless networks. When using individual per-relay maximum transmission power constraint, it has been proven that the relay selection and beamforming optimization problem becomes NP hard and requires exhaustive search to find the optimal solution. Therefore, we propose a computationally affordable sub-optimal multiple relay selection and beamforming optimization scheme based on the l1 norm squared relaxation. The proposed scheme performs the selection for the two transmission directions, simultaneously, while aiming…
Real-time Sound Source Localization on an Embedded GPU Using a Spherical Microphone Array
2015
Abstract Spherical microphone arrays are becoming increasingly important in acoustic signal processing systems for their applications in sound field analysis, beamforming, spatial audio, etc. The positioning of target and interfering sound sources is a crucial step in many of the above applications. Therefore, 3D sound source localization is a highly relevant topic in the acoustic signal processing field. However, spherical microphone arrays are usually composed of many microphones and running signal processing localization methods in real time is an important issue. Some works have already shown the potential of Graphic Processing Units (GPUs) for developing high-end real-time signal proce…
Clustering-Assisted 3D Beamforming for Throughput Maximization in mmWave Networks
2021
Beamforming schemes have been widely used to improve network throughput in 5G mmWave networks. However, 3D beamforming schemes have hereto not been investigated in this context. In this work, a cluster-assisted 3D beamforming scheme is proposed to optimize the downtilt angle for network coverage and throughput maximization. User Equipment (UEs) are clustered based on inter-user and the inter-cluster distances. The interference is accounted from the adjacent clusters and thus frequency resources can be assigned to the non-adjacent clusters. Optimal downtilt angles are obtained for every cluster to maximize the throughput while considering the interference from adjacent clusters. 3D beam patt…
Coordination in a multi-cell multi-antenna multi-user W-CDMA system: a beamforming approach
2008
The problem of designing joint power control and optimal beamforming (JPCOB) algorithms for the downlink of a coordinated multi-cell WCDMA system is considered throughout this paper. In this case, the JPCOB design is formulated as the problem of minimizing the total transmitted power in the coordinated multi-cell system, subject to a certain quality of service requirement for each user. In this paper, the performance of two JPCOB algorithms based on different beamforming approaches is compared over the coordinated multi-cell system. The first one, obtains local beamformers by means of the well-known virtual uplink-downlink duality. In contrast, the second algorithm implements multi-base bea…
Enable concurrent transmissions with beamforming for broadband wireless access in CSMA/CA-based WLANs
2014
In CSMA/CA based wireless local networks, two stations are not allowed to transmit at the same time due to interference generated to each other, resulting in degraded throughput. Concurrent transmission, which enables simultaneous transmission of two or more stations under certain conditions, is able to overcome this problem, leading to enhanced channel utilization efficiency. Different from earlier work on this topic which focuses on omni-direction concurrent transmission, we introduce in this paper beamforming into a co-channel concurrent transmission scheme and investigate the benefits of concurrency with beamforming. The circumstances for concurrent transmission and frame scheduling are…
Multi-aperture beamforming for automated large structure inspection using ultrasonic phased arrays
2019
Increasing the inspection quality and speed is essential in manufacturing applications, especially for large structures (e.g. modern aircrafts). Traditional ultrasonic manual scanning can be comprehensive, but lacks repeatability and is time-consuming. Several robotic non-destructive testing systems have been developed in recent years. Although high inspection rates have been achieved by the use of robotic arms, there is the need to furtherly increase the inspection speeds, to cope with the current industrial demands. For systems delivering robotic ultrasonic inspection through phased array probes, the current bottleneck is given by the time required to electrically fire all elements of the…
Stochastic Collaborative Beamforming in Wireless Sensor Networks
2018
Wireless Sensor Networks (WSNs) are composed of spatially distributed autonomous sensor devices, named motes. These devices are constituted by a microcontroller, sensors, and they have the ability to communicate in the ISM frequency band using the IEEE 802.15.4 standard. They have their own power supply, AA or AAA batteries, processing unit, sensors and wireless communications. Usually, the motes exchange packets using a multihop routing, and the maximum communication distance emitter-receiver is around 100m. At least one mote acts as a gateway, and the data gathered by the sensors of each mote have to be sent to this mote that is named sink or Base Station (BS). In a WSN the BS is within t…
Final Results of a Phase I/II Trial of the Combination Bendamustine and Rituximab With Temsirolimus (BeRT) in Relapsed Mantle Cell Lymphoma and Folli…
2020
Abstract. In this phase I/II study, we explored the combination of Temsirolimus with Bendamustine and Rituximab (BeRT) in patients with relapsed or refractory (r/r) follicular lymphoma (FL) or mantle cell lymphoma (MCL). Patients with 1 to 3 previous therapies received Bendamustine (90 mg/m2, day 1 + 2) and Rituximab (375 mg/m2, day 1) with Temsirolimus in doses from 25 to 75 mg in phase I and 50 mg Temsirolimus in phase II, added on day 1, 8, 15 of a 28 days cycle. The primary endpoint of the phase II was ORR at the end of treatment. Overall, 39 (29 MCL, 10 FL) patients were included. Median age was 71 years and median pretreatment number was 2. Grade 3/4 non-hematologic adverse events wer…