Search results for "MCM"
showing 10 items of 92 documents
Cracking Activity and Hydrothermal Stability of MCM-41 and Its Comparison with Amorphous Silica-Alumina and a USY Zeolite
1996
It has been found that the cracking activity of MCM-41 for a reaction catalyzed by strong acids site, such asn-heptane cracking, is much lower than that of a USY zeolite, and similar to that of amorphous silica-alumina. The higher activity of USY is due to the presence of stronger Bronsted acid sites in the zeolite. In the case of gas oil cracking, the greater accessibility of the large molecules to acid sites in MCM-41 relative to USY makes the difference in activity between these two catalysts much smaller than for the pure hydrocarbon. In the calcined state MCM-41 is more active and gives more gasoline and less gases and coke than amorphous silica-alumina. However, when the catalysts wer…
MCM-41 silica monoliths with independent control of meso- and macroporosity
2007
Centimetre sized macroporous silica monoliths consisting of MCM-41 have been prepared by a two-step procedure allowing an independent control of the meso- and macro-porosity. In the first step a monolith with a macroporosity tailored between 2 and 20 μm is prepared under acidic medium by a phase separation, named spinodal decomposition, leading to a bicontinuous structure of a silica/polymer phase and a water phase. The monolith is then reacted in an alkaline solution of cetyltrimethyl ammonium to transform the silica skeleton into MCM-41 under conditions which preserve the original morphology and macroporosity of the material. The combination of spinodal decomposition and pseudomorphic tra…
Rotational State Change of Acetonitrile Vapor on MCM-41 upon Capillary Condensation with the aid of Time-Correlation Function Analysis of IR Spectros…
2000
The infrared spectra of adsorbed acetonitrile on MCM-41 (porewidth = 3.2 nm) were measured at 303 K. In the CN stretching ν2 region, two bands were observed at 2265 cm− 1 and 2254 cm− 1, assigned to hydrogen-bonded molecules on surface hydroxyls of MCM-41, and physisorbed molecules in mesopores, respectively. We designate here the 2265 cm− 1 band as the ν2α band and the 2254 cm− 1 band as the ν2β band. The bandwidth of the fundamental transition ν2fβ, was obtained by removing the overlap with hot band transitions of the same mode, ν2α band, and other modes by least-squares fitting. Before capillary condensation, the relaxation time τ obtained from the bandwidth of the ν2fβ band was smaller …
Incorporation of Pt(II) complex with [amino-2(methylthio)(1,2,4)triazole-(1,5-a)pyrimidine-6-carboxylic-acid] ligand in MCM41 for controlled release
2015
Drug carriers play a critical role for the loading and the release of the drug. A promising frontier is represented by a new class of innovative medicines that represents directional transport vehicles "drug delivery" and consist of assembled structures carrier (nano)-drug. Silica-based materials, nontoxic, biocompatible, have been used as adjuvant and excipient in pharmaceutical technology. In this class of compounds, the mesoporous materials, such as MCM41, SBA-15 and hexagonal mesoporous silica, have been investigated for medication and drug delivery due to their properties. In fact, these materials show a large specific pore volume made up of regular pores having a diameter in the nanom…
Bayesian Analysis of Diagnostic Accuracy for Gastroesophageal Reflux Disease in the absence of gold standard
2007
Spontaneous doping and magnetic properties of polyacetylene and polypropyne synthesized in situ in Ni-exchanged mordenite and mesoporous MCM-41
2001
Upon polymerisation of acetylene and propyne inside the channels of Ni2+-exchanged mordenite and mesoporous MCM-41 spontaneous doping and formation of antiferromagnetic NiO clusters are observed to various extents. The population of polarons present in the final polymer/zeolite composite: (i) is higher for polyacetylene than for polypropyne; (ii) increases with polymerisation temperature in the range 100 to 335 °C; (iii) increases with the C content; and (iv) is higher for mordenite than for MCM-41 under the same conditions. The use of Ni(0),H+-mordenite for polymer formation enhances the polaron population of the resulting polymer by over one order of magnitude. Doped polyacetylene encapsu…
Post-synthesis alumination of MCM-41: Effect of the acidity on the HDS activity of supported Pd catalysts
2010
Abstract Siliceous MCM-41 with different amount of alumina, from 0.25 up to 4.0 wt%, were prepared by impregnation of the MCM-41 with aqueous solution of Al(NO) 3 ·9H 2 O. The modified mesoporous silicas were then used as supports for Pd catalysts prepared by wet-impregnation from PdCl 2 precursor. Supports and corresponding Pd catalysts were characterized by XRD, XPS and NH 3 -TPD. The catalytic behavior was tested in the hydrodesulfurization (HDS) reaction of thiophene. An increase of the hydrodesulfurization activity with increasing alumina amount up to 0.5 wt% was observed. On the basis of the acidity change of the support and the structural modification underwent by the deposited palla…
Nature of cobalt active species in hydrodesulfurization catalysis: combined support and preparation method effects
2007
Abstract Co/γ-Al2O3, Co/SiO2, Co/MCM-41, Co/ASA and Co/S2 (amorphous aluminosilicate with Al/Si = 0.13 and with Al/Si ≈ 2, respectively) were prepared by the method of wet impregnation and by the method of precipitation in the presence of sodium carbonate. The samples were characterised by XPS, XRD and TPR. The catalytic activity was tested in the hydrodesulfurization of thiophene using a continuous flow reactor. Among the wet impregnated catalysts those supported on the amorphous and ordered mesoporous silica exhibited higher HDS activity as compared to the alumina containing supports. Particularly, the use of the mesoporous, high surface area MCM-41 support, determined the best performing…
Decompression induces inflammation but do not modify cell proliferation and apoptosis in odontogenic keratocyst
2022
Background Odontogenic keratocyst (OKC) is a development cyst, of odontogenic origin, that differs from other entities by its infiltrating and aggressive biological behavior. Among conservative treatments for large lesions, surgical decompression stands out, with a variable recurrence rate. Aim: To evaluate the histological effects of decompression treatment on OKC, including cell proliferation and apoptosis of epithelial cyst. Material and Methods 21 OKC cases were included. Samples were taken before and after surgical decompression for histological evaluation and immunohistochemical staining of Ki-67, MCM4/7, Bax and Bcl2. Data were analyzed and compared using Student’s t and Wilcoxon tes…