Search results for "Generator"
showing 10 items of 426 documents
Low-noise microvolt level calibrator for measurement of performance of biosignal recording systems
1997
A calibrator, the noise level of which is below the noise level generated in the preamplifier system, was needed for testing and development of a multichannel recording system. A multichannel preamplifier head assembly was used for recording cortical, subcortical, and cerebellar slow potentials and multiunit activity in freely moving cats and restrained rabbits. An inexpensive, battery-powered, lownoise voltage signal generator for calibration of the preamplifiers is described. The circuit provides a square-wave output at a frequency of 10 or 1000 Hz, and the peak-to-peak (p-p) amplitude can be selected at 10, 100, or 1000µV. The measured output noise of the calibrator is below 2µV (p-p, 0.…
Photonically assisted RF generator with incoherent sources
2008
An RF waveform generator operating with incoherent broadband light is successfully implemented. Complex RF ~10 GHz bandwidth waveforms are generated by means of incoherent wavelength-to-time mapping. Our technique can be scaled to the mm-wave range.
Reconfigurable RF waveform generation using optical incoherent sources
2008
An RF waveform generator operating with incoherent broadband light is successfully implemented. Complex RF ~10 GHz bandwidth waveforms are generated by means of incoherent wavelength-to-time mapping. Our technique can be scaled to the mm-wave range.
20 GHz arbitrary radio-frequency waveform generator based on incoherent pulse shaping
2008
We demonstrate a new approach of photonically assisted radiofrequency (RF) waveform generation using a spectrally incoherent light source. The system is based on the so-called generalized frequency-to-time mapping operation. In this work, external modulation of the source is done by concatenating two electro-optic Mach-Zehnder modulators properly biased to achieve short pulse gates which allow for broad bandwidth electrical signals. Also, the spectral shaping stage is performed prior to O/E conversion. A detailed theoretical analysis demonstrates that even in this case the frequency-to-time mapping is preserved. The key is that the noise level is greatly reduced because the amplitude filter…
Design and Performance of a High Temperature Superconducting Axial Flux Generator
2013
In this paper, a high temperature axial flux (HTSAF) generator is presented. In this generator the excitation of the generator is obtained by using some high temperature superconducting magnets. In order to reduce the negative effects of vibrations, the excitation is located on the stationary part of the generator. Starting, running and endurance tests of the machine are presented.
Quantum Computing: A Way to Break Complexity?
2003
The perception of time is given by the happening of some events that determines a variation in the state of the observed system. In this sense a computation, i.e. a set of well defined transformations that, starting from an initial state (the input) brings to a final state (the output), can be considered a time generator. Each ticking of the clock corresponds to the computer changes of its states. The speed of computation leads to a different perception of time as well as traveling by airplanes changed the perception of spatial distances.
A sliding mass wave energy converter
2019
This paper presents a wave energy converter which is based on a sliding mass coupled to a linear generator. In order to maximize energy extraction, the stochastic features of the energy source has been included in the mathematical model of the system in order to satisfactorily tackle the problem. The results of several simulations are presented.
Numerical simulation of a wawe generator: A case of study
2013
The aim of present work is the numerical simulation of a linear generator, capable of directly converting the kinetic energy, available by the wave, into electrical energy, through the device linear motion (up and down). In this paper, we intend to propose a numerical simulation approach to immersed devices by applying the Immersed Boundary Method. The Theory of linear wave is used to study and reproduce sea conditions and the computational domain is created based on observations available for the site in which it is envisaged the positioning of the device.
40-GHz photonic waveform generator by linear shaping of four spectral sidebands
2015
International audience; We show that the amplitude and phase shaping of only four sidebands of the optical spectrum is sufficient to synthesize parabolic, triangular, or flat-top pulse trains at high repetition rates. Selection of the symmetric carrier-suppressed waveform is easily achieved by changing the phase difference between the inner and outer spectral lines. Experiments carried out at a repetition rate of 40 GHz confirm the high quality of the intensity profiles that are obtained.
Arbitrary Waveform Generator Based on All-Incoherent Pulse Shaping
2006
An all-incoherent technique for the generation of arbitrary electromagnetic intensity profiles is presented. It is based on spectral filtering of a broadband continuous-wave light source so that the filtered spectral density function (SDF) becomes the user-defined waveform. After large temporal modulation and subsequent distortion in a first-order dispersive medium, the incoherent mapping of the filtered SDF to the time domain occurs. Finally, optical-to-electrical conversion in a fast photodiode allows the optical intensity to be mapped into the electrical domain