Search results for "Linder"
showing 8 items of 178 documents
Interpreting the decomposition of gender earnings gap
2010
In this paper we discuss a decomposition of the gender monthly earnings differential into three components: the first is due to differences in individual characteristics, the second is due to discrimination and the last to the differential in hours worked. The Oaxaca-Blinder hourly wage decomposition is perfectly integrated into the decomposition of the monthly earnings gap. In order to evaluate the effects of this components on the monthly earnings gap, we calculate counterfactual earnings gaps, estimating what would happen if various aspects relating to the two genders were equal (for example, educational level), and then we compare these with the empirical earnings gap. The aim of the co…
A physical model for the interaction between unsaturated soils and retaining structures
2020
Temporary and permanent retaining structures interact with soils that are usually in unsaturated conditions. In this work, a 1g-scale physical model is presented to investigate the interactions between retaining walls and unsaturated soils. The physical model is equipped with a water-filled hydraulic cylinder connected to a pressure-volume controller to measure the horizontal component of the later earth thrust and high capacity tensiometers to measure soil matric suction. A system of low-friction linear guideways has been installed at the base of the wall-model. The failure surface is observed through a 3 cm thick glass wall on one side of the container. A series of images are acquired dur…
Increasing the drying efficiency of cylinder drying
2011
This PhD Thesis concentrates on paper drying: first on the drying rate in a cylinder covered with fabric, enhanced using hot air impingement through the fabric, and its potential effects on paper quality, and second, on the heat transfer rate from hot steam to paper through the cylinder shell. Cylinder drying is a drying method where a heated surface in contact with paper causes water removal from the latter by evaporation. Impingement through the fabric of hot air has been suggested to cause increase in the water removal and drying of paper. Increase in the drying rate by impingement of hot air was confirmed by laboratory tests and by simulations. In laboratory tests the increase in the dr…
Effect of simulated CO2and GaAlAs laser surface decontamination on temperature changes in Ti-plasma sprayed dental implants
2002
Background and Objective To investigate and compare temperature elevations at the implant-bone interface during simulated implant surface decontamination with a CO2 and a GaAlAs laser. Study Design/Materials and Methods Stepped cylinder implants (Frialit 2® Friadent GmbH, Mannheim, Germany) with a Titanium plasma sprayed surface were inserted into bone blocks cut from pig femurs. An artificial periimplant bone defect provided access for laser irradiation in the coronal third. Both lasers were operated at 1.0–2.5 W in the cw-mode. The bone block was placed into a 37°C water bath in order to simulate in vivo thermal conductivity and diffusitivity of heat. K-type thermocouples connected to a d…
Temperature changes induced by 809-nm GaAlAs laser at the implant-bone interface during simulated surface decontamination
2003
The aim of the study was to investigate temperature changes at the implant-bone interface during simulated implant surface decontamination with a 809-nm gallium-aluminium-arsenid (GaAlAs) semiconductor laser. Stepped cylinder implants with a diameter of 3.8 mm and a length of 11 mm with two different surfaces (sand-blasted and acid etched, and hydroxyapatite-coated) were inserted into bone blocks cut from freshly resected pig femurs. Access holes of 0.5 mm were drilled into the bone, to allow K-type thermocouples to contact periimplant bone in different parts of the cavity. An artificial periimplant bone defect provided access for laser irradiation in the coronal third. A 600-micrometer opt…
Variational parabolic capacity
2015
We establish a variational parabolic capacity in a context of degenerate parabolic equations of $p$-Laplace type, and show that this capacity is equivalent to the nonlinear parabolic capacity. As an application, we estimate the capacities of several explicit sets.
Enabling Energy Savings in Offshore Mechatronic Systems by using Self-Contained Cylinders
2019
This paper proposes a novel actuation system for an offshore drilling application. It consists of three self-contained electro-hydraulic cylinders that can share and store regenerated energy. The energy saving potential of the proposed solution is analyzed through a multibody system simulation. The self-contained system demonstrates superior energy efficiency compared to the benchmark system representing the state-of-the-art approach used today (i.e., valve-controlled cylinders by means of pressure-compensated directional control valves and counter-balance valves, supplied by a centralized hydraulic power unit). Due to the power on demand capability, the cancellation of the throttling losse…
Numerical and Experimental Study of a Novel Concept for Hydraulically Controlled Negative Loads
2016
This paper presents a numerical and experimental investigation of a novel concept that eliminates oscillations in hydraulic systems containing a counterbalance valve in series with a pressure compensated flow supply. The concept utilizes a secondary circuit where a low-pass filtered value of the load pressure is generated and fed back to the compensator of the flow supply valve. The novel concept has been implemented on a single boom actuated by a cylinder. A nonlinear model of the system has been developed and an experimental verification shows good correspondence between the model and the real system. The model is used for a parameter study on the novel concept. From the study it is found…