Search results for "IRRADIATION"
showing 10 items of 1012 documents
Comparison Between Point Defect Generation by $\gamma$-rays in Bulk and Fibre Samples of High Purity Amorphous ${\hbox {SiO}}_{2}$
2008
We compare the E', H(I) and Si-ODC(II) contents in a low-OH high-purity a-SiO2 either in bulk or fibre forms. We found that the H(I) centre appears during irradiation and tend to increase with the dose if the fibre contains hydrogen excess. This behaviour is believed to be one the possible reason to explain the apparent radiation-sensitivity enhancement in the blue-UV spectrum when the fibre is hydrogenated and irradiated at high dose. However for the hydrogen-treated fibres, no experimental repeatability could be evidenced in the measurements of E' and Si-ODC(II) although an acceptable agreement was still found in normal samples. This suggests a possible complex reactional mechanisms in pr…
Neutron irradiation influence on magnesium aluminium spinel inversion
2002
Abstract Grown by the Verneuil method MgO · nAl2O3 single crystals and natural spinel crystal have been studied using X-ray diffraction and photoluminescence spectra. The fast neutron irradiation of magnesium aluminium spinel leads to the lattice parameter decrease. The bond lengths of Mg–O and Al–O vary with the u-parameter and the lattice parameter. On the other hand, the bond lengths are related with the inversion parameter. Using changes of the lattice parameter during irradiation we have calculated the inversion parameter, which is 15–20%. In the luminescence spectra, the fast neutron radiation (fluence 1016 cm−2) produces an increase in the intensity ratio of the N- to R-lines by 5–20…
Micro-Raman analysis of the fuel-cladding interface in a high burnup PWR fuel rod
2017
International audience; New insights on the fuel-cladding bonding layer in high burnup nuclear fuel were obtained using micro-Raman spectroscopy. A specimen was specifically prepared from a fuel rod which had been irradiated to an average burnup of 56 GWd.tU-1 in a pressurized water reactor (PWR). Both inner and outer corrosion scale regions were investigated. A 10-15 et956;m thick zirconia bonding layer between fuel and cladding materials which consisted of three distinct regions was observed. Close to the fuel, tetragonal, then monoclinic zirconia was identified as the main phases. Close to the bonding layer-cladding interface, peculiar Raman signals were observed. Similar signals were ob…
Analytical and Numerical Assessment of Thermally Induced Pressure Waves in the IFMIF-DONES Liquid-Lithium Target
2020
The intended steady-state operation conditions of the International Fusion Materials Irradiation Facility-DEMO Oriented Neutron Source (IFMIF-DONES) target system are based on the D+ beam stationary running at full nominal power (5 MW). Nevertheless, critical situations can occur in the case of unavoidable sudden events like beam trips. The instantaneous variation in the heating power deposited in lithium when the beam is rapidly switched between ON-and OFF-states leads to thermal expansion, which is compensated by the compression of the target material, resulting in locally high pressures and a pressure wave propagating through the target toward the back wall. Besides the tensile stress of…
Aggregation of Frenkel defects under irradiation: a mesoscopic approach
1994
The radiation-induced aggregation of Frenkel defects in solids is studied in terms of a mesoscopic approach. The asymmetry in elastic interactions between mobile interstitials (I-I) and between interstitials and vacancies (I-V) plays a decisive riile in the aggregation of similar defects. The conditions for defect aggregation are studied in detail for NaCl crystals. The critical dose rate for aggregation has been calculated as a function of the temperature as well as the aggregation rate as a function of temperature and dose rate. Furthermore, the r&e of deep traps (like impurities and di-vacancies), reducing the mobility of interstitials, and the r&le of dislocations serving as sinks for i…
Neutron yield from carbon, light- and heavy-water thick targets irradiated by 40MeV deuterons
2009
Abstract Angular and energy distributions of neutrons produced by the interaction of deuterons of 40 MeV in carbon, light- and heavy-water targets, in which they are stopped, have been measured by the activation method. A discrepancy with a time-of-flight measurement for d + C has been found. The results are compared with a Monte-Carlo calculation and are discussed in the frame of building a deuteron-to-neutron converter for the SPIRAL2 radioactive ion-beam facility.
Design of large scale sensors in 180 nm CMOS process modified for radiation tolerance
2019
International audience; The last couple of years have seen the development of Depleted Monolithic Active Pixel Sensors (DMAPS) fabricated with a process modification to increase the radiation tolerance. Two large scale prototypes, Monopix with a column drain synchronous readout, and MALTA with a novel asynchronous architecture, have been fully tested and characterized both in the laboratory and in test beams. This showed that certain aspects have to be improved such as charge collection after irradiation and the output data rate. Some improvements resulting from extensive TCAD simulations were verified on a small test chip, Mini-MALTA. A detailed cluster analysis, using data from laboratory…
Combined High Dose and Temperature Radiation Effects on Multimode Silica-Based Optical Fibers
2013
International audience; We investigate the response of Ge-doped, P-doped, pure-silica, or Fluorine-doped fibers to extreme environments combining doses up to MGy(SiO $_{{{2}}}$) level of 10 keV X-rays and temperatures between 25 C and 300 C . First, we evaluate their potential to serve either as parts of radiation tolerant optical or optoelectronic systems or at the opposite, for the most sensitive ones, as punctual or distributed dosimeters. Second, we improve our knowledge on combined ionizing radiations and temperature (R&T) effects on radiation-induced attenuation (RIA) by measuring the RIA spectra in the ultraviolet and visible domains varying the R&T conditions. Our results reveal the…
Evaluation of Distributed OFDR-Based Sensing Performance in Mixed Neutron/Gamma Radiation Environments
2017
We report the study of a radiation resistant single mode optical fiber doped with fluorine exposed to mixed neutron and $\gamma $ -radiation up to $10^{17}$ n/cm2 fluence and >2 MGy dose to evaluate its performances when used as the sensing element of a distributed Optical Frequency Domain Reflectometry (OFDR). The use of complementary spectroscopic techniques highlights some differences between the responses of solely $\gamma $ -radiation (10 MGy) or mixed neutron and $\gamma $ ( $10^{17}$ n/cm $^{2}+>2$ MGy) irradiated samples. Those differences are linked to the defect generation rather than to structural changes of the ${a}$ -SiO2 host matrix. We show that a modification of the refracti…
Steady-State X-Ray Radiation-Induced Attenuation in Canonical Optical Fibers
2020
The so-called canonical optical fibers (OFs) are samples especially designed to highlight the impact of some manufacturing process parameters on the radiation responses. Thanks to the results obtained on these samples, it is thus possible to define new procedures to better control the behaviors of OFs in radiation environments. In this article, we characterized the responses, under steady-state X-rays, of canonical samples representative of the most common fiber types differing by their core-dopants: pure silica, Ge, Al, and P. Their radiation-induced attenuation (RIA) spectra were measured online at both room temperature (RT) and liquid nitrogen temperature (LNT), in the energy range [~0.6…