Search results for "Infiltrometer"
showing 10 items of 53 documents
Estimating the macroscopic capillary length from Beerkan infiltration experiments and its impact on saturated soil hydraulic conductivity predictions
2020
International audience; The macroscopic capillary length, λc, is a fundamental soil parameter expressing the relative importance of the capillary over gravity forces during water movement in unsaturated soil. In this investigation, we propose a simple field method for estimating λc using only a single-ring infiltration experiment of the Beerkan type and measurements of initial and saturated soil water contents. We assumed that the intercept of the linear regression fitted to the steady-state portion of the experimental infiltration curve could be used as a reliable predictor of λc. This hypothesis was validated by assessing the proposed calculation approach using both analytical and field d…
Determining hydraulic properties of a loam soil by alternative infiltrometer techniques
2015
Testing infiltrometer techniques to determine soil hydraulic properties is necessary for specific soils. For a loam soil, the water retention and hydraulic conductivity predicted by the BEST (Beerkan Estimation of Soil Transfer parameters) procedure of soil hydraulic characterization was compared with data collected by more standard laboratory and field techniques. Six infiltrometer techniques were also compared in terms of saturated soil hydraulic conductivity, Ks. BEST yielded water retention values statistically similar to those obtained in the laboratory and Ks values practically coinciding with those determined in the field with the pressure infiltrometer (PI). The unsaturated soil hyd…
A new automated single ring infiltrometer for Beerkan infiltration experiments
2014
A new automated compact device was developed to collect data from single ring infiltration experiment. The infiltrometer consists of a containment ring in which a small quasi-constant head of water (i.e. a few mm) is maintained by a Mariotte reservoir and a very inexpensive data acquisition system, based on the open source microcontroller platform Arduino, and a differential pressure transducer. The design can easily be reproduced and operated. The infiltrometer was tested in a citrus orchard on a sandy loam soil. A simple methodology was applied for an accurate data acquisition from the initial stage of the process and to minimize the disturbance of the soil surface. A new approach to proc…
Testing a Simplified Approach to Determine Field Saturated Soil Hydraulic Conductivity
2013
Abstract Interpreting and simulating hydrological processes need a large number of field saturated soil hydraulic conductivity, Kfs , data that should be collected with simple and rapid field experiments. A Simplified method based on a Beerkan Infiltration run (SBI method) was recently developed and tested successfully on Burundian soils. With the SBI method, a cylinder is inserted to a short depth into the soil and the infiltration time of a few small volumes of water repeatedly applied at the surface of the confined soil is measured. Calculating Kfs needs the slope of the linearized cumulative infiltration vs. time relationship and an estimate of the so called α* parameter. In this invest…
Field testing parameter sensitivity of the two-term infiltration equation using differentiated linearization
2003
Knowledge of soil hydraulic conductivity in the vadose zone is important in many agronomic, engineering and environmental areas. Transient tension infiltrometer experiments can be used to estimate the hydraulic conductivity, K0, corresponding to a given pressure head by the single-test (TST) method that uses the coefficients C1 and C2 of the two-term infiltration equation. The “Differentiated Linearization” (DL) method has been proposed to estimate these coefficients when a layer of contact material is used for the experiment. A field test of the DL and TST methods was conducted on a sandy loam and a clay soil. Eliminating the early-time influence of the contact layer was easy when the sorp…
Ring diameter effects on determination of field-saturated hydraulic conductivity of different loam soils
2017
Abstract Establishing ring diameter effects on the field-saturated soil hydraulic conductivity, Kfs, determined with ponding infiltrometer methods can help to find a compromise between the need to sample a large area with an individual measurement and the impracticality of using large rings in the field. Five ring sizes (diameter, D = 5.5, 10.9, 16.0, 27.8 and 31.8 cm) were used to determine Kfs by the simplified falling head (SFH) technique in four loamy soils with different salinity (electrical conductivity of saturated extract, ECe = 0.9–29.4 dS/m) and sodicity (exchangeable sodium percentage, ESP = 2.7–81.3%) levels. According to USDA classification, two soils were non-saline, non-sodic…
Development and analysis of the Soil Water Infiltration Global database
2018
27 Pags.- 11 Tabls.- 8 Figs. © Author(s) 2018. This work is distributed under the Creative Commons Attribution 4.0 License.
Automated single ring infiltrometer with a low-cost microcontroller circuit
2015
Automation of a new single ring infiltrometer.Data acquisition system based on the open source microcontroller platform Arduino.New method to minimize the disturbance of the soil surface.New approach to process transducer output. A method to automate data collection with a compact infiltrometer under constant head conditions was developed. The infiltrometer consists of a containment ring with a small quasi-constant head of water (i.e., 2-3mm) that is controlled by a Mariotte reservoir and a data acquisition system based on the open source microcontroller platform Arduino and a differential pressure transducer. The presented design can be easily reproduced and operated.The infiltrometer was …
Parameterization of a comprehensive explicit model for single-ring infiltration
2021
International audience; Comprehensive infiltration models can simultaneously describe transient and steady-state infiltration behaviors, and therefore can be applied to a range of experimental conditions. However, satisfactory model accuracy re- quires proper parameterization, including estimating the transition time from transient to steady-state flow conditions (τcrit). This study focused on improving the estimation of two parameters – τcrit and a second constant called a – used in a comprehensive, explicit, two-term model for single ring infiltration (hereafter referred to as the SA model). Different studies have recommended that a should be as low as 0.45 to as high as 0.91. Furthermore…
Determining Soil Hydraulic Properties Using Infiltrometer Techniques: An Assessment of Temporal Variability in a Long-Term Experiment under Minimum- …
2020
Conservation agriculture is increasingly accepted by farmers, but the modeling studies on agro-environmental processes that characterize these agricultural systems require accurate information on the temporal variability of the soil&rsquo