Search results for "Front and back ends"
showing 2 items of 12 documents
The Performance of Belle II Data Acquisition System in the First Physics Run
2019
The Belle II experiment is a new generation B-factory experiment at KEK in Japan aiming at the search for New Physics in a huge sample of B-meson dacays. The commissioning of the SuperKEKB accelerator was started in 2017 (Phase 1), and then a pilot run with outer detectors was performed in 2018 (Phase 2). From March this year, an operation with the full detector has been started for the physics data taking (Phase 3). The Belle II data acquisiton system (DAQ) is now fully working in the Phase 3 run. The system consists of the trigger timing distribution system, the common readout modules (COPPER) with the unified optical data link to the detector front end, the readout PCs and the network sw…
Development of the optical multiplexer board prototype for data acquisition in TileCal experiment
2005
The optical multiplexer board is one of the elements present in the read out chain of the tile calorimeter in ATLAS experiment. Due to radiation effects, two optical fibers with the same data come out from the front end boards to this board, which has to decide in real time which one carries good data and pass them to the read out driver motherboard for processing. This paper describes the design and tests of the first prototype, implemented as a 6U VME64x slave module, including both hardware and firmware aspects. In this last, algorithms for cyclic redundancy code checking are used to make the decision. Besides, the board may be used as a data injector for testing purposes of the read out…