Search results for "Inertia"
showing 10 items of 263 documents
Layer-wise and equivalent single layer models for smart multilayered plates
2014
Layer-wise and equivalent single layer plate models for magneto-electro-elastic multiphysics laminates are presented in a unified framework. They are based on variable kinematics and quasi-static behavior of the electromagnetic fields. The electromagnetic state of each single layer is preliminary determined by solving the corresponding governing equations coupled with the proper interface continuity and external boundary conditions. By so doing, the electromagnetic state is condensed into the plate kinematics and the layer governing equations are inferred by the principle of virtual displacements. This approach identifies effective mechanical layers, which are kinematically equivalent to th…
On the exhaust of electromagnetic drive
2016
Recent reports about propulsion without reaction mass have been met on one hand with enthusiasm and on the other hand with some doubts. Namely, closed metal cavities, when fueled with microwaves, have delivered thrust that could eventually maintain satellites on orbits using solar power. However, the measured thrust appears to be without any apparent exhaust. Thus the Law of Action-Reaction seems to have been violated. We consider the possibility that the exhaust is in a form that has so far escaped both experimental detection and theoretical attention. In the thruster's cavity microwaves interfere with each other and invariably some photons will also end up co-propagating with opposite pha…
Classical electromagnetic radiation in noninertial reference frames
1991
Customarily electromagnetic radiation is defined with reference to some inertial laboratory frame. But such a definition is too narrow to be applicable to questions concerning accelerated observers,e.g. why an accelerated observer does not receive radiation from a co-accelerating charge. It is shown in this paper that a radiation concept introduced for inertial observers by Rohrlich and Teitelboim allows an extension to noninertial (accelerating and rotating) reference frames in a natural way. The generalized concept is explicitly dependent on the proper acceleration and the rotation of the observer’s laboratory frame. The case of radiation due to an accelerated point charge is treated in f…
Braking procedure analysis of a pegs-wing ventilated disk brake rotor
2006
Fade test results of a ventilated disk brake rotor with pegs-wing performed by means of an inertia dynamometer, consisting of 14 repeated brake applications from an initial brake speed of 160 km/h down to 0 km/h, with constant deceleration are shown. The first brake application test results are compared to the FEM numerical predictions with MSC Visual Nastran on the entire disk. These conform well to the experimental data, although numerical thermal field is slightly higher than the experimental one. Besides, ventilated disk brake rotor shows great dimensional stability and the ability to dissipate a great amount of thermal flow.
PCM Thermal Energy Storage in Buildings: Experimental Study and Applications
2015
Abstract The study aims at analyzing the performance of Phase Change Materials (PCMs) in residential housing for different climates. This paper presents the results of an experiment performed in the Concordia University Solar Simulator and Environmental Chamber research facility (SSEC, Montreal, Canada). PCM boards were embedded on the back wall of a test hut placedin the climatic chamber. Several experiments were performed to explore the potential for verification of the proposed analysis and to produce enough data to perform model calibrations. Results show a strong increase in the apparent thermal inertia of the room allowing for a reduction in daily temperature fluctuations in the test …
Low-cost underwater navigation systems by multi-pressure measurements and AHRS data
2017
This paper deals with accurate navigation for underwater remotely operated vehicles. A feasibility study for a multi-pressure device to be mounted on an ROV is presented. The device can provide accurate estimates of a ROV orientation and angular speed. It is based on the well-known total pressure principle, also used in a Pitot tube, and allows reconstruction of static and dynamic pressures, which in turn provide good estimates of the ROV's orientation and rotational speed, respectively. An appealing feature of the proposed device is its ability to provide accurate estimates even for low-speed movements.
Head and Body Coordination during Locomotion and Complex Movements
1994
Publisher Summary This chapter discusses theory in which it is argued that during complex movements, the head is stabilized intermittently under the control of gaze, and that this stabilization allows the head to serve as an inertial guidance platform for the control of multilimb movement. The otolithic organs, sacculus and utriculus, are inertial detectors of linear acceleration of the head in the plane of their macula. It is well established that in normal gravity conditions, although the perceived gravitational vertical deviates from the objective vertical by a few degrees, gravitational reference is used not only for posture but also for perceptual tasks that involve orientation in spac…
Car following: Comparing distance-oriented vs. inertia-oriented driving techniques
2018
The rationale behind most car-following (CF) models is the possibility to appraise and formalize how drivers naturally follow each other. Characterizing and parametrizing Normative Driving Behavior (NDB) became major goals, especially during the last 25 years. Most CF models assumed driver propensity for constant, safe distance is axiomatic. This paper challenges the idea of safety distance as the main parameter defining a unique (or natural) NDB. Instead, it states drivers can adapt to reactive and proactive car following. Drawing on recent CF models close to the Nagoya paradigm and on other phenomena (e.g., wave movement in Nature), we conceived car following by Driving to keep Inertia (D…
Development details and performance assessment of a Wind Turbine Emulator
2016
This paper describes an experimental platform to emulate the static and dynamic behavior of real Wind Energy Conversion Systems (WECS). The Wind Turbine Emulator (WTE) consists of two coupled 1.5 kW squirrel-cage induction machines. The WTE calculations are performed on a PC and a DSP, both connected via USB. The total torque applied to the WTE motor is the difference of the scaled wind mechanical torque calculated on the PC, and the turbine inertia torque calculated on the DSP. An improved WTE shaft speed derivative has been used for the inertia torque calculation, which provides better results in terms of attenuation of the high-frequency harmonics present in the generator speed acquisiti…
An inertial system for the production of electricity and hydrogen from sea wave energy
2015
This paper aims at describing a small scale prototype of a complete wave energy converter system for hydrogen production promoting the opportunity of installation in Sicily, in the Mediterranean Sea. The opportunity to produce hydrogen from sea-water identifies ocean wave energy as the most promising solution for electricity generation including hydrogen production and storage. Even if hydrogen is considered one of the most promising secondary sources, criticism arises from both the academic and the industrial world mainly because hydrogen production requires electricity consumption. Furthermore, safety problems concerning hydrogen storage and transport are actually the main hindrance to fu…