Search results for "Isothermal process"
showing 10 items of 114 documents
Calorimetric investigation of the vulcanization of factice
1991
Sulphur factice is produced from a mixture of a vegetable oil and sulphur at temperatures between 130 and 160‡C. The slow exothermal vulcanization results in rubber-like elastomers. We have developed an isothermal calorimeter for measurements both in the liquid and the solid state and simulated the production process at the laboratory scale. The compensating calorimeter consists of a hot plate equipped with thin aluminium rods descending into a Dewar vessel. Besides optimization of the temperature control, remarkable savings of time were achieved by previous elaidinization of the oil using hydrosulphide.
Thermoosmotic transfer of sterically stabilized ferrofluid particles in non-isothermal capillary porous layer
2005
Experiments on thermodiffusive transfer of ferrofluid nanoparticles in capillary porous layer are presented. The layer consists of a number of capillary filter sheets pressed between two plates of different temperatures. Steady profiles of particle concentration are detected after the experiment from magnetization of each filter sheet. It is shown that particle separation in porous layer is remarkably influenced by thermoosmotic forces. The observed effect is different for colloids of various surfactants and of various carrier liquids.
Non-isothermal mass transfer of ferrocolloids through porous membrane
2011
Abstract The present paper deals with transport properties of ferrofluid nanoparticles in non-isothermal capillary-porous layer. Experiment establishes that the temperature difference, which is applied across the layer, induces a thermoosmotic pressure gradient directed toward increasing temperature. The measurement results are interpreted in a frame of phenomenology of linear irreversible thermodynamics. The transport coefficients are evaluated comparing the measured separation curves with approximate solution of the corresponding mass transfer problem.
Natural convection heat transfer in a partially—or completely—partitioned vertical rectangular enclosure
1991
Abstract The effect of symmetric partitions protruding centrally from the end walls of a rectangular vertical enclosure on heat transfer rates is investigated numerically. The enclosure has opposite isothermal walls at different temperatures. The Rayleigh number is varied from 10 4 to 10 7 and the aspect ratio from 0.5 to 10. The thickness of the partitions is fixed and equal to one tenth of the width of the enclosure. Their non-dimensional length ( L / H ) is varied from 0 (non-partitioned enclosure) to 0.5 (two separate enclosures). The effect of different thermal boundary conditions at the end walls and at the partitions is included in the investigation.
Numerical evidence for a thermal driving force during adsorption of butane in silicalite.
2009
International audience; The transport properties of nano-porous materials determine their applicability, e.g. as separators or catalysts (J. Ka¨rger, D. Ruthven. Diffusion in zeolites, Wiley, New York (1991); L.V.C. Rees, D. Shen. Adsorption of gases in zeolite molecular sieves. In Introduction to Zeolite Science and Practice, Studies in surface science and catalysis, H.V.C. van Bekkum, E.M. Flanigen, P.A. Jacobs, J.C. Jansen (Eds.), vol. 137, pp. 579–631, Elsevier, Amsterdam (2001)). Adsorption in zeolites is explained as a two-step process; adsorption to the external crystal surface and subsequent intra-crystalline diffusion (R. M. Barrer. Porous crystal membranes. J. Chem. Soc. Faraday T…
Neutron Diffraction Study of the in Situ Oxidation of UO2
2009
This paper discusses uranium oxide crystal structure modifications that are observed during the low-temperature oxidation which transforms UO(2) into U(3)O(8). The symmetries and the structural parameters of UO(2), beta-U(4)O(9), beta-U(3)O(7), and U(3)O(8) were determined by refining neutron diffraction patterns on pure single-phase samples. Neutron diffraction patterns were also collected during the in situ oxidation of powder samples at 483 K. The lattice parameters and relative ratios of the four pure phases were measured during the progression of the isothermal oxidation. The transformation of UO(2) into U(3)O(8) involves a complex modification of the oxygen sublattice and the onset of…
ChemInform Abstract: Neutron Diffraction Study of the in situ Oxidation of UO2.
2009
This paper discusses uranium oxide crystal structure modifications that are observed during the low-temperature oxidation which transforms UO2 into U3O8. The symmetries and the structural parameters of UO2, β-U4O9, β-U3O7, and U3O8 were determined by refining neutron diffraction patterns on pure single-phase samples. Neutron diffraction patterns were also collected during the in situ oxidation of powder samples at 483 K. The lattice parameters and relative ratios of the four pure phases were measured during the progression of the isothermal oxidation. The transformation of UO2 into U3O8 involves a complex modification of the oxygen sublattice and the onset of complex superstructures for U4O…
The effect of montmorillonite clay in alginate gel beads for polychlorinated biphenyl adsorption: Isothermal and kinetic studies
2014
Beads of alginate montmorillonite have been used as sorbent for polychlorinated biphenyls from aqueous solutions.The structure and the differences between the different beads were established by IR spectroscopy (FT-IR). The adsorption at 25 °C has been studied in a batch system, following its kinetics and assessing adsorbent dose, initial PCB concentrations, and pH effects. The results show that increasing the initial concentration of the PCBs and the adsorption time favored the adsorption. Adsorption isotherm data were modeled using Chapman, Freundlich and Langmuir adsorption isotherms and the appropriate parameters were calculated.Adsorption of trichlorobiphenyls on alginate–montmorilloni…
A comparison between the chemical behaviour of lead-gold and lead-bismuth eutectics towards 316L stainless steel
2013
Radiochimica acta, 101 (10)
Modeling the isothermal inactivation curves of Listeria innocua CECT 910 in a vegetable beverage under low-temperature treatments and different pH le…
2015
Thermal inactivation kinetics of Listeria innocua CECT 910 inoculated in a vegetable beverage at three pH conditions (4.25, 4.75, and 5.20), four levels of temperature (50, 55, 60, 65℃), and different treatment times (0–75 min) were obtained. Survival curves did not follow a log-linear relationship and consequently were fitted to various mathematical models: Weibull, Geeraerd, Cerf with shoulder, and the modified Gompertz equation. Results indicated that the best model for the treatment conditions was the modified Gompertz equation, which provides the best goodness-of-fit and the lowest Akaike information criterion value. Sensitivity analysis indicated that the most influential factors affe…