Search results for "Furnace"

showing 10 items of 44 documents

Microscopy studies of the surface of high-temperature superconductor films

1997

The surface morphology is studied by use of optical and electron microscopes with respect to production regime (rate and temperature of crystallization) of the 50 - 125 micrometer thick doped YBa 2 Cu 3 O 7 films obtained by Stokes sedimentation on SrTiO 3 ceramic substrate (size 20 mm by 5 mm by 0.5 mm) and firing in air or oxygen following the MTG procedure, performed in the gradient tube furnace. Evolution of thick film structure with regard to temperature and cooling rate is studied.

SuperconductivityHigh-temperature superconductivityMaterials scienceDopingAnalytical chemistrylaw.inventionMicrometrelawvisual_artMicroscopyvisual_art.visual_art_mediumTube furnaceCeramicCrystallizationSPIE Proceedings
researchProduct

Design of temperature control system using conventional PID and Intelligent Fuzzy Logic controller

2015

In this paper, we present the design of temperature control for industrial heat treating furnace by using Intelligent Fuzzy Logic and PID controllers. Temperature control is important in heating processes as it can disqualify materials in terms of their physical properties when not well performed. Obviously PID temperature controller is the most used in industries to control non-linear processes. Consequently, it has been found that the output response from Fuzzy Logic is very accurate in terms of overshoot and steady state error when compared to that of PID. Moreover, both temperature controllers are modeled and simulated using MATLAB software.

Temperature controlController; Furnace; Fuzzy Logic; PID; Temperature; Artificial Intelligence; Control and Optimization; Discrete Mathematics and CombinatoricsControl and OptimizationComputer sciencePIDTemperaturePID controllerFurnaceControl engineeringFuzzy control systemFuzzy logicControllerFuzzy LogicControl theoryArtificial IntelligenceControl systemOvershoot (signal)Process controlDiscrete Mathematics and Combinatorics
researchProduct

Oral intake of cadmium, cobalt, copper, iron, lead, nickel, manganese and zinc in the university student's diet.

1993

A duplicate diet meal study was carried out with a group of university students living in a hostel, in order to estimate the intake of Zn, Cd, Co, Cu, Fe, Mn, Ni and Pb. Zn, Cu, Fe, Mn and Ni were determined by flame atomic absorption spectrophotometry and Cd, Co and Pb by graphite furnace atomic absorption spectrophotometry after a nitric acid wet digestion procedure. The estimated intake values from the contents of breakfast, lunch, dinner and drinks were compared with the values of the Provisional Tolerable Daily Intake (PTDI) in the case of Cd and Pb, Recommended Dietary Allowances (RDA) of Co, Fe and Zn and Estimated Safe and Adequate Dietetic Daily Intake (ESADDI) of Cu and Mn. Neithe…

Tolerable daily intakeMealCadmiumUniversitiesSpectrophotometry AtomicMetallurgychemistry.chemical_elementNutritional StatusFood ContaminationZincManganeselaw.inventionDietTrace ElementschemistrylawSpainHumansAtomic absorption spectroscopyGraphite furnace atomic absorptionStudentsCobaltFood AnalysisFood ScienceNuclear chemistryDie Nahrung
researchProduct

The wettability of ash from burned vegetation and its relationship to Mediterranean plant species type, burn severity and total organic carbon content

2011

Abstract Immediately following a wildfire, a layer of ash and charred material typically covers the ground. This layer will gradually be reduced, being redistributed by rainfall, wind or animals, by partial dissolution and by incorporation into the soil. Ash can increase or decrease the post-fire runoff and erosion response, depending upon the soil and ash properties and the ash thickness. One aspect of ash that has remained unknown and which may affect the variability in the hydrological response of the burned soil is its wettability. This study examines the wettability of ash using the Water Drop Penetration Time (WDPT) test, its relationship with total organic carbon (TOC) content and co…

Total organic carbonMediterranean climatebiologySoil ScienceSoil sciencebiology.organism_classificationCombustionEnvironmental chemistryVegetation typeEnvironmental scienceMuffle furnaceQuercus cocciferaSurface runoffDissolution
researchProduct

Detection of bias errors in ETAASDetermination of copper in beer and wine samples

2005

A method that evidences changes in the shape of the absorbance profiles obtained by graphite furnace atomic absorption spectrometry (ETAAS) is proposed. The method is based upon the apparent content curves model previously described for molecular spectroscopy and it permits the detection of possible sources of bias errors. Moreover, a procedure that allows to detect the existence of constant and/or proportional errors is also described. Both models has been applied to the determination of copper in wine and beer samples with and without pre-treatment of the samples. Results obtained evidence the usefulness of the proposed models.

WineObservational errorChemistryAnalytical chemistrychemistry.chemical_elementMolecular spectroscopyMass spectrometryCopperAnalytical Chemistrylaw.inventionAbsorbancelawAtomic absorption spectroscopyGraphite furnace atomic absorptionTalanta
researchProduct

Determination of lead on the airborne particulates of urban Valencia city

1991

A method for the determination of lead in airborne particulates by graphite furnace atomic absorption spectrometry after extraction with HCl-HNO3 (120–150°C) is described. Particulate lead levels in the atmosphere have been measured in samples collected throughout a year, sampling has been made at eleven sites within the city of Valencia. The results obtained in this study show that annual means of lead levels are within the range of 0.526 to 7.033 μg/m3 depending upon the sampling site. Lead levels are higher in winter and autumn. Lead and nitrogen oxide levels are well correlated.

biologyChemistryLead (sea ice)Sampling (statistics)Particulatesbiology.organism_classificationBiochemistryAnalytical ChemistryAtmospherechemistry.chemical_compoundEnvironmental chemistryNitrogen oxideGraphite furnace atomic absorptionValenciaFresenius' Journal of Analytical Chemistry
researchProduct

Pyrolysis gas chromatography-mass spectrometry in environmental analysis: Focus on organic matter and microplastic

2020

Pyrolysis gas chromatography-mass spectrometry (Py-GC-MS) has great potential within environmental analysis. This technique is mainly used for the chemical identification of macromolecules that cannot be characterized by either liquid or gas chromatography due to their big size. Through pyrolysis (controlled thermal degradation), these macromolecules are broken down into simpler molecules that can be separated by gas chromatography and detected by mass spectrometry. This technique has been traditionally used in environmental samples for the characterization of organic matter and humic substances, contaminants, lignins, etc. It attains the identification of the different types of chemical un…

chemistry.chemical_classificationMicroplasticsCurie-pointEnvironmental analysisEvolved gas analysisChemistry010401 analytical chemistryMass spectrometry01 natural sciences0104 chemical sciencesAnalytical ChemistryFilamentsPyrolysis–gas chromatography–mass spectrometryEnvironmental chemistryReactive pyrolysisOrganic matterEvolved gas analysisGas chromatographyPyrolysisMicrofurnacesSpectroscopy
researchProduct

A data-driven surrogate-assisted evolutionary algorithm applied to a many-objective blast furnace optimization problem

2017

A new data-driven reference vector-guided evolutionary algorithm has been successfully implemented to construct surrogate models for various objectives pertinent to an industrial blast furnace. A total of eight objectives have been modeled using the operational data of the furnace using 12 process variables identified through a principal component analysis and optimized simultaneously. The capability of this algorithm to handle a large number of objectives, which has been lacking earlier, results in a more efficient setting of the operational parameters of the furnace, leading to a precisely optimized hot metal production process. peerReviewed

data-driven optimizationPareto optimalityEngineeringBlast furnaceMathematical optimizationOptimization problemmodel managementblast furnaceEvolutionary algorithm02 engineering and technologyMulti-objective optimizationIndustrial and Manufacturing Engineering020501 mining & metallurgyData-drivenironmakingoptimointi0202 electrical engineering electronic engineering information engineeringGeneral Materials Scienceta113business.industrypareto-tehokkuusMechanical EngineeringProcess (computing)metamodelingMetamodeling0205 materials engineeringmulti-objective optimizationMechanics of MaterialsPrincipal component analysis020201 artificial intelligence & image processingbusinessrautateollisuus
researchProduct

The brick furnace of Pisciotto Country, in Scicli: an example of "human disaster"

2017

La fornace in contrada Pisciotto in Scicli: un esempio di "disastro umano" La Fornace Penna in Contrada Pisciotto, a Scicli è oggi un imponente ed elegante rudere dalla suggestiva bellezza, sfiorita e mortificata dal trascorrere del tempo e dall’incuria dell’uomo. Lo splendido paesaggio che faceva da sfondo al manufatto, è oggi deturpato da costruzioni abusive e da villaggi turistici ad alta ricettività; mentre lo sperone roccioso dal quale un giorno svettava l’alta ciminiera, si è trasformato in "luogo del cinema", vincolo che insieme a molti altri in realtà poco hanno fatto per la salvaguardia di questo bene. Il tempo sembra essersi fermato ad una notte di fine gennaio del 1924 (forse 192…

industrial archeology cultural heritage brick furnace Scicli.archeologia industriale eredità culturale fornace di laterizi ScicliSettore ICAR/12 - Tecnologia Dell'Architettura
researchProduct

Evaluation of Antimony, Cadmium and Lead Levels in Vegetables, Drinking and Raw Water from Different Agricultural Areas

1990

Abstract Lead and cadmium levels in edible vegetables and antimony, lead and cadmium in drinking and raw waters from three agricultural areas exposed to different levels of environmental pollution (1-high industrial pollution, 2-high urban pollution, 3-standard low industrial and urban pollution) are determined. The organic matter is destroyed by repeated attack with nitric acid. Cadmium and lead are determined by graphite furnace atomic absorption spectrometry (GFAAS) and antimony by hydride generation atomic absorption spectrometry (HGAAS). When the results obtained for three different areas are compared, differences between cadmium and lead contents in vegetables are observed. Waters are…

inorganic chemicalsPollutionchemistry.chemical_classificationCadmiumHealth Toxicology and Mutagenesismedia_common.quotation_subjectPublic Health Environmental and Occupational HealthSoil Sciencechemistry.chemical_elementEnvironmental pollutionPollutionAnalytical Chemistrylaw.inventionchemistryAntimonylawEnvironmental chemistryEnvironmental ChemistryOrganic matterRaw waterGraphite furnace atomic absorptionAtomic absorption spectroscopyWaste Management and DisposalWater Science and Technologymedia_commonInternational Journal of Environmental Analytical Chemistry
researchProduct