Search results for "INTERFACE"
showing 10 items of 2139 documents
Photoelectron lifetime determination of Ag(1 1 1) films at the Fermi surface
2001
The electronic properties of 10 monolayers Ag(111) films deposited onto Si(111)-7 x 7 substrates at room temperature have been studied by scanning the photoelectron intensity at the Fermi level in different symmetry directions. The main features observed in these profiles correspond to Lorentzian-like peaks produced by the pass of the sp band through the Fermi level. A simple model has been developed, which connects the photoemission peak linewidth with the lifetime of photoelectrons excited from the Fermi level. The obtained inverse photoelectron lifetime values have been found to be in excellent agreement with the typical values of the Ag single crystals. These results support the fact th…
Structural and in situ vibrational study of luminescent cluster assembled silicon thin films
2006
A Low Energy Cluster Beam Deposition apparatus is employed to produce cluster assembled silicon thin films (1-500 nm thick) by using a laser vaporization source. The generated clusters are studied since their formation through time of flight mass spectra and the calculated size in the gas phase are compared with those of the deposited aggregates obtained through Dynamic Scanning Force Microscopy. The deposited material is also studied "in situ" by Raman and infrared spectroscopy. The spectra reveal that the as deposited clusters are hydrogenated with negligible amount of oxide. A comparison of the film properties before and after their air exposure shows that the exposition induces a consis…
Changes in surface stress, morphology and chemical composition of silica and silicon nitride surfaces during the etching by gaseous HF acid
2007
Abstract HF acid attack of SiO2 and Si3N4 substrates is analyzed to improve the sensitivity of a sensor based on microcantilever. Ex situ analysis of the etching using XPS, SIMS and AFM show significant changes in the anisotropy and the rate of the etching of the oxides on SiO2 and Si3N4 surface. Those differences influence the kinetic evolution of the plastic bending deflection of the cantilever coated with SiO2 and Si3N4 layer, respectively. The linear dependence between the HF concentration and the Si3N4 cantilever bending corresponds to a deep attack of the layer whereas the non-linear behavior observed for SiO2 layer can be explained by a combination of deep and lateral etching. The ca…
Organic Monolayers by B(C6F5)3-Catalyzed Siloxanation of Oxidized Silicon Surfaces
2017
Inspired by the homogeneous catalyst tris(pentafluorophenyl) borane [B(C6F5)3], which acts as a promotor of Si-H bond activation, we developed and studied a method of modifying silicon oxide surfaces using hydrosilanes with B(C6F5)3 as the catalyst. This dedihydrosiloxanation reaction yields complete surface coverage within 10 min at room temperature. Organic monolayers derived from hydrosilanes with varying carbon chain lengths (C8-C18) were prepared on oxidized Si(111) surfaces, and the thermal and hydrolytic stabilities of the obtained monolayers were investigated in acidic (pH 3) medium, basic (pH 11) medium, phosphate-buffered saline (PBS), and deionized water (neutral conditions) for …
Multiarm cyclam-grafted mesoporous silica: a strategy to improve the chemical stability of silica materials functionalized with amine ligands
2009
We have explored in this work the stability and the reactivity of multiarm cyclam-grafted mesoporous silica samples in aqueous solution. A series of hybrid materials have been prepared by grafting silylated cyclam molecules bearing one, two, or four silyl groups onto both amorphous silica gel (K60) and ordered mesoporous silica (SBA15). Under these conditions, cyclam moieties are attached to the silica walls via one, two, or four arms. Various physicochemical techniques have been applied to characterize the functionalized solids (elemental analysis, 1H-29Si and 1H-13C CPMAS NMR, and N2 adsorption-desorption isotherms). The interest in two and four arms for improving the chemical stability i…
Protein delivery based on uncoated and chitosan-coated mesoporous silicon microparticles
2011
Mesoporous silicon is a biocompatible, biodegradable material that is receiving increased attention for pharmaceutical applications due to its extensive specific surface. This feature enables to load a variety of drugs in mesoporous silicon devices by simple adsorption-based procedures. In this work, we have addressed the fabrication and characterization of two new mesoporous silicon devices prepared by electrochemistry and intended for protein delivery, namely: (i) mesoporous silicon microparticles and (ii) chitosan-coated mesoporous silicon microparticles. Both carriers were investigated for their capacity to load a therapeutic protein (insulin) and a model antigen (bovine serum albumin) …
Surface preparation influence on the initial stages of MOCVD growth of TiO2 thin films
2006
In situ chemical surface analyses using X-ray photoelectron spectroscopy (XPS), completed by ex situ atomic force microscopy (AFM) analyses, were performed in order to compare the initial stages of MOCVD growth of TiO 2 thin films on two different surface types. The first type was a silicon native oxide free hydrogen terminated surface and the second one was a silicon dioxide surface corresponding to a thin layer of 3.5 nm thick in situ thermally grown on silicon substrate. Si(100) was used as substrate, and the growths of TiO 2 thin films were achieved with titanium tetraisopropoxide (TTIP) as precursor under a temperature of 675 °C, a pressure of 0.3 Pa and a deposition time of 1 h. Whate…
Bimodal Acidity at the Amorphous Silica/Water Interface
2015
International audience; Understanding the microscopic origin of the acid base behavior of mineral surfaces in contact with water is still a challenging task, for both the experimental and the theoretical communities. Even for a relatively simple material, such as silica, the origin of the bimodal acidity behavior is still a debated topic. In this contribution we calculate the acidity of single sites on the humid silica surface represented by a model for the hydroxylated amorphous surface. Using a thermodynamic integration approach based on ab initio molecular dynamics, we identify two different acidity values. In particular, some convex geminals and some type of vicinals are very acidic (pK…
Theory of the growth mode for a thin metallic film on an insulating substrate
2002
We have developed a novel theory predicting the growth mode of a thin metallic film on an insulating substrate. This combines ab initio electronic structure calculations for several ordered metal/insulator interfaces (varying both coverage and substrate lattice constant), with a thermodynamic approach based on microscopic calculations. We illustrate this approach for Ag film deposited on MgO(0 0 1) substrate. Ab initio calculations predict high mobility of adsorbed silver atoms on the perfect magnesia surface even at low temperatures. Our theoretical analysis clearly demonstrates that the growth of metallic islands is predominant at the initial stage of silver deposition, which agrees with …
Bioprospective of Sorbus aucuparia leaf extract in development of silver and gold nanocolloids
2010
At the present time the bioprospective field is a dynamic area of research. The rapid biosynthesis of silver and gold nanoparticles without using toxic chemicals is reported here. Sorbus aucuparia is omnipresent in Europe. The aqueous leaves extract of the plant were used as reducing agent for the synthesis of silver and gold nanoparticles from their salt solutions. The synthesized nanoparticles were spherical, triangular and hexagonal in shape with an average size of 16 and 18nm for silver and gold, respectively. Different extract quantities, metal concentrations, temperatures and contact times were investigated to find their effect on nanoparticles synthesis. The resulting silver and gold…