Search results for "Infiltrometer"

A simplified falling-head tecnique for rapid determination of field-saturated hydraulic conductivity

2004

Simplified measurements of the field-saturated hydraulic conductivity, K fs , require short duration experiments, small water volumes, and easily transportable equipment. A simplified falling-head (SFH) technique for the rapid determination of K fs has been developed and tested. The technique consists in applying a small volume of water on a soil surface, confined by a ring inserted a short distance into the soil, and then measuring the time from the application of water to the instant at which the surface area is no longer covered by water. A measurement of the initial and field-saturated soil water contents, and an estimate of the α* parameter of the Gardner's exponential model are then u…

Evaluation of Green Roof Ageing Effects on Substrate Hydraulic Characteristics

2020

The vegetated substrate of green roofs may undergo various chemical and physical changes with time. Minidisk infiltrometer (MDI) tests were conducted to assess the short-term variations of the near-saturated hydraulic conductivity, K0, in the extensive green roof test plot established at the University of Palermo. Sampling was repeated four times: before planting (Age 0) and then after four months (Age 1), seven months (Age 2) and ten months (Age 3). A total of 144 infiltration tests were conducted at two pressure heads, h0 = −3 cm and h0 = −0.5 cm and infiltration data analysed by the Zhang (Soil Science Society of America Journal 61(4):1024–1030, 1997) model. Both K-3 and K-0.5 underwent …

A field assessment of the Simplified Falling Head technique to measure the saturated soil hydraulic conductivity

2012

Abstract The Simplified Falling Head (SFH) technique to measure field saturated soil hydraulic conductivity, Kfs, has received little testing or comparison with other techniques. Different experiments were carried out to i) determine the effect of ring size on the measured conductivity; ii) compare the SFH and Pressure Infiltrometer (PI) techniques in a clay loam soil; and iii) evaluate the approach used in the SFH methodology to estimate the α* parameter. Sampling a relatively large number of sites allowed to detect statistically significant relationships between the Kfs values obtained with rings differing in diameter (0.15 and 0.30 m, respectively). The ring size effect was substantial (…

Testing infiltration run effects on the estimated water transmission properties of a sandy-loam soil

2016

Abstract Testing factors influencing determination of soil water transmission properties by an infiltrometer method helps better interpretation of the collected data and allows the development of appropriate sampling strategies for the intended use of the data. These factors include the soil water content at the start of the experiment, the height from which water is poured onto the soil surface, and the duration of the infiltration run. A sandy-loam soil was sampled with the BEST (Beerkan Estimation of Soil Transfer parameters) procedure of soil hydraulic characterization and two heights of pouring of water (0.03 and 1.5 m) under three different initial soil water content, θ i (0.12 ≤ θ i …

Impacts of thinning of a Mediterranean oak forest on soil properties influencing water infiltration

2017

[EN] In Mediterranean ecosystems, special attention needs to be paid to forest¿water relationships due to water scarcity. In this context, Adaptive Forest Management (AFM) has the objective to establish how forest resources have to be managed with regards to the efficient use of water, which needs maintaining healthy soil properties even after disturbance. The main objective of this investigation was to understand the effect of one of the AFM methods, namely forest thinning, on soil hydraulic properties. At this aim, soil hydraulic characterization was performed on two contiguous Mediterranean oak forest plots, one of them thinned to reduce the forest density from 861 to 414 tree per ha. Th…

Comparing two methods of analysis of single-ring infiltrometer data for a sandy–loam soil

2009

Abstract The single-ring pressure infiltrometer (PI) with the steady-state Two-Ponding-Depth (TPD) application method were developed to simultaneously determine the saturated soil hydraulic conductivity, K fs , and the α ⁎-parameter in the field. Methods of analysis of transient PI data are also available but they have received little testing so far. The transient WU method and the TPD method were compared for a sandy-loam soil. A linearization technique of the infiltration curve yielded more reliable K fs and α ⁎ results (i.e., falling within expected ranges) than a non-linear optimization technique. The WU method gave both positive and reasonable K fs and α ⁎ values for all infiltration t…

A comparison between the single ring pressure infiltrometer and simplified falling head techniques

2013

Testing the relative performances of the single ring pressure infiltrometer (PI) and simplified falling head (SFH) techniques to determine the field saturated soil hydraulic conductivity, Kfs, at the near point scale may help to better establish the usability of these techniques for interpreting and simulating hydrological processes. A sampling of 10 Sicilian sites showed that the measured Kfs was generally higher with the SFH technique than the PI one, with statistically significant differences by a factor varying from 3 to 192, depending on the site. A short experiment with the SFH technique yielded higher Kfs values because a longer experiment with the PI probably promoted short-term swe…

Appendix – Additional Measurements

2016

This appendix deals with the determination of different soil physical and hydraulic characteristics used in the analysis and/or interpretation of the infiltration experiments. The core method and the excavation method for measurement of soil bulk density are initially presented. Determination of soil water content by the thermo-gravimetric and the Time Domain Reflectometry methods is then illustrated. Subsequently, field measurement of soil water matric potential by tensiometers is discussed. Laboratory determination of the soil water retention curve by tensiometric and pressiometric techniques is also described. Finally, different methods to test water stability of soil aggregates are illu…

INVESTIGATIONS ON INFILTRATION METHODS FOR AN IMPROVED SOIL HYDRAULIC CHARACTERIZATION

2020

Determining hydraulic properties of a loam soil by alternative infiltrometer techniques

2015

Testing infiltrometer techniques to determine soil hydraulic properties is necessary for specific soils. For a loam soil, the water retention and hydraulic conductivity predicted by the BEST (Beerkan Estimation of Soil Transfer parameters) procedure of soil hydraulic characterization was compared with data collected by more standard laboratory and field techniques. Six infiltrometer techniques were also compared in terms of saturated soil hydraulic conductivity, Ks. BEST yielded water retention values statistically similar to those obtained in the laboratory and Ks values practically coinciding with those determined in the field with the pressure infiltrometer (PI). The unsaturated soil hyd…