Search results for "HETEROGENEOUS PHOTOCATALYSIS"
showing 6 items of 36 documents
Two Dimensional (2-D) Modeling of a Flat Plate Photocatalytic Reactor for Oxidation of Indoor Air Pollutants
2007
In this paper we present a two-dimensional (2-D) analysis of a narrow-slit, flat-plate, single-pass, flow-through photocatalytic reactor for air purification. The continuity equation for convection and diffusion in two dimensions, under un-steady-state conditions, was coupled with radiation field modeling and photocatalytic reaction kinetics to model the transient and steady-state behavior of the reactor. The model was applied to the photocatalytic oxidation of trichloroethylene (TCE) in humidified air streams under different experimental conditions. The kinetic parameters determined by a three-dimensional (3-D) computational fluid dynamics model of the reactor were used in the 2-D model si…
Preface
2019
Preface of the book "Heterogeneous Photocatalysis Relationships with Heterogeneous Catalysis and Perspectives"
COMPARISON OF THE PHOTOCATALYTIC DEGRADATION OF 2-PROPANOL IN GAS-SOLID AND LIQUID-SOLID SYSTEMS BY USING TiO2 – LnPc2 HYBRID POWDERS
2009
Photocatalytic degradation of 2-propanol was carried out as a probe reaction both in gas–solid and in liquid–solid systems in the presence of TiO2 both bare and impregnated with lanthanide (Sm, Gd, Ho) bis-phthalocyanines (LnPc2) used as sensitizers. Continuous and batch photo-reactors, irradiated with an equal flux of photons, were used in gas–solid and in liquid–solid systems, respectively. Propanone and acetaldehyde were the main intermediates found in both systems during 2-propanol oxidation, whereas carbon dioxide and water were the final oxidation products exclusively in the gas–solid regime. The photocatalysts exhibited significantly higher activity in the liquid–solid system than in…
Degradation of 4-nitrophenol (4-NP) using Fe–TiO2 as a heterogeneous photo-Fenton catalyst
2010
Photocatalytic degradation of 4-nitrophenol was investigated using Fe-doped (1, 3, 5 and 8 wt.% Fe) TiO(2) catalysts under UV light irradiation in aqueous dispersions in the presence of H(2)O(2). Photocatalysts with the lowest Fe content (1%) showed a considerably better behavior with respect to the unloaded TiO(2) and the catalysts with higher Fe contents. Photocatalytic degradation was studied under different conditions such as amounts of 1% Fe-TiO(2) catalyst, H(2)O(2) dose and initial pH of 4-NP solution. The results indicated that about 67.53% total organic carbon of a solution containing 20 mg L(-1) 4-NP was removed at pH 6.17 by using 4.9 mM of H(2)O(2) and 0.4 g L(-1) of the catalys…
Photocatalytic oxidation of acetonitrile in gas–solid and liquid–solid regimes
2005
Il programma NON mi ha consentito di scaricare il PDF di questo articolo. Se lo volete ditemi come inviarlo ABSTRACT Photocatalytic degradation of acetonitrile was carried out in both gas–solid and liquid–solid regimes using two commercial TiO2 catalysts (Merck and Degussa P25). For the gas–solid regime, a continuous annular photoreactor was used. The influence on photodegradation kinetics of the gas flow rate and concentrations of acetonitrile, oxygen, and water was investigated. Acetonitrile degradation products detected in the gas phase included carbon dioxide and hydrogen cyanide. The same photoactivity was exhibited in the presence and in the absence of water vapour. The liquid–solid reg…
Photocatalytic degradation of nitrophenols in aqueous titanium dioxide dispersion
1991
Abstract The results are reported of an investigation into the photodegradation of nitrophenol isomers carried out in aqueous titania (anatase) dispersions under various experimental conditions. We investigated the influence of various parameters on the photodegradation rate, such as the concentrations of the catalyst, dissolved oxygen and organic compound, and the presence of various anions in the dispersion. A plausible explanation is proposed for the influence of these parameters, both mechanistic and kinetic factors being accounted for. Gas chromatography and mass spectrometry were used as analytical methods in order to determine intermediate products. Spectroscopic methods (UV-vis and …