Search results for "Inert"

Accumulation of radiation defects and products of radiolysis in lithium orthosilicate pebbles with silicon dioxide additions under action of high abs…

2012

Abstract One of the technological problems of a fusion reactor is the change in composition and structure of ceramic breeders (Li 4 SiO 4 or Li 2 TiO 3 pebbles) during long-term operation. In this study changes in the composition and microstructure of Li 4 SiO 4 pebbles with 2.5 wt% silicon dioxide additions, fabricated by a melt-spraying process, were investigated after fast electron irradiation ( E  = 5 MeV, dose rate up to 88 MGy h −1 ) with high absorbed dose from 1.3 to 10.6 GGy at high temperature (543–573 K) in air and argon atmosphere. Three types of pebbles with different diameters and grain sizes were investigated. Products of radiolysis were studied by means of FTIR and XRD. TSL …

Germanium Doped CHxMicroshells for LMJ Targets

2011

AbstractAt the CEA Laser “Megajoule” facility, amorphous hydrogenated carbon (a-C:H or CHx) is the nominal ablator used to achieve inertial confinement fusion experiments. These targets are filled with a fusible mixture of deuterium-tritium in order to perform ignition.Since the achievement of ignition greatly depends on the physical properties of the shell, there must be precise control of thicknesses, doping concentration, and roughness. Experimental devices associated with suitable characterizations are described in this paper. The tolerances and yields for each specification are also presented. Some specifications are largely reached; high-frequency surface roughness due to isolated sur…

A Model to Characterize the D-T Layer of ICF Targets by Backlit Optical Shadowgraphy

2005

A numerical model is presented in order to modelize the bright ring that appears in backlit optical shadowgraphy on a transparent hollow sphere with a solid deuterium-tritium layer inside. This novel model is based on computational calculations applied to the problem of the targets used in inertial confinement fusion. The model takes into account the influences of the optical imaging system (numerical aperture, source divergence, camera resolution, etc.) and the effect of the capsule itself, diameter, thickness, and refractive index, and allows one to analyze the inner surface of a capsule in terms of thickness and roughness.

Properties of nuclei in the nobelium region studied within the covariant, Skyrme, and Gogny energy density functionals

2015

We calculate properties of the ground and excited states of nuclei in the nobelium region for proton and neutron numbers of 92 <= Z <= 104 and 144 <= N <= 156, respectively. We use three different energy-density-functional (EDF) approaches, based on covariant, Skyrme, and Gogny functionals, each within two different parameter sets. A comparative analysis of the results obtained for odd-even mass staggerings, quasiparticle spectra, and moments of inertia allows us to identify single-particle and shell effects that are characteristic to these different models and to illustrate possible systematic uncertainties related to using the EDF modelling

Identification of theg92proton and neutron band crossing in theN=ZnucleusSr76

2007

High-spin states in $^{76}\mathrm{Sr}$ have been studied using Gammasphere plus Microball detector arrays. The known yrast band has been extended beyond the first band crossing, which involves the simultaneous alignment of pairs of ${\mathrm{g}}_{\frac{9}{2}}$ protons and neutrons, to a tentative spin of $24\ensuremath{\hbar}$. The data are compared with the results of cranked relativistic mean-field (CRMF) and cranked relativistic Hartree-Bogoliubov (CRHB) calculations. The properties of the band, including the ${\mathrm{g}}_{\frac{9}{2}}$ proton/neutron band crossing frequency and moments of inertia, are found to be well reproduced by the CRHB calculations. Furthermore, the unpaired CRMF …

Anomalous Behavior of High-Spin States inCm248

1981

The ground-state band of $^{248}\mathrm{Cm}$ has been studied up to spin ${28}^{+}$ and tentatively to ${30}^{+}$ by observing $\ensuremath{\gamma}$ rays following multiple Coulomb excitation with use of $^{208}\mathrm{Pb}$ ions at 5.3 MeV/u. A smooth, gradual increase in the effective moment of inertia is seen at lower spin with an anomalous forward bend above spin ${22}^{+}$. Calculations are presented which indicate that this behavior including the forward bend can be understood in terms of the alignment of single-particle angular momenta along the rotation axis.

Variable masses in fission and heavy-ion collisions

1972

With the use of the cranking formula, the coordinate-dependent mass parameters of the kinetic-energy operator in fission processes and heavy-ion collisions are calculated in the two-center oscillator model. It is shown that the reduced mass and also the classical moment of inertia are obtained for large separations of the fragments. For small separations, however, the mass parameter for the motion of the centers of mass of the fragments is larger than the reduced mass by an order of magnitude.

A new approach to studying sponge cake aroma after storage in treated paper and plastic packaging by direct gas chromatography–olfactometry (D-GC–O)

2007

The objective of this study was to use D-GC–O to compare the global odour of a sponge cake flavoured with either a ‘viennoiserie’ aromatic note or a simplified mixture of aroma compounds (used for physicochemical studies), then stored in a glass packaging (inert and impermeable) or in pouches made with treated papers or with plastic packaging, in accelerated ageing conditions (high temperature and relative humidity gradient). After 1 week of storage, the flavoured sponge cake headspace was SPME-extracted directly into the packaging and analysed by D-GC–O. The sponge cake global odour was better retained if plastic film rather than treated-papers was used, for both flavourings. Changes in th…

2015

In everyday life, one of the most frequent activities involves accelerating and decelerating an object held in precision grip. In many contexts, humans scale and synchronize their grip force, normal to the finger/object contact, in anticipation of the expected tangential load force, resulting from the combination of the gravitational and the inertial forces. In many contexts, grip force and load force are linearly coupled. A few studies have examined how we adjust the parameters - gain and offset - of this linear relationship. However, the question remains open as to how the brain adjusts grip force regardless of whether load force is generated by different combinations of weight and inerti…

Hybrid Passive Control Strategies for Reducing the Displacements at the Base of Seismic Isolated Structures

2019

In this paper, the use of hybrid passive control strategies to mitigate the seismic response of a base-isolated structure is examined. The control performance of three different types of devices used for reducing base displacements of isolated buildings is investigated. Specifically, the Tuned Mass Damper (TMD), the New Tuned Mass Damper (New TMD) and the Tuned Liquid Column Damper (TLCD), each one associated to a Base Isolated structure (BI), have been considered. The seismic induced vibration control of base-isolated structures equipped with the TMD, New TMD or the TLCD is examined and compared with that of the base-isolated system without devices, using real recorded seismic signals as e…