Search results for "Geomatic"
showing 10 items of 506 documents
Optimizing and comparing gap-filling techniques using simulated NDVI time series from remotely sensed global data
2019
Abstract NDVI (Normalized Difference Vegetation Index) time series usually suffer from remaining cloud presence, even after data pre-processing. To address this issue, numerous gap-filling (or reconstruction) techniques have been developed in the literature, although their comparison has mainly been local to regional, with only two global studies to date, and has led to sometimes contradictory results. This study builds on these different comparisons, by testing different parameterizations for five NDVI temporal profile reconstruction techniques, namely HANTS (Harmonic Analysis of Time Series), IDR (iterative Interpolation for Data Reconstruction), Savitzky-Golay, Asymmetric Gaussian and Do…
Intercomparison of remote-sensing based evapotranspiration algorithms over amazonian forests
2019
Abstract Evapotranspiration (ET) is considered a key variable in the understanding of the Amazonian tropical forests and their response to climate change. Remote-Sensing (RS) based evapotranspiration models are presented as a feasible means in order to provide accurate spatially-distributed ET estimates over this region. In this work, the performance of four commonly used ET RS models was evaluated over Amazonia using Moderate Resolution Imaging Spectroradiometer (MODIS) data. RS models included i) Priestley-Taylor Jet Propulsion Laboratory (PT-JPL), ii) Penman-Monteith MODIS operative parametrization (PM-Mu), iii) Surface Energy Balance System (SEBS), and iv) Satellite Application Facility…
Near real-time estimation of Sea and Land surface temperature for MSG SEVIRI sensors
2020
Abstract Land and Sea Surface Temperatures (LST and SST) are both recognized as Essential Climate Variables, and are routinely retrieved by a wealth of satellites. However, for validated approaches, the latest data are usually not available to the general public. We offer to bridge this gap, by using Meteosat Second Generation (MSG) Spinning Enhanced Visible and InfraRed Imager (SEVIRI), with its 15 min temporal resolution. Here, we present generic algorithms for the retrieval of both LST and SST, valid for the SEVIRI instrument onboard MSG platforms 8–11, which we validate using hourly data of 4 ground stations and 11 buoys in Spain over the years 2015 to 2018. These validations show that …
Laboratory calibration and field measurement of land surface temperature and emissivity using thermal infrared multiband radiometers
2019
Accurate ground measurements of land surface temperature (LST) are necessary for validating satellite LST products. In order to provide reliable data, ground radiometers must be calibrated with reference to an international standard, and radiometric temperatures must be corrected for land surface emissivity. As opposed to water, land surface emissivity is not usually known for many ground covers, so an emissivity value has to be assumed, assigned from spectral emissivity libraries or measured for each land cover and spectral band considered. The aim of this study is to show the laboratory calibration and the methodology for simultaneous field measurements of LST and emissivity employed in t…
Emissivity mapping over urban areas using a classification-based approach: Application to the Dual-use European Security IR Experiment (DESIREX)
2012
Abstract In this work a methodology to provide an emissivity map of an urban area is presented. The methodology is applied to the city of Madrid (Spain) using data provided by the Airborne Hyperspectral Scanner (AHS) in 2008. From the data a classification map with twelve different urban materials was created. Each material was then characterized by a different emissivity, whose values were obtained from the application of the TES algorithm to in situ measurements and values extracted from the ASTER spectral library. This new emissivity map could be used as a basis for determining the temperature of the city and to understand the urban heat island effect in terms of spatial distribution and…
A methodology to estimate forest fires burned areas and burn severity degrees using Sentinel-2 data. Application to the October 2017 fires in the Ibe…
2021
Abstract A methodology to estimate the extent of areas affected by forest fires, as well as the burn severity levels using Sentinel 2 images (10 and 20 m) is proposed and applied to the fires occurred in October 2017 in Spain and Portugal. An extension larger than 250,000 ha and 4 burn severity levels (low, moderate, high and very high) have been obtained. The comparison with the European Forest Fire Information System (EFFIS), which uses MODIS images (250 m), shows that the methodology improves the area estimate by 10 % in commission area. In terms of burn severity levels, the Separability index (SI) and the Kappa statistic (k) show a high correlation between Sentinel-2 and EFFIS (SI value…
Intercomparison and quality assessment of MERIS, MODIS and SEVIRI FAPAR products over the Iberian Peninsula
2013
Abstract The fraction of absorbed photosynthetically active radiation (FAPAR) is a key variable in productivity and carbon cycle models. The variety of available FAPAR satellite products from different space agencies leads to the necessity of assessing the existing differences between them before using into models. Discrepancies of four FAPAR products derived from MODIS, SEVIRI and MERIS (TOAVEG and MGVI algorithms), covering the Iberian Peninsula from July 2006 to June 2007 are here analyzed. The assessment is based on an intercomparison involving the spatial and temporal consistency between products and a statistical analysis across land cover types. In general, significant differences ar…
Review of the relationship between aggregates geology and Los Angeles and micro-Deval tests
2021
Rock aggregates constitute the enormous volume of inert construction material used around the globe. The petrologic description as igneous, sedimentary, and metamorphic types establishes the intrinsic formation pattern of the parent rock. The engineering properties of these rocks vary due to the differences in the transformation process (e.g. hydrothermal deposits) and weathering effect. The two most common mechanical tests used to investigate the performance of aggregates are the Los Angeles (LA) and micro-Deval (MD) tests. This study reviewed the geological parameters (including mineralogy, grain and crystal size, grain shape, and porosity) and the relationship to Los Angeles and micro-De…
Domain Adaptation of Landsat-8 and Proba-V Data Using Generative Adversarial Networks for Cloud Detection
2019
Training machine learning algorithms for new satellites requires collecting new data. This is a critical drawback for most remote sensing applications and specially for cloud detection. A sensible strategy to mitigate this problem is to exploit available data from a similar sensor, which involves transforming this data to resemble the new sensor data. However, even taking into account the technical characteristics of both sensors to transform the images, statistical differences between data distributions still remain. This results in a poor performance of the methods trained on one sensor and applied to the new one. In this this work, we propose to use the generative adversarial networks (G…
Design of a Generic 3-D Scene Generator for Passive Optical Missions and Its Implementation for the ESA’s FLEX/Sentinel-3 Tandem Mission
2018
During the design phase of a satellite mission, end-to-end mission performance simulator (E2ES) tools allow scientists and engineers evaluating the mission concept, consolidating system technical requirements and analyzing the suitability of the implemented technical solutions and data processing algorithms. The generation of synthetic scenes is one of the core parts of an E2ES, providing scenes (ground truth) as would be observed by satellite instruments and used as reference against simulated retrieved mission products. An appropriate generation of the scene also allows assessing the performance of the ground data processing chain replacing real instrument data before the mission is in or…