Search results for "I.2"

Photocatalysis in dimethyl carbonate green solvent: degradation and partial oxidation of phenanthrene on supported TiO2

2014

Dimethyl carbonate (DMC) is here proposed – for the first time – as a green organic solvent for photocatalytic synthesis. In this work, the photocatalytic partial oxidation of phenanthrene in dimethyl carbonate (DMC) by using anatase TiO2 as the photocatalyst is described as paradigmatic example of a green synthetic process starting from polycyclic aromatic hydrocarbons (PAHs). For comparison, the same reaction carried out also in ethanol, 1-propanol or 2-propanol is reported. The use of DMC as the solvent allowed us to achieve 19% and 23% selectivity towards 9-fluorenone and 6H-benzo[c]chromen- 6-one, respectively. The proposed approach may represent both a new green synthetic process and …

Graphite-supported TiO2 for 4-nitrophenol degradation in a photoelectrocatalytic reactor

2009

WOS: 000274769500044

Nanostructured anatase TiO2 densified at high pressure as advanced visible light photocatalysts

2015

This study reports on characterization and photoactivity of nanostructured TiO2 samples, which have been permanently densified under high pressures, up to 2.1 GPa. Commercial Mirkat 211 anatase has been used as a benchmark sample, in order to investigate the effect of unidirectional high pressure on structural, optical and photocatalytic properties of TiO2. Vibrational Raman spectroscopy shows that the treatment does not cause transitions among the different crystalline phases of titanium dioxide. UV-vis diffuse reflectance spectra reveal that increasing pressure gives rise to a shift of the absorption onset towards higher wavelength enhancing the photoactivity under visible radiation. Samp…

N-Doped Anatase/Rutile Photocatalysts for the Synthesis of Aromatic Aldehydes Under Ultraviolet and Solar Irradiation

2015

N-doped anatase/rutile photocatalysts were prepared by a sol-gel method, using TiCl4 as TiO2 precursor and urea as N-dopant source. The catalysts required a thermal treatment at temperature higher than 300 degrees C to achieve actual nitrogen doping; this treatment also allowed obtaining crystalline and hydrophobic samples. Moreover, nitrogen doping modified the surface of samples by increasing the anatase to rutile phase ratio and hydrophilicity. The catalysts were characterized by BET specific surface area, XRD, ESEM, TGA, FT-IR, DRS and XPS measurements, with particular attention to the assessment of the N-doping effect. It was found that XPS analysis should be used together with DRS and…

Facile preparation of CuBi2O4/TiO2 hetero-systems employed for simulated solar-light selective oxidation of 4-methoxybenzyl alcohol model compound

2023

The selective photocatalytic oxidation of organic substances is today considered one of the green techniques to synthesize important starting materials in different technological applications. This work reports an efficient, simple and cheap strategy for the synthesis of a new photocatalytic CuBi2O4-TiO2 (CBO/TiO2) heterosystem at room temperature. The prepared powders were characterized by X-ray diffraction (XRD), UV–Vis diffuse reflectance spectra (DRS), field-emission scanning electron microscopy (FE-SEM), X-ray photoelectron spectroscopy (XPS), and electrochemical measurements. The photocatalytic activity was evaluated by performing a probe reaction, namely the partial oxidation of 4-me…

Ferulic Acid Oxidation Through Visible Light Induced TiO2 Photocatalysis

2012

Membranes for photocatalysis in wastewater treatment

2011

Photocatalytic oxidation of aromatic alcohols to aldehydes in aqueous suspension of home prepared titanium dioxide: 2. Intrinsic and surface features…

2008

Some intrinsic electronic properties of home prepared (HP) TiO2 catalysts were investigated by diffuse reflectance spectroscopy and quasi-Fermi level measurements. These powders were used for carrying out the photocatalytic oxidation of benzyl alcohol to benzaldehyde and CO2 in water; the selectivity for aldehyde formation was enhanced by the addition of small amounts of ethanol, a typical hole trap. The values of band gap, valence band and conduction band edges are almost identical for all the HP samples in which anatase phase is predominant, whereas appreciable differences can be noticed for an HP sample containing high amount of rutile phase. A comparative ATR-FTIR study of the HP cataly…

Selective photocatalytic oxidation of 4-substituted aromatic alcohols in water with rutile TiO2 prepared at room temperature

2009

WOS: 000264978500012

Determination of Photoadsorption Capacity of Polychrystalline TiO2 Catalyst in Irradiated Slurry

2009

WOS: 000322711800002