Search results for "Fractional calculus"

THE MECHANICAL MODEL OF FRACTIONAL VISCOELASTICITY

2010

Viscoelastic materials have been more and more used nowadays for their low-cost productions as well as for their dissipative capabilities that may be coupled with others, more performing materials, to form complex-type engineering elements. The main feature of viscoelastic behavior is the relaxation of the stress state and the creep of the strain field that may be experienced, respectively, in hard or soft test devices. Such phenomenological consideration has been extensively analyzed yet at the beginning of the twentieth century and simple rheological models representing linear, constitutive, stress-velocity relations of the studied material have been proposed. Moreover the rheological rel…

Visco-elastic behavior through fractional calculus: an easier method for best fitting experimental results

2011

In capturing visco-elastic behavior, experimental tests play a fundamental rule, since they allow to build up theoretical constitutive laws very useful for simulating their own behavior. The main challenge is representing the visco-elastic materials through simple models, in order to spread their use. However, the wide used models for capturing both relaxation and creep tests are combinations of simple models as Maxwell and/or Kelvin, that depend on several parameters for fitting both creep and relaxation tests. This paper, following Nutting and Gemant idea of fitting experimental data through a power law function, aims at stressing the validity of fractional model. In fact, as soon as rela…

CROSS-POWER SPECTRAL DENSITY AND CROSS-CORRELATION REPRESENTATION BY USING FRACTIONAL SPECTRAL MOMENTS

2012

Filter equation by fractional calculus

2014

Aim of this paper is to represent a causal filter equation for any kind of linear system in the general form L=f(t), where f(t) is the forcing function, x(t) is the output and L is a summation of fractional operators. The exact form of the operator L is obtained by using Mellin transform in complex plane.

Characterization of the dynamic behaviour of flax fibre reinforced composites using vibration measurements

2017

International audience; Experimental and numerical methods to identify the linear viscoelastic properties of flax fibre reinforced epoxy (FFRE) composite are presented in this study. The method relies on the evolution of storage modulus and loss factor as observed through the frequency response. Free-free symmetrically guided beams were excited on the dynamic range of 10 Hz to 4 kHz with a swept sine excitation focused around their first modes. A fractional derivative Zener model has been identified to predict the complex moduli. A modified ply constitutive law has been then implemented in a classical laminates theory calculation (CLT) routine.

Extended fractional-order Jeffreys model of viscoelastic hydraulic cylinder

2020

A novel modeling approach for viscoelastic hydraulic cylinders, with negligible inertial forces, is proposed, based on the extended fractional-order Jeffreys model. Analysis and physical reasoning for the parameter constraints and order of the fractional derivatives are provided. Comparison between the measured and computed frequency response functions and time domain transient response argues in favor of the proposed four-parameter fractional-order model.

Stability analysis of Beck's column over a fractional-order hereditary foundation

2018

This paper considers the case of Beck's column resting on a hereditary bed of independent springpots. The springpot possesses an intermediate rheological behaviour among linear spring and linear dashpot. It is defined by means of couple ( C β ,  β ) that characterize the material of the element and is ruled by a Caputo's fractional derivative. In this paper, we investigate the critical load of the column under the action of a follower load by means of a novel complex transform that allows to use the Routh–Hurwitz theorem in the complex half-plane for the stability analysis.

On the fractional probabilistic Taylor's and mean value theorems

2016

In order to develop certain fractional probabilistic analogues of Taylor's theorem and mean value theorem, we introduce the nth-order fractional equilibrium distribution in terms of the Weyl fractional integral and investigate its main properties. Specifically, we show a characterization result by which the nth-order fractional equilibrium distribution is identical to the starting distribution if and only if it is exponential. The nth-order fractional equilibrium density is then used to prove a fractional probabilistic Taylor's theorem based on derivatives of Riemann-Liouville type. A fractional analogue of the probabilistic mean value theorem is thus developed for pairs of nonnegative rand…

A discrete mechanical model of fractional hereditary materials

2013

Fractional hereditary materials are characterized for the presence, in the stress-strain relations, of fractional-order operators with order beta a[0,1]. In Di Paola and Zingales (J. Rheol. 56(5):983-1004, 2012) exact mechanical models of such materials have been extensively discussed obtaining two intervals for beta: (i) Elasto-Viscous (EV) materials for 0a parts per thousand currency sign beta a parts per thousand currency sign1/2; (ii) Visco-Elastic (VE) materials for 1/2a parts per thousand currency sign beta a parts per thousand currency sign1. These two ranges correspond to different continuous mechanical models. In this paper a discretization scheme based upon the continuous models p…

Exact mechanical models of fractional hereditary materials

2012

Fractional Viscoelasticity is referred to materials, whose constitutive law involves fractional derivatives of order β R such that 0 β 1. In this paper, two mechanical models with stress-strain relation exactly restituting fractional operators, respectively, in ranges 0 β 1 / 2 and 1 / 2 β 1 are presented. It is shown that, in the former case, the mechanical model is described by an ideal indefinite massless viscous fluid resting on a bed of independent springs (Winkler model), while, in the latter case it is a shear-type indefinite cantilever resting on a bed of independent viscous dashpots. The law of variation of all mechanical characteristics is of power-law type, strictly related to th…